ABSTRACT
AIM: The aim of this study is to compare and to evaluate effect of curing light and curing modes on the nanohybrid composite resins with conventional Bis-GMA and novel tricyclodecane (TCD) monomers. METHODOLOGY: Two nanohybrid composites, IPS empress direct and charisma diamond were used in this study. Light-emitting diode (LED)-curing unit and quartz-tungsten-halogen (QTH)-curing unit which were operated into two different modes: continuous and soft start. Based on the composite resin, curing lights, and mode of curing used, the samples were divided into 8 groups. After polymerization, the samples were stored for 48 h in complete darkness at 37°C and 100% humidity. The Vickers hardness (VK) of the surface was determined with Vickers indenter by the application of 200 g for 15 s. Three VK readings were recorded for each sample surface both on top and bottom surfaces. For all the specimens, the three hardness values for each surface were averaged and reported as a single value. The mean VK and hardness ratio were calculated. The depth of cure was assessed based on the hardness ratio. RESULTS: Comparison of mean hardness values and hardness ratios was done using ANOVA with post hoc Tukey's test. CONCLUSION: Both QTH- and LED-curing units had shown the adequate depth of cure. Soft-start-curing mode in both QTH- and LED-curing lights had effectively increased microhardness than the continuous mode of curing. TCD monomer had shown higher hardness values compared with conventional Bis-GMA-containing resin.
ABSTRACT
Understanding the morphological anatomy of the root and root canal systems of the teeth increases the success rate of endodontic therapy. Advanced diagnostic imaging techniques like cone beam computed tomography (CBCT) are an essential aid in understanding the anatomy of teeth especially in mandibular premolars. Most commonly mandibular first and second premolars have a single root and a single canal. However, multiple root and canals have also been reported. The present case report discusses endodontic management of a three rooted mandibular first premolar using CBCT.
ABSTRACT
One of the determining factors for the success of endodontic therapy is understanding the morphological anatomy of the tooth structure and its variants in relation to its template anatomy. The internal anatomy of maxillary first premolars is particularly complex due to their variation in number of roots and canal configuration. However, the bilateral presence of three roots in a maxillary first premolar is of rare occurrence. This case report describes the unusual anatomy bilaterally detected in maxillary first premolars using Cone-Beam Computed Tomography.
