Tailoring Photoprotection of Polylactide with New Isobornyl Derivatives of Phenol and Aniline.

This article is devoted to the development of new photostabilizers for polylactide (PLA), a polymer that is an environmentally friendly alternative to polymers and is based on fossil raw materials. We have elucidated the role of the reaction center of two potential PLA photoprotectors: N-isobornylaniline and 2-isobornylphenol, in reactions occurring in a polymer matrix under the action of UV-C radiation. PLA samples with the photostabilizers were irradiated under a wavelength of 253.7 nm for 4, 8 and 12 h. The effectiveness of the photostabilizers was evaluated based on FTIR spectrometric data, 1H and 13C NMR, scanning electron microscopy and simultaneous thermal analysis (TG-DSC). Both stabilizers led to the protection of ester bonds between monomer units of PLA. However, 2-isobornylphenol proved to be more effective at a concentration of 0.05 wt.%, while the optimal concentration of N-isobornylaniline was 0.5 wt.% by weight. TG-DSC showed that the addition of N-isobornylaniline led to an increase in PLA resistance to thermal decomposition; the temperature of the onset of weight loss increased by 2.8 °C at 0.05 wt.% and by 8.1 °C at 0.5 wt.% of N-isobornylaniline. The photoprotector 2-isobornylphenol, on the contrary, reduced the thermal stability of PLA.

Structural, Optical, Luminescence, and Electrical Properties of Eu/Li- and Eu/Na-Codoped Magnesium Bismuth Niobate Pyrochlores.

Eu-doped bismuth-based Bi1.5M0.4Mg0.5Nb1.5O7-δ (M = Li and Na) pyrochlores were synthesized by the organic-inorganic precursor combustion technique. The study examined the effect of rare earth element Eu3+ doping on the structural, dielectric, optical, and luminescence properties of synthesized materials. The analysis showed that the substitution of Bi3+ cations with Eu3+ leads to dielectric permittivity decreasing due to the structural distortion for the Eu-concentrated compositions and low polarizability of Eu3+. The band gap values predicted by electronic band structure calculation using DFT-HSE03 are in line with the experimental ones and tended to increase with the decrease in the unit cell parameters with Eu concentration changing. By the optical and luminescence measurements, the specific roles of Li- and Na-containing host types, additional phases, and dopant concentration in bismuth niobate pyrochlores are shown concerning the dielectric, structural, and Eu3+ emission properties. All Eu-doped bismuth-based pyrochlore ceramics behave as high-frequency dielectrics up to 200 °C and have mixed conductivity (electronic, proton, and oxygen) at T > 200 °C. The obtained dielectric parameters make them suitable for high-frequency ceramic capacitors.

Water stable colloidal lignin-PVP particles prepared by electrospray.

In this study, electrospray deposition has been used as a method to prepare lignin submicron spherical particles. Regularities of electrospraying of lignin solutions in DMSO were revealed. The influence of voltage, distance between electrodes, feed rate, temperature and concentration of lignin solution on the morphology, size and polydispersity of the obtained particles was determined. SEM, IR, TG-DSC, elemental analysis, dynamic light scattering, Zeta potential and nitrogen sorption were used to characterize the particles and to determine their properties. The aqueous colloidal solutions of the submicron particles of lignins from various plant sources were stabilized by preparing the lignin/polyvinylpyrrolidone polymeric complexes.

The epidemiology of amyotrophic lateral sclerosis in Moscow (Russia).

Objectives: To estimate the incidence of amyotrophic lateral sclerosis (ALS) in Moscow by investigating multiple sources of cases. Incidence rates from previous Russian studies ranged from 0.3 to 0.7 per 100,000/year. Methods: A retrospective study of the incidence of ALS was performed in the South district of Moscow (population, 1,760,000, 2015). Several data sources were investigated. The medical records of the calendar year 2015 were examined by an ALS expert who accepted only patients with definite or probable ALS according to the revised El Escorial criteria. Crude and standardized incidence rates were calculated, the latter adjusted to the Russian and the European population. Results: Twenty-two patients were found, accounting for a crude incidence of 1.25/100,000/year (95% CI 0.78-1.89) and a standardized incidence of 1.22 (Russia) and 1.28 (Europe). The sample included 11 men and 11 women aged 36-73 years (mean 56). Five patients (23%) had bulbar onset ALS. The mean diagnostic delay was 12.8 ± 9.2 months (8.5 ± 4.8 in men and 17.2 ± 10.6 in women) (p = 0.02). Family history of ALS was present in two cases. Conclusion: The incidence of ALS in the Russian Federation is higher than previously reported but lower than in other countries. Poor diagnostic ascertainment, particularly in women, and the shorter life expectancy of the Russian population are possible explanations.

Encapsulated drug system based on the gels obtained from callus cultures modified pectins.

The aims of this research were to obtain modified pectins of callus cultures using various culture conditions, to evaluate the relationship between the chemical characteristics of pectins, the swelling behavior and the release of prednisolone from calcium pectinate gel (CaPG) beads. An increase of the calcium concentration in the culture media correlated significantly with the rhamnogalacturonan I (RG-I) branching of the pectin. The beads from the pectin with a higher RG-I branching had the lower prednisolone release in a gastric fluid. The beads produced from the pectins obtained from callus cultured with a higher calcium concentration showed the lower prednisolone release. The swelling of the CaPG beads from pectin with a lower molecular weight (Mw) or linearity occurred to a lower degree. All beads prepared from modified pectins showed a high stability and a slow liberation of prednisolone in the simulated gastric and intestinal fluids, whereas rapid drug release in a colonic fluid. An applied strategy involving modification of the pectic structure using the abiotic factors allows obtaining the pectic gels with modified functional properties, in particular, with enhanced gastric and small intestinal resistance and a low drug release. These CaPG beads can be applied as the carriers for colon delivery of the drugs.

Synthesis of a Bulk Ti4SiC3 MAX Phase by Reduction of TiO2 with SiC.

The bulk MAX phase Ti4SiC3 was first synthesized with a yield of 86% by a long-time thermal treatment of TiO2 and SiC powder mixture with a molar ratio of 2:3 at 1600 °C under vacuum conditions. It was found that the appearance of Ti4SiC3 was preceded by the formation of TiC and Ti3SiC2 as a result of the following reactions: (1) combined carbothermic and silicothermic reduction of TiO2 to TiC accompanied by evolution of SiO and CO gases; (2) silicidation of TiC with gaseous SiO, leading to the growth of Ti3SiC2. It was suggested that, apart from TiC and Ti3SiC2 solids, sublimed gaseous species such as Ti, Si, Si2C, SiC2, etc., could take part in the Ti4SiC3 formation that occurred in the next stage. The crystal structure of synthesized Ti4SiC3 was refined by X-ray diffraction Rietveld analysis and confirmed by high-resolution scanning transmission electron microscopy. The measured structural characteristics of bulk Ti4SiC3 are in good agreement with those predicted by ab initio calculations reported in the literature.