Comparative study of physicochemical, nutritional, phytochemical, and sensory properties of bread with plantain and soy flours partly replacing wheat flour.

Plantain flour (PLF) and soy flour (SF) were used to substitute wheat flour (10% and 20% w/w) in composite bread. Physicochemical, phytochemical, and sensory properties were investigated. Partial substitution by PLF significantly increased (p < .05) starch, amylose, ascorbic acid, and potassium content in bread samples. In contrast, a significant improvement (p < .05) in protein, fat, amylopectin, and calcium content was observed with SF substitution. Composite bread with PLF and SF together lowered the hydrolysis index (HI) and glycemic index (GI) as compared with whole wheat flour. The molar phytate to minerals (iron, zinc, and calcium) ratio in all composite loaves was lower than reported critical values, except for phytate to iron. Significant differences (p < .05) were found in color, specific volume, and texture characteristics of loaves made from partial substitution with PLF and SF. Sensory evaluation revealed that bread with 10% PLF exhibited better scores for appearance and willingness to pay than the control. In contrast, SF negatively affected (p < .05) the appearance, texture, color, overall acceptance, and willingness to pay. The trade-off analysis indicated that PLF can be utilized to produce bread that meets consumers' demands, while incorporating SF as an alternative high-nutrient density bread will be beneficial to health.

The Feasibility of Using Pulsed-Vacuum in Stimulating Calcium-Alginate Hydrogel Balls.

The effect of the pulsed-vacuum stimulation (PVS) on the external gelation process of calcium-alginate (Ca-Alg) hydrogel balls was studied. The process was conducted at four different working pressures (8, 35, 61, and 101 kPa) for three pulsed-vacuum cycles (one cycle consisted of three repetitions of 10 min of depressurization and 10 min of vacuum liberation). The diffusion coefficients (D) of calcium cations (Ca2+) gradually reduced over time and were significantly pronounced (p < 0.05) at the first three hours of the external gelation process. The rate of weight reduction (WR) and rate of volume shrinkage (Sv) varied directly according to the D value of Ca2+. A significant linear relationship between WR and Sv was observed for all working pressures (R2 > 0.91). An application of a pulsed vacuum at 8 kPa led to the highest weight reduction and shrinkage of Ca-Alg hydrogel samples compared to other working pressures, while 61 kPa seemed to be the best condition. Although all textural characteristics (hardness, breaking deformation, Young's modulus, and rupture strength) did not directly variate by the level of working pressures, they were likely correlated with the levels of WR and Sv. Scanning electron micrographs (SEM) supported that the working pressure affected the characteristics of Ca-Alg hydrogel structure. Samples stimulated at a working pressure of 8 kPa showed higher deformation with heterogenous structure, large cavities, and looser layer when compared with those at 61 kPa. These results indicate the PVS is a promising technology that can be effectively applied in the external gelation process of Ca-Alg gel.

How Does Cultivar, Maturation, and Pre-Treatment Affect Nutritional, Physicochemical, and Pasting Properties of Plantain Flours?

The effect of cultivar, ripening stage, and pre-treatment method were investigated on the nutritional, physicochemical, and pasting properties of plantain flours from two plantains and two plantain hybrids. There were significant variations (p < 0.05) in chemical composition and physical properties influenced by the interaction of cultivars, ripening stages, and pre-treatment methods. The highest levels of amylose, water-holding capacity (WHC), and oil-holding capacity (OHC) were observed in unripe flours and acid-treated flour recorded the highest content of resistant starch (RS). Flour after pre-blanching contained the highest level of total phenolic (TP), carotenoid contents, and browning index (BI) value. In contrast, acid-treated flours had the lowest BI value. As ripening progressed, peak viscosity and breakdown values increased but final viscosity, setback, and pasting temperature values were reduced. Untreated flour samples showed the highest peak viscosity. Higher breakdown values were found in acid-treated samples and higher setback values in pre-blanched samples.

Consumer Preferences and Socioeconomic Factors Decided on Plantain and Plantain-Based Products in the Central Region of Cameroon and Oyo State, Nigeria.

Plantain is a key staple food in Central and West Africa, but there is limited understanding of its market in Africa. In addition, the cooking methods for enhancing the nutritional value, consumer preference, and willingness to pay for plantain and plantain-based products are not well understood. The knowledge gaps in the market and consumer dimension of the food chain need to be known to increase plantain utilization and guide breeding efforts. This research contributes by examining the cooking methods, consumer preference, and willingness to pay for plantain and plantain-based products in Cameroon and Nigeria. A household survey sample of 454 Cameroonian consumers in four divisions of Central Region and 418 Nigerian consumers in seven government areas of Oyo State in southwest Nigeria was the basis for the analysis. The results showed some levels of similarity and difference in the consumption and cooking of boiled, roasted, and fried plantain in both countries. The trend in consumption of all plantain-based products was constant in Cameroon but increased in Nigeria. The most important factor influencing Cameroonian consumers' choice of plantain and its products was taste, while the nutrition trait influenced Nigerian consumers. Both Cameroonian and Nigerian consumers considered packaging, location of produce, and size and quantity as the least important factors. In addition, socioeconomic characteristics were significant determinants of consumers' choices to consume plantain and its products. Gender significantly influenced (p < 0.05) taste, while nutrition was significantly driven (p < 0.05) by education and annual income. Household size played a significant role (p < 0.05) in consumers' choices when the price was considered. These findings serve as a guideline to improve existing products to match the needs of consumers in each country and develop products for different consumer segments and potentially increase production.

Utilization of mixed adsorbents to extend frying oil life cycle in poultry processing.

The effects were studied of two different adsorbent combinations (com I; bentonite: activated carbon: celite = 3:4:1 and com II; bentonite: activated clay: celite = 3:4:1 + 1% citric acid) on the physico-chemical changes of oil used continuously for deep-fat frying of chicken drumsticks. The results showed that the % FFA was reduced by 44.3, PV by 50.2, and FOS reading by 40.1% in com I whereas reductions of 41.6, 44.9, and 32.8%, respectively, were found in com II. The oil treated with com II exhibited a lighter color than with com I. The changes of oil color in com I were L∗ 30.7, a∗ 1.7, and b∗ 31.9%; in com II they were 53.2, 19.1, and 39.5% respectively. The higher the L∗ observed, the better the oil quality obtained because of the bleaching ability of adsorbents. Therefore, the use of such adsorbents is recommended for poultry processing.