Organic photovoltaics for simultaneous energy harvesting and high-speed MIMO optical wireless communications.

We show that organic photovoltaics (OPVs) are suitable for high-speed optical wireless data receivers that can also harvest power. In addition, these OPVs are of particular interest for indoor applications, as their bandgap is larger than that of silicon, leading to better matching to the spectrum of artificial light. By selecting a suitable combination of a narrow bandgap donor polymer and a nonfullerene acceptor, stable OPVs are fabricated with a power conversion efficiency of 8.8% under 1 Sun and 14% under indoor lighting conditions. In an optical wireless communication experiment, a data rate of 363 Mb/s and a simultaneous harvested power of 10.9 mW are achieved in a 4-by-4 multiple-input multiple-output (MIMO) setup that consists of four laser diodes, each transmitting 56 mW optical power and four OPV cells on a single panel as receivers at a distance of 40 cm. This result is the highest reported data rate using OPVs as data receivers and energy harvesters. This finding may be relevant to future mobile communication applications because it enables enhanced wireless data communication performance while prolonging the battery life in a mobile device.

Morphological, Chemical, and Electronic Changes of the Conjugated Polymer PTB7 with Thermal Annealing.

There is considerable interest in improving the performance of organic optoelectronic devices through processing techniques. Here, we study the effect of high-temperature annealing on the properties of the semiconducting polymer PTB7 and PTB7:fullerene blends, of interest as efficient organic photovoltaic (OPV) devices. Annealing to moderate temperature improves the PTB7 morphology and optoelectronic properties. High-temperature annealing also improves morphology but results in poorer optoelectronic properties. This is a result of side chain cleavage that creates by-products that act as trap states, increasing electronic disorder and decreasing mobility. We further observe changes to the PTB7 chemical structure after thermal cleavage that are similar to those following solar irradiation. This implies that side chain cleavage is an important mechanism in device photodegradation, which is a major "burn-in" loss mechanism in OPV. These results lend insight into side chain cleavage as a method of improving optoelectronic properties and suggest strategies for improvement in device photostability.

Morphology Changes Upon Scaling a High-Efficiency, Solution-Processed Solar Cell From Spin-Coating to Roll-to-Roll Coating.

Solution processing via roll-to-roll (R2R) coating promises a low cost, low thermal budget, sustainable revolution for the production of solar cells. Poly[(5,6-difluoro-2,1,3-benzothiadiazol-4,7-diyl)-alt-(3,3‴-di(2-octyldodecyl)-2,2';5',2″;5″,2‴-quaterthiophen-5,5-diyl)], PffBT4T-2OD, has recently been shown to achieve high power conversion efficiency (>10%) paired with multiple acceptors when thick films are spun-coat from hot solutions. We present detailed morphology studies of PffBT4T-2OD based bulk heterojunction films deposited by the volume manufacturing compatible techniques of blade-coating and slot-die coating. Significant aspects of the film morphology, the average crystal domain orientation and the distribution of the characteristic phase separation length scales, are remarkably different when deposited by the scalable techniques vs spun-coat. Yet, we find that optimized blade-coated devices achieve PCE >9.5%, nearly the same as spun-coat. These results challenge some widely accepted propositions regarding what is an optimal BHJ morphology and suggest the hypothesis that diversity in the morphology that supports high performance may be a characteristic of manufacturable systems, those that maintain performance when coated thicker than ≈200 nm. In situ measurements reveal the key differences in the solidification routes for spin- and blade- coating leading to the distinct film structures.