Miltefosine-cholesterol interactions: a monolayer study.

Mixed Langmuir monolayers of miltefosine (hexadecylphosphocholine) and cholesterol have been investigated by recording surface pressure-area (pi-A) isotherms at different subphase pHs (2, 6, and 10) and temperatures (10, 20, 25, and 30 degrees C). The change of both pH and temperature within the investigated range does not modify significantly the behavior of mixed films. The most pronounced effect involves condensation of the miltefosine monolayer by cholesterol, which diminishes in the following order: pH 6 > pH 2 > pH 10. The analyses of pi-A and compressibility modulus dependencies indicate the existence of interactions in the investigated system; at pH 2 and 6, the strongest were found to occur for the mixed film of miltefosine molar fraction (XM) between 0.6 and 0.7 (mean value, 0.66). Such a composition corresponds to the stable complex formation wherein 2 miltefosine molecules and 1 molecule of cholesterol are strongly bound together, mainly by attractive hydrophobic forces between their apolar tails. However, at pH 10 the highest stability occurs for mixtures containing a smaller proportion of miltefosine (XM = 0.5), which means that on alkaline subphases the ability to condense the miltefosine monolayer by cholesterol is less efficient as it requires a higher proportion of cholesterol (1:1 as compared to 1:2 at pH 2 and 6) to attain the maximum stability of the mixed film. The attractive forces between miltefosine and cholesterol are also weaker at pH 10 due to a greater solvatation of the miltefosine polar group. A similar trend is observed on increasing subphase temperature, when monolayers are more expanded.

Orientational changes in dipalmitoyl phosphatidyl glycerol Langmuir monolayers.

Dipalmitoyl phosphatidyl glycerol (DPPG) as Langmuir monolayers at the air/water interface was investigated by means of surface pressure measurements in addition to Brewster angle microscopy (BAM) during film compression/expansion. A characteristic phase transition region appeared in the course of surface pressure-area (pi-A) isotherms for monolayers spread on alkaline water or buffer subphase, while on neutral or acidic water the plateau region was absent. This phase transition region was attributed to the ionization of DPPG monolayer. It has been postulated that the ionization of the phosphatidyl glycerol group leads to its increased solvation, which probably provokes both a change in the orientation of the polar group and its deeper penetration into bulk phase. Film compression along the transition region provokes the dehydration of polar groups and subsequent change of their conformation, thus causing the DPPG molecules to emerge up to the interface. Quantitative Brewster angle microscopy (BAM) measurements revealed that along the liquid-expanded to liquid-condensed phase transition the thickness of the ionized DPPG monolayer increases by 4.2 A as a result of the conformational changes of the ionized polar groups, which tend to emerge from the bulk subphase up to the surface.

Molecular organisation of amphotericin B at the air-water interface in the presence of sterols: a monolayer study.

Using the monolayer technique to study the surface behaviour of systems consisting of amphotericin B (AmB) and various sterols, the components were found to interact with each other. The interactions observed are accounted for by postulating that, at low surface pressures, AmB and different sterols form mixed films where the former lies parallel and the latter normal to the air-water interface in such a way that the polar groups in both components establish hydrogen bonds that lead to the formation of an AmB-sterol 'complex' of 2:1 stoichiometry at the interface. At high surface pressures, AmB molecules rearrange themselves normal to the interface; this gives rise to the Van der Waals interactions between non-polar chains of both components that vary with the nature and composition of the system. The occurrence of these hydrophobic interactions prevents the desorption of AmB into the subphase, which is consistent with the positive excess areas of mixing obtained under these surface pressure conditions. Among the four sterols studied, ergosterol exhibits the strongest interaction with AmB and beta-sitosterol the weakest. Cholesterol and stigmasterol show intermediate behaviour.

Study of pi-A Curves for Mixed Monolayers of Cyclosporin and Poly(dl-Lactic Acid-co-Glycolic Acid) Spread at the Air/Water Interface

Mixed monolayers of CyA and poly(dl-lactic acid-co-glycolic acid) spread at the air/water interface were studied by measuring surface pressure (pi) as a function of the area per residue (A). The pi-A curves suggest that the components are miscible below surface pressures of 10 mN/m. Also, the diagrams obtained by plotting the mean area per residue as a function of molar fraction show positive deviations from ideal, which indicate the existence of interactions between both components in the mixed films. The nature of these interactions was influenced by the pH and temperature of the subphase; however, it was not dependent on the molecular size of the polymer. Above pi = 10 mN/m mixed monolayers showed immiscible behavior with no interactions between their components. This was manifested by the obedience to the mean area additivity rule and the same value of collapse pressure present for all mixed monolayers studied.

Surface pressure-area isotherms of mixed cyclosporin-poly(isobutylcyanoacrylate) monolayers spread at the air/water interface.

The pi-A isotherms of mixed monolayers of cyclosporin and poly(isobutylcyanoacrylate) (PIBCA) show that the molecular areas of cyclosporin and PIBCA are additive regardless of the pH of the substrate or the physical state of the monolayers. All these mixed films collapse at the same surface pressure; therefore, application of the two-dimensional phase rule implies that cyclosporin and PIBCA are immiscible at the interface. This conclusion may have important implications with regard to the formulation of PIBCA-cyclosporin nanoparticles for cyclosporin administration, though further research in this direction will require consideration of the role played by the coadjuvants used for PIBCA polymerization during nanoparticle formation.