Physical and histopathological assessment of the effects of metallic stents on radiation therapy.

To evaluate whether simultaneous metallic stent (MS) placement and radiotherapy are feasible, phantom and animal experiments were performed. The interface dose by external irradiation (EI) or intracavity irradiation (II) to 5 kinds of MS was measured using the charge-coupled device (CCD) camera with a thermoluminescent (TL) sheet, and backscatter and absorption were evaluated using composite method. Lineac 10 MV X-ray irradiated the MS in close contact with the TL sheet. II was performed using (192)Ir, and the irradiation dose transmitted through the MS was measured using the TL sheet. The ratio of the CCD value of the MS wire region to that of the MS non-wire region was defined as the dose perturbation factor (DPF). Furthermore, the effects of a combination of (60)Co gamma-ray EI and MS placement in the normal common bile duct were histopathologically evaluated in dogs. In the phantom experiments of EI, in backscatter by the MS, the DPF was 1.09 for CZ, and 1.03 for Pal, but no backscatter was detected in the remaining 3 MS. In absorption by the MS, the DPF was 0.92, 0.97, 0.97, and 0.98 for CZ, Wall, Pal, and Vel, respectively, but no absorption was detected in U. Flex. In those of II, the DPF of absorption was 0.91, 0.98, and 0.98 for CZ, U. Flex, and Wall, respectively, but no absorption was detected in Pal and Vel. The animal experiments showed infiltration of inflammatory cells and fibrosis in the case of both MS placement and EI. These changes were marked in EI treating after MS placement, but neither severe ulcer nor perforation was found. In conclusion, these results suggested that the effect of MS should be considered carefully when simultaneous MS placement and EI is performed clinically.

Two-dimensional dosimetry in the near field of the model 200 103Pd source for interstitial brachytherapy implants using a thermoluminescent sheet.

A large area and highly sensitive thermoluminescent (TL) sheet film was used for two-dimensional dose distribution measurements at millimetre distances from a 103Pd interstitial brachytherapy source. The TL film is made of Teflon homogeneously mixed with small particles of thermoluminescent material (BaSO4: Eu doped). This TL sheet (5 cm x 5 cm) was used to determine the relative dosimetric characteristics (i.e., radial dose function, 2D and 1D anisotropy functions, as defined by the updated AAPM Task Group No 43 report) of the model 200 103Pd source that emits low energy photons (21 keV). The two-dimensional dosimetry data were obtained for distances from the source surface to 15 mm. The radial dose function measured with the TL sheet is in reasonable agreement within 11% with the values recommended in the updated AAPM TG-43 report. All the measured 2D dose distributions showed limited symmetry about the source axes. The differences between the 1D anisotropy function values measured with the TL sheet and the data recommended in the updated AAPM TG-43 report were 10% at 5 mm and 7.5% at 10 mm, respectively, for the model 200 103Pd seed. Our experiments have demonstrated that it is feasible to use the TL sheet as a dosimeter in the determination of the dosimetric characteristics in the immediate vicinity of interstitial brachytherapy sources emitting low energy photons.

Near-field dosimetry of 125I sources for interstitial brachytherapy implants measured using thermoluminescent sheets.

The dosimetric characteristics were measured for two types of 125I low-energy photon-emitting sources by using a wide and highly sensitive thermoluminescent (TL) sheet film, which was developed for two-dimensional dose distribution measurements. The TL film is made of Teflon homogeneously mixed with small powders of thermoluminescence (BaSO4:Eu doped). Various dosimetric parameters (i.e., radial dose function, 2D and 1D anisotropy functions) of model 6711 and 6702 125I sources were obtained at various distances from the source surfaces to 15 mm. These parameters obtained with TL sheet were compared with the data recommended in the updated AAPM TG-43 report. The radial dose functions measured with TL sheet are in agreement with those established data of model 6711 125I seed and model 6702 125I seed at most of the distances within 5% and 7%, respectively. All the measured anisotropy functions showed symmetry about the longitudinal source axis. The anisotropy of dose distributions was clearly present in the immediate vicinity of the source edges. The measured 2D anisotropy function values at 1 cm are in reasonably good agreement with the recommended values. The differences at two points in the 1D anisotropy functions measured with TL sheet and the established data at 1 cm from source center were 0.7% and 1.9% for model 6711 and 6702 125I sources, respectively; the differences at 0.5 cm were 1.5% and 1.7% for model 6711 and 6702 125I sources, respectively. The relative dosimetric characteristics in the vicinity of actual interstitial brachytherapy sources containing 125I have been experimentally determined by using the TL sheet as a 2D dosimeter.