[Spectrum analysis of blue to purple membrane transition induced by diverse valent cations].

The visible difference spectra, M412 yield and M412 decay lifetime in blue membrane (bM) to purple membrane (pM) transition induced by Na+ , Mg2+ and Tb3+ metal ions were characterized. The transition ability from bM to pM induced by Tb3+ , Mg2+ and Na+ has distinguished difference, their concentration ratio at the midpoint of ion-induced absorbance changes is 1:2.5:650. Meanwhile, the curve of absorbance changes at 540 nm is similar to that of M412 yield changes in bM to pM transition. The M412 decay lifetime of regenerative pM induced by Tb3+ was prolonged remarkably when more Tb3+ was added. However, for the other two ions, additional ions have no effects on its lifetime. These results suggest that diverse valence metal ions exist in different binding ways from pM.

Melittin-regenerated purple membrane.

We have investigated the character of melittin-regenerated purple membrane. Adding melittin to blue membrane causes the color transition and partial regeneration of the photocycle and the proton pump. The reconstitution of bacteriorhodopsin by melittin is proved to be charge-dependent. In studying the location of melittin binding on the blue membrane, we suggest that melittin anchors on the membrane through both hydrophobic and electrostatic interactions. The electrostatic interaction is dominant. The binding sites for the electrostatic interaction should be on the surface of the membrane.

Asymmetric distribution of biotin labeling on the purple membrane.

This work examined the biotin modification of bacteriorhodopsin (BR) in the purple membrane (PM). The results of flash kinetic absorption measurements showed that photocycle was maintained in biotinylated BR. Biotinylated BR also maintained its photoelectric activity, as indicated by the photoelectric response of the bilayer lipid membrane (BLM). Atomic force microscopy (AFM) of stretavidiin-bound biotin revealed that biotin molecules covered both surfaces of the, but the amount of biotinylated BR on the extracellular (EC) surface was markedly higher than on the cytoplasmic (CP) surface. Further studies showed that, after reaction with fluorescamine (FL), biotin labeling occurred only on the CP surface. These results are informative for future work on bioconjugation of BR as well as work on oriented assembly and the design of BR-based photoelectric devices.

Different interactions between the two sides of purple membrane with atomic force microscope tip.

Atomic force microscopy (AFM) is known to be capable of measuring local surface charge density based on the DLVO model. However, it has failed to distinguish charge density difference between the extracellular and cytoplasmic sides of purple membrane (PM) in previous studies. In this paper, tapping-mode AFM with thioglycolate-modified tips was used to image PM in buffers of different salt concentrations. When imaged in 25 mM KCl buffer, the topography of membranes appeared to be of two different types, one flat and the other domelike. Such a difference was not observed in buffers of high salt concentrations. This suggests that the topography variation results from differences in electrostatic interaction between the AFM tip and the different membrane surfaces. With images of papain-digested PM and high-resolution images of membrane surface structure, we proved that the membrane surfaces with flat topography were on the extracellular side while the surfaces with domelike topography were on the cytoplasmic side. Hence, this provides a straightforward method to distinguish the two sides of PM without the requirement of high-resolution imaging. Force-distance curves clearly demonstrated the different tip-sample interactions. The force curves recorded on the extracellular side of PM were consistent with the DLVO model, so its surface charge density can be estimated well. However, the curves recorded on the cytoplasmic side had a much longer decay length, which is supposed to be relevant to the flexibility of the C-terminus of bacteriorhodopsin (bR).

Studies on the temperature effect on bacteriorhodopsin of purple and blue membrane by fluorescence and absorption spectroscopy.

Fluorescence and absorption spectra were used to study the temperature effect on the conformation of bacteriorhodopsin (bR) in the blue and purple membranes (termed as bRb and bRp respectively). The maximum emission wavelengths of tryptophan fluorescence in both proteins at room temperature are 340 nm, and the fluorescence quantum yield of bRb is about 1.4 fold higher than that of bRp. As temperature increases, the tryptophan fluorescence of bRb decreases, while the tryptophan fluorescence of bRp increases. The binding study of extrinsic fluorescent probe bis-ANS indicated that the probe can bind only to bRb, but not to bRp. These results suggest that significant structural difference existed between bRb and bRp. It was also found that both kinds of bR are highly thermal stable. The maximum wavelength of the protein fluorescence emission only shifted from 340 nm to 346 nm at 100 degrees C. More interestingly, as temperature increased, the characteristic absorption peak of bRb at 605 nm decreased and a new absorption peak at 380 nm formed. The transition occurred at a narrow temperature range (65 degrees C-70 degrees C). These facts indicated that an intermediate can be induced by high temperature. This phenomenon has not been reported before.

Structural changes of purple membrane and bacteriorhodopsin during its denaturation induced by high pH.

Bacteriorhodopsin (bR) trimers naturally form two-dimensional hexagonal crystals in purple membrane (PM), which make it very stable. However, the dnaturation of bR was found to occur during a very narrow pH range when the pH was increased above 12.0, as indicated by inactivation of the photochemical cycle observed by flash photolysis kinetic spectra. Here, atomic force microscopy was used to study the surface structural changes of PM during the denaturation process induced by high pH. Together with the absorption and fluorescence spectra, it was found that the structural changes could be divided into three steps. First, some hydrophobic amino acids of bR become exposed to the aqueous environment and PM loses its 2D crystalline structure, transforming into the so-called "nonisland" structure. Second, bR molecules are extracted out of membrane and form protrusions on the surface like islands in the sea; therefore, the "nonisland" structure transforms into the "island" structure. Finally, most bRs break off from the membrane and form large depositions.

All-trans to 13-cis retinal isomerization in light-adapted bacteriorhodopsin at acidic pH.

The flash photolysis kinetic spectra of the intermediate M(412) of bacteriorhodopsin were monitored during the process of acid titration. In the light-adapted state, the maximum peak amplitude of M(412) absorbance of bacteriorhodopsin decreased (pK(a)=3.40+/-0.05) as the pH decreased from 7.3 to 1.9. In the dark-adapted state, the maximum peak amplitude of M(412) absorbance of bacteriorhodopsin increased as the pH decreased from 6.9 to 4.1, and then decreased (pK(a)=2.85+/-0.05) as the pH dropped to 2.1. These different trends in the change in the maximum peak amplitude suggested that not only the transition of purple membrane to blue membrane had taken place in both light and dark-adapted states, but also the fraction of all-trans-bR had changed during the acid titration. The pH-dependent absorption changes at 640 nm of bacteriorhodopsin in both light- and dark-adapted states were also observed. The pK(a)-values of the purple-to-blue transition were 3.80+/-0.05 in light-adapted state and 3.40+/-0.05 in dark-adapted state, respectively. According to Balashov's method, the fraction of all-trans-bR was assayed as the pH decreased. All these results indicated that the purple-to-blue transition of light-adapted bacteriorhodopsin was accompanied by an all-trans to 13-cis retinal isomerization at acidic pH.

Characteristics and the Mechanism of Bacteriorhodopsin Photoelectric Response.

Oriented bacteriorhodopsin films were prepared on ITO conductive glass by using electrophoretic or Langmuir-Blodgett methods to construct photocells. Pulse response photovoltages under stimulation of pulsed laser and differentialresponse signals under irradiation of discontinued light were respectively measured, and the origins of the two responses and their correlation are analyzed. The pulse response photovoltage initiated from the ultrafast charge separation of the retinal and the proton translocation, followed by the deprotonation and reprotonation of the Schiff base and its surrounding amino acids. This was a quick response and was the preceding reaction of the differential response. The differential response was caused by the charging and discharging of the continuous proton current of the BR light-driven proton pump at the light-on and light-off, as well as the coupling mode of the measuring circuit, which was a slow process.