ABSTRACT
The low electrical conductivity and the high surface defect density of the TiO2 electron transport layer (ETL) limit the quality of the following perovskite (PVK) layers and the power conversion efficiency (PCE) of corresponding perovskite solar cells (PSCs). Sulfur was reported as an effective element to passivate the TiO2 layer and improve the PCE of PSCs. In this work, we further investigate the effect of chemical valences of sulfur on the performance of TiO2/PVK interfaces, CsFAMA PVK layers, and solar cells using TiO2 ETL layers treated with Na2S, Na2S2O3, and Na2SO4, respectively. Experimental results show that the Na2S and Na2S2O3 interfacial layers can enlarge the grain size of PVK layers, reduce the defect density at the TiO2/PVK interface, and improve the device efficiency and stability. Meanwhile, the Na2SO4 interfacial layer leads to a smaller perovskite grain size and a slightly degraded TiO2/PVK interface and device performance. These results indicate that S2- can obviously improve the quality of TiO2 and PVK layers and TiO2/PVK interfaces, while SO42- has little effects, even negative effects, on PSCs. This work can deepen the understanding of the interaction between sulfur and the PVK layer and may inspire further progress in the surface passivation field.
ABSTRACT
The performance of a bismuth oxychloride (BiOCl)-based quartz crystal microbalance (QCM) humidity sensor was studied using an oscillating circuit method. The BiOCl powder was prepared by a hydrolysis method. Scanning electron microscopy, X-ray diffraction, and Fourier transform infrared spectroscopy were used to characterize the BiOCl sample. Its humidity-sensing property was analyzed by combining it with a QCM at room temperature (25 °C). Experimental results indicated that the BiOCl-based QCM sensor showed good humidity characteristics from 11.3 to 97.3%, such as good logarithmic frequency response to humidity levels (R 2 = 0.994), fast response time (5.2 s)/recovery time (4.5 s), good reversibility, stability, repeatability, and low humidity hysteresis. In addition, the response to human nose breaths showed excellent practicability. Finally, the humidity sensing mechanism of the BiOCl-based QCM humidity sensor was discussed in detail. This work demonstrates that BiOCl is a promising candidate material for humidity detection.