ABSTRACT
A new large-area gas flow multi-wire proportional counter has been developed to replace the large-area counting system that is currently in use at the National Institute of Standards and Technology (NIST) and several Department of Defense counting facilities for calibrating large-area alpha and beta sources. The current systems are over 20 years old and part replacement is very difficult. The new systems have been built using specifications that will improve on the current systems and allow collecting data at pressures up to 0.2MPa. The ability to operate at higher pressures will increase the beta efficiency of the counter and lead to improved precision in the final measured results. Comparison of the results from the old and new systems is presented for both alpha and beta sources.
ABSTRACT
As part of an international 222Rn measurement intercomparison conducted at Bermuda in October 1991, NIST provided standardized sample additions of known, but undisclosed ("blind") 222Rn concentrations that could be related to U.S. national standards. The standardized sample additions were obtained with a calibrated 226Ra source and a specially-designed manifold used to obtain well-known dilution factors from simultaneous flow-rate measurements. The additions were introduced over sampling periods of several hours (typically 4 h) into a common streamline on a sampling tower used by the participating laboratories for their measurements. The standardized 222Rn activity concentrations for the intercomparison ranged from approximately 2.5 Bq · m-3 to 35 Bq · m-3 (of which the lower end of this range approached concentration levels for ambient Bermudian air) and had overall uncertainties, approximating a 3 standard deviation uncertainty interval, of about 6 % to 13 %. This paper describes the calibration and methodology for the standardized sample additions.
ABSTRACT
As part of an international measurement intercomparison of instruments used to measure atmospheric 222Rn, four participating laboratories made nearly simultaneous measurements of 222Rn activity concentration in commonly sampled, ambient air over approximately a 2 week period, and three of these four laboratories participated in the measurement comparison of 14 introduced samples with known, but undisclosed ("blind") 222Rn activity concentration. The exercise was conducted in Bermuda in October 1991. The 222Rn activity concentrations in ambient Bermudian air over the course of the intercomparison ranged from a few hundredths of a Bq · m-3 to about 2 Bq · m-3, while the standardized sample additions covered a range from approximately 2.5 Bq · m-3 to 35 Bq · m-3. The overall uncertainty in the latter concentrations was in the general range of 10 %, approximating a 3 standard deviation uncertainty interval. The results of the intercomparison indicated that two of the laboratories were within very good agreement with the standard additions, and almost within expected statistical variations. These same two laboratories, however, at lower ambient concentrations, exhibited a systematic difference with an averaged offset of roughly 0.3 Bq · m-3. The third laboratory participating in the measurement of standardized sample additions was systematically low by about 65 % to 70 %, with respect to the standard addition which was also confirmed in their ambient air concentration measurements. The fourth laboratory, participating in only the ambient measurement part of the intercomparison, was also systematically low by at least 40 % with respect to the first two laboratories.
ABSTRACT
Carrier-free 209Po solution standards have been prepared and calibrated. The standards, which will be disseminated by the National Institute of Standards and Technology as Standard Reference Material SRM 4326, consist of (5.1597 ±0.0024) g of a solution of polonium in nominal 2 mol · L-1 hydrochloric acid (having a solution density of (1.031±0.004) g · mL-1 at 22 °C) that is contained in 5 mL flame-sealed borosilicate glass ampoules, and are certified to contain a 209Po alpha-particle emission rate concentration of (85.42±0.29) s-1 · g-1 (corresponding to a 209Po activity concentration of (85.83 ±0.30) Bq · g-1) as of the reference time of 1200 EST 15 March 1994. The calibration was based on 4πα liquid scintillation (LS) measurements with two different LS counting systems and under wide variations in measurement and sample conditions. Confirmatory measurements by 2πα gas-flow proportional counting were also performed. The only known radionuclidic impurity, based on α- and photon-emission spectrometry, is a trace quantity of 208Po. The 208Po to 209Po impurity ratio as of the reference time was 0.00124 ±0.00020. All of the above cited uncertainty intervals correspond to a combined standard uncertainty multiplied by a coverage factor of k = 2. Although 209Po is nearly a pure α emitter with only a weak electron capture branch to 209Bi, LS measurements of the 209Po a decay are confounded by an a transition to a 2.3 keV ( Jπ= 1/2-) level in 205Pb which was previously unknown to be a delayed isomeric state.
ABSTRACT
The recently developed 222Rn emanation standards that are based on polyethylene-encapsulated 226Ra solutions were employed for a first field-measurement application test to demonstrate their efficacy in calibrating passive integral radon monitors. The performance of the capsules was evaluated with respect to the calibration needs of electret ionization chambers (E-PERM®, Rad Elec Inc.). The encapsulated standards emanate well-characterized and known quantities of 222Rn, and were used in two different-sized, relatively-small, accumulation vessels (about 3.6 L and 10 L) which also contained the deployed electret monitors under test. Calculated integral 222Rn activities from the capsules over various accumulation times were compared to the averaged electret responses. Evaluations were made with four encapsulated standards ranging in 226Ra activity from approximately 15 Bq to 540 Bq (with 222Rn emanation fractions of 0.888); over accumulation times from 1 d to 33 d; and with four different types of E-PERM detectors that were independently calibrated. The ratio of the electret chamber response ERn to the integral 222Rn activity IRn was constant (within statistical variations) over the variables of the specific capsule used, the accumulation volume, accumulation time, and detector type. The results clearly demonstrated the practicality and suitability of the encapsulated standards for providing a simple and readily-available calibration for those measurement applications. However, the mean ratio ERn/IRn was approximately 0.91, suggesting a possible systematic bias in the extant E-PERM calibrations. This 9 % systematic difference was verified by an independent test of the E-PERM calibration based on measurements with the NIST radon-in-water standard generator.
ABSTRACT
This paper describes the construction and calibration of the NIST large area x-ray counting system. 238Pu sources 8 in (20.32 cm) by 5 in (12.70 cm) thick, emitting L x rays in the range of 12-20 keV are calibrated for total emission rate and also for rate through a centrally located 3 in (7.63 cm) diameter aperture. Alpha particle emission rates are obtained using the known x-ray to alpha particle abundances. The sources will be used to calibrate alpha-particle surface monitors.
ABSTRACT
Within the United States, the national standard for radon measurements is embodied in a primary radon measurement system that has been maintained for over 50 years to accurately measure radon (222Rn) against international and national radium (226Ra) standards. In turn, all of the radon measurements made at the National Institute of Standards and Technology (NIST) and the radon transfer calibration standards and calibration services provided by NIST are directly related to this national radon standard. This primary radon measurement system consists of pulse ionization chambers and ancillary gas handling and gas purification equipment. The system is currently undergoing a significant upgrading and expansion which will replace the extant outdated system.