ABSTRACT
The performance of upflow multitube microbial fuel cell (UM2FC) from membrane concentrate of domestic wastewater (50% concentrate or a volume to concentration ratio of 2) has been investigated in a laboratory test. The test found that the UM2FC with the tin-coated copper mesh and coil spring under different hydraulic retention times (HRTs) produced maximum electricity of 916 ± 200 mW/m3 (61 mW/m2) at an HRT of 0.75 day with a 78% soluble chemical oxygen demand (sCOD) removal efficiency and 3% and 20% Coulombic efficiencies (CEs). The whole-cell resistance as calculated from the Nyquist plot and equivalent circuit were approximately 134 and 255 Ω for HRTs of 0.5 and 0.75 days, respectively. Considering HRT, the current increase with longer HRT could be due to longer contact time between organic material and biofilm, which results in a higher electrical efficiency. The results showed that UM2FC could represent an effective system for simultaneous membrane concentrate treatment and electricity production after further improvements on MFC and operating conditions.
Subject(s)
Bioelectric Energy Sources , Waste Disposal, Fluid/methods , Wastewater , Bioelectric Energy Sources/microbiology , Biofilms , Biological Oxygen Demand Analysis , Electricity , Membranes, Artificial , Wastewater/chemistry , Wastewater/microbiologyABSTRACT
Performance of cathode materials in microbial fuel cell (MFC) from dairy wastewater has been investigated in laboratory tests. Both cyclic voltammogram experiments and MFC tests showed that Pt-Ni cathode much better than pure Pt cathode. MFC with platinum cathode had the maximum power density of 0.180 W m(-2) while MFC with Pt:Ni (1:1) cathode produced the maximum power density of 0.637 W m(-2), even if the mass mixing ratio of Pt is lower in the alloy were used. The highest chemical oxygen demand (COD) removal efficiency was around 82-86% in both systems. The cyclic voltammogram (CV) analyses show that Pt:Ni (1:1) offers higher specific surface area than Pt alone does. X-ray diffraction (XRD) and Scanning Electron Microscopy (SEM) results showed that entire Pt:Ni (1:1) alloys can reduce the oxygen easily than pure platinum, even though less precious metal amount. The main outcome of this study is that Pt-Ni, may serve as a alternative catalyst in MFC applications.
Subject(s)
Bioelectric Energy Sources , Membranes, Artificial , Nickel/chemistry , Platinum/chemistry , Catalysis , Electrochemical Techniques , ElectrodesABSTRACT
This study focused on using beer brewery wastewater (BBW) to evaluate membrane concentrate disposal and production of electricity in microbial fuel cells. In the membrane treatment of BBW, the membrane permeate concentration was 570 ± 30 mg/L corresponding to a chemical oxygen demand (COD) removal efficiency of 75 ± 5%, and the flux values changed between 160 and 40 L/m(2)-h for all membrane runs. For electricity production from membrane concentrate, the highest current density in the microbial fuel cell (MFC) was observed to be 1950 mA/m(2) according to electrode surface area with 36% COD removal efficiency and 2.48% CE with 60% BBW membrane concentrate. The morphologies of the cation exchange membrane and the MFC deterioration were studied using a scanning electron microscope (SEM), attenuated total reflection-Fourier transform infrared (ATR-FTIR) spectroscopy, differential scanning calorimetry (DSC), and thermal gravimetric analysis (TGA). A decrease in the thermal stability of the sulfonate (-SO3H) groups was demonstrated and morphological changes were detected in the SEM analysis.
