ABSTRACT
Silver nanoparticle (Ag-NP) containing antibacterial micro-arc oxidation (MAO) coatings have already been synthesized over titanium-based materials via the MAO process employed in silver acetate (AgC2H3O2) containing electrolyte. However, the way of incorporation and in-situ formation of Ag-NPs within the MAO coating have not been documented yet. Present work was initiated to reveal the mechanism of Ag-NP formation within the MAO coatings. Thus, the structure of the MAO coating fabricated on commercial purity titanium in the AgC2H3O2-containing electrolyte was investigated by electron microscopy techniques. To this end, the cross-sectional high-resolution electron microscopy studies were carried out on lamella cut out with the focused ion beam technique, and these investigations were backed by X-ray photoelectron spectroscopy measurements of chemical composition on the surface of the MAO coating. These studies revealed that Ag is dispersed in the form of nanoparticles throughout the coating and that a higher density was confirmed closer to the micro-pores.
ABSTRACT
The study is concerned with the mechanical properties of Zn and three Zn-Mg double alloys with Mg concentrations: 0.5%, 1.0% and 1.5% in the form of rods with a diameter of 5 mm as potential materials for use in biodegradable medical implants, such as vascular stents. The materials were cast, next conventionally hot extruded at 250 °C and finally, hydrostatically extruded (HE) at ambient temperature. Occasionally HE process was carried at liquid nitrogen temperature or in combination with the ECAP process. After HE, the microstructure of the alloys was made up of fine-grained αZn of mean grain size ~1 µm in a 2-phase coat of 50-200 nm nano-grains of the fine αZn + Mg2Zn11 eutectic. The 3 to 4-fold reduction of grain size as a result of HE allowed an increase in yield strength from 100% to over 200%, elongation to fracture from 100% to thirty fold and hardness over 50% compared to the best literature results for similar alloys. Exceptions accounted for elongation to fracture in case of Zn-0.5 Mg alloy and hardness in case of Zn-1.5 Mg alloy, both of which fell by 20%. For the Zn-0.5 Mg and Zn-1Mg alloys, after immersion tests, no corrosive degradation of plasticity was observed. Achieving these properties was the result of generating large plastic deformations at ambient temperature due to the application of high pressure forming with the cumulative HE method. The results showed that Zn-Mg binary alloys after HE have mechanical and corrosive characteristics, qualifying them for applications in biodegradable implants, including vascular stents.
