Imaging porosity evolution of tight sandstone during spontaneous water imbibition by X-ray Micro-CT.

Water imbibition is an important process in reservoir rocks during hydraulic fracturing and water-based enhanced oil recovery operations. However, the water imbibition behavior in tight sandstones has not been fully understood due to their complex pore structure, including the presence of nano and micron-sized pores and throats, surface properties, and wide variation in mineralogy. The present study focuses on the effect of spontaneous water imbibition on the porosity evolution of a tight sandstone. Within this context, a core of Torrey Buff sandstone was characterized by using a combination of multiscale imaging methods (X-ray Computed Tomography, Scanning Electron Microscopy), laboratory experiments (porosity-permeability measurements), and analytical techniques (X-ray Diffraction, Fourier Transform Infrared Spectroscopy, Scanning Electron Microscopy-Energy Dispersive Spectroscopy, and Thermogravimetry). The studied tight sandstone core has a porosity of 12.3 % and permeability of 2.05mD with minerals of quartz (58 %), clays (kaolinite and illite, 23 %), K-feldspar (7 %), dolomite (7 %) and calcite (5 %). Primary and secondary pores, ranging in size from 60 to 140 µm and 30-50 µm, respectively, are mostly filled with highly-soluble carbonate minerals and hydrophilic illite, which influence the spontaneous water imbibition capacity of the tight sandstone. The multiscale imaging technique indicates that after a 10-h long water imbibition experiment, the average pore size of the tight sandstone increased by 1.28 %, reaching 2.35 % at the rock-water contact and 0.13 % at the top of the core. In other words, throughout the core, the porosity changes upon water imbibition are not uniform but show an almost linear trend. This observation could be explained by the significant contribution of highly-soluble carbonates and hydrophilic illite on the microstructure of the tight sandstone. This study implies that multiscale imaging techniques, crucial in examining spontaneous water imbibition, hold promise for further research in enhanced oil recovery or hydraulic fracking in tight sandstones.

Effect of lithological properties of beach sediments on plastic pollution in Bodrum Peninsula (SW Türkiye).

The effects grain size on transport and retention of plastics in sediments are controversial issue. Four beaches were selected on the Bodrum Peninsula (SW Türkiye) for this study. Twenty-four samples with poorly to well sorted, sandy gravel, gravel, or gravelly sand were collected from the top five cm of the sampling quadrant's four corners and center of 1 m2 area, from shoreline and backshore. The highest plastic content (38 mesoplastics/600 g - 455 microplastics (MPs)/1200 g) was determined on the Bodrum Coast having the highest population. Polyethylene (PE), polypropylene (PP), polyvinyl chloride (PVC), polystyrene (PS), polyethylene terephthalate (PET) and polyurethane (PU) were predominantly detected with Fourier Transform Infrared Spectroscopy (FTIR) analysis as MPs as a fragment and fiber. This study indicates the negative correlation between grain size and the number of MPs in coastal sediments. Anthropogenic activities are evaluated as a possible primary source of plastic pollution in the study area.

ESR dating of calcrete nodules from Bala, Ankara (Turkey): preliminary results.

The age of two calcrete nodules (C1 and C2) from the Bala section in the region of Ankara, Turkey, is determined by the Electron Spin Resonance (ESR) method. Three radiation-induced ESR signals at g=2.0056 (A signal), g=2.0006 (C signal) and g=2.0038 (broad signal, BL) were observed. The broad signal (BL) intensity was used as a dating signal. The properties of this dating signal are described in this manuscript. The calcrete nodules were irradiated with a (60)Co gamma source and measured with an ESR spectrometer (X-band) to obtain the signal intensity vs. dose curve and fitted well with the single exponential saturation functions. Based on this model, accumulated dose (D(E)) values for dating are obtained using the multiple-aliquot additive dose method. The D(E) values of C1 and C2 calcretes are 1880±207 and 671±67 Gy, respectively. The ESR ages of the two calcrete samples are obtained by assessing the annual dose rate (D) from the content of (238)U, (232)Th and K(2)O determined by wavelength dispersive X-ray fluorescence (XRF) spectrometry. The results are 761±120 and 419±64 ka, respectively, falling into the Middle Pleistocene Epoch in the geological time scale in agreement with the positions of the stratigraphical record.