Digital evaluation of Bolton's tooth size discrepancies among different malocclusions categories of Egyptian adolescent orthodontic population: A retrospective study.

OBJECTIVE: This retrospective investigation aimed to compare Bolton's ratios among different malocclusion groups of Egyptian adolescent orthodontic patients with original Bolton's standards. MATERIALS AND METHODS: Pre-treatment dental casts of 588 Egyptian subjects, 290 males and 298 females with mean age 16.7±2.2 years, were randomly selected and classified into 220 class I (108 males and 112 females), 230 class II (112 males and 118 females), and 138 class III (68 males and 70 females) groups. Mesiodistal widths from first molar to first molar were measured on 3-dimensionally scanned models via software and ratios were calculated. Two-way analysis of variance compared ratios as a function of skeletal classification and gender. Additionally, percentages of significant discrepancy outside 2 standard deviations (SDs) were calculated. RESULTS: The anterior mean ratio for the total sample were higher (79.4±4.7) and overall mean ratio was lower (90.1±5) than Bolton's standards. The differences between the obtained and standard values were statistically significant (P<0.001). However, there were no significant differences in either anterior ratio (P=0.637) or overall ratio (P=295) regarding gender. Class I cases showed the highest mean anterior ratio of 80±5.7 whereas class II and class III cases had the lowest ratio of 78.5±4.6 and 78.7±3.5, respectively. Concerning overall ratio, class III subjects had the highest ratio of 91.8±2.6 with no substantial distinction from class II cases (90.2±4.7) but was significantly different from class I cases that demonstrated the lowest ratio (89.7±5, P=0.020). High percentages of patients displayed clinically significant tooth size discrepancies (TSD), exceeding either above or below 2SD of Bolton's values, which were more marked in the anterior ratio. These were 25.2% and 7.4% for anterior ratio and 3.4% and 15.4% for overall ratio. CONCLUSIONS: Tooth size ratios of Egyptian orthodontic patients are generally different than the original Bolton's standards. Patients with class I and class III malocclusions had greater anterior and overall ratios than those with class II malocclusions with no considerable gender differences in either ratio.

Three-Dimensional Assessment of Mandibular Condylar Volume and Position Subsequent to Twin Block Functional Therapy of Skeletal Class II Malocclusion Accompanied by Low-Level Laser Therapy.

This study aimed to evaluate and compare the effect of low-level laser therapy (LLLT) on mandibular condylar volume and position following treatment of a Class II malocclusion with a twin block (TB) appliance employing cone beam computed tomography (CBCT). Twenty-four growing patients, aged 9-12 years, were randomly allocated into control and laser groups. All patients were treated with a TB appliance. The patients in the laser group were treated weekly with a gallium-aluminum-arsenide (GaAlAs) diode laser around the temporomandibular joint (TMJ) region for three months. CBCT images were obtained before and after TB therapy and the changes in TMJ and skeletal variables were evaluated and compared among and between the groups. In the laser group, the condylar volume of the right and left sides significantly increased by 213.3 mm3 and 231.2 mm3, respectively (p < 0.05), whereas in the control group it significantly increased by 225.2 mm3, and 244.2 mm3, respectively (p < 0.05), with forward and lateral positioning of both sides. Furthermore, effective mandibular, ramus, and corpus lengths were increased, which were not significant between the groups. Low-Level Laser therapy accomplished no considerable effect on mandibular condylar volume and position following the functional orthopedic treatment of skeletal Class II malocclusions using a TB appliance.

Outcome of photodynamic therapy on orthodontic leveling and alignment of mandibular anterior segment: A controlled clinical trial.

BACKGROUND: Photodynamic therapy (PDT) is a non-invasive approach that has drawn attention to accelerate orthodontic tooth movement (OTM). However, no studies have been published that evaluates the outcome of PDT on orthodontic leveling and alignment. Therefore, the present study aimed to evaluate outcome of PDT on orthodontic leveling and alignment of mandibular anterior segment. MATERIALS AND METHODS: Thirty patients (18 females and 12 males) were included who had moderate mandibular crowding with average age was 19.23 ± 3.1 years. They were randomly divided into a control group without PDT intervention and a laser group. All patients followed non-extraction approach using one category of fixed appliance and matching NiTi archwire sequence for 3 months. In PDT group, methylene blue mediated gallium aluminum arsenide laser was applied with 635 nm, 6.5 J/cm2, for 10 s at 10 points (0.2 J/point) started immediately after first wire then at days 3,7,14 of first month and repeated for additional 2 months. Relief of crowding was assessed by Little`s irregularity index (LII) scores after 4, 8, and 12 weeks through scanned 3-dimensional models via a software. RESULTS: Both groups showed improvements in mandibular crowding as evidenced by significant decreases (p ≤ 0.001) in LII scores during all observation intervals with no significant differences (p > 0.05). Moreover, the alignment`s rate showed no significant differences between groups. CONCLUSION: PDT produced a negligible effect concerning alignment of crowded mandibular anterior teeth. Besides, OTM's rate at different observation intervals showed an equivalent pattern either with or without PDT.

Three-dimensional assessment of transverse dentoskeletal mandibular dimensions after utilizing two designs of fixed mandibular expansion appliance: A prospective clinical investigation.

The aim of this clinical study was to evaluate and compare the dentoskeletal transverse mandibular arch dimensions following the use of two designs of fixed mandibular expanders using cone beam computed tomography (CBCT). Twenty orthodontic patients, 12 females and 8 males, with mean age of 13.4 ± 0.5 years were selected and randomly divided into two equivalent groups; group A consisted of 10 patients (4 boys, 6 girls) who were treated with modified Williams expander and group B consisted of 10 patients (4 boys, 6 girls) who were treated with a two-arm fixed expander. Consistent expansion instructions were given to all patients according to a standardized slow protocol of one quarter turn twice/week for both expanders. Routine orthodontic records as well as mandibular CBCTs were obtained before (T1) and immediately after expansion (T2) to estimate changes in dentoskeletal mandibular transverse dimensions. The data was statistically analyzed and the significance level was set at p ≤ 0.05. Mandibular intercanine, inter-premolar, intermolar widths; and arch perimeter were significantly increased (p ≤ 0.05) following expansion with both fixed expanders. However, the changes in inter-premolar width, intercanine width, and arch perimeter were significantly augmented in two-arm fixed expander group than modified Williams's group. In contrast, their effects on the skeletal mandibular body width were non-significant (p > 0.05). Both expanders yielded significant and equivalent dentoalveolar effects that were more evident with two-arm fixed expander than the William one. Both fixed designs enhanced mandibular transverse dental dimensions; however, they were unsuccessful to create any considerable skeletal effects.

The impact of chlorhexidine mouth rinse on the bond strength of polycarbonate orthodontic brackets.

OBJECTIVE: The purpose of the current in-vivo study was to assess the effect of using 0.12% chlorhexidine (CHX) mouth rinse, before bonding, on shear bond strength of polycarbonate brackets bonded with composite adhesive. SUBJECTS AND METHODS: Eighteen orthodontic patients with a mean age 21.41 ± 1.2 years, who were scheduled to have 2 or more first premolars extracted, were included in this study. Patients were referred for an oral prophylaxis program which included, in part, the use of a mouth rinse. Patients were divided into 2 groups, a test group of 9 patients who used 0.12% CHX gluconate mouth rinse twice daily and a control group of 9 patients who used a mouth rinse without CHX, but with same color. After 1 week, polycarbonate brackets were bonded to first premolars with Transbond XT composite adhesive. Premolars were extracted after 28 days and tested for shear bond strength on a universal testing machine. Student's t-test was used to compare shear bond strengths of both groups. RESULTS: No statistically significant difference was found in bond strengths' values between both groups. The test group (with CHX) has mean shear bond strength of 14.21 ± 2.42 MPa whereas the control group (without CHX) revealed a mean strength of 14.52 ± 2.31 MPa. CONCLUSION: The use of 0.12% CHX mouth rinse, for one week before bonding, did not affect the shear bond strength of polycarbonate brackets bonded with Transbond composite. Furthermore, these brackets showed clinically acceptable bond strength.