Structure-Related Electronic and Magnetic Properties in Ultrathin Epitaxial NixFe3-xO4 Films on MgO(001).

Off-stoichiometric NixFe3-xO4 ultrathin films (x < 2.1) with varying Ni content x and thickness 16 (±2) nm were grown on MgO(001) by reactive molecular beam epitaxy. Synchrotron-based high-resolution X-ray diffraction measurements reveal vertical compressive strain for all films, resulting from a lateral pseudomorphic adaption of the film to the substrate lattice without any strain relaxation. Complete crystallinity with smooth interfaces and surfaces is obtained independent of the Ni content x. For x < 1 an expected successive conversion from Fe3O4 to NiFe2O4 is observed, whereas local transformation into NiO structures is observed for films with Ni content x > 1. However, angle-resolved hard X-ray photoelectron spectroscopy measurements indicate homogeneous cationic distributions without strictly separated phases independent of the Ni content, while X-ray absorption spectroscopy shows that also for x > 1, not all Fe2+ cations are substituted by Ni2+ cations. The ferrimagnetic behavior, as observed by superconducting quantum interference device magnetometry, is characterized by decreasing saturation magnetization due to the formation of antiferromagnetic NiO parts.

Increased Readiness for Water Splitting: NiO-Induced Weakening of Bonds in Water Molecules as Possible Cause of Ultra-Low Oxygen Evolution Potential.

The development of non-precious metal-based electrodes that actively and stably support the oxygen evolution reaction (OER) in water electrolysis systems remains a challenge, especially at low pH levels. The recently published study has conclusively shown that the addition of haematite to H2 SO4 is a highly effective method of significantly reducing oxygen evolution overpotential and extending anode life. The far superior result is achieved by concentrating oxygen evolution centres on the oxide particles rather than on the electrode. However, unsatisfactory Faradaic efficiencies of the OER and hydrogen evolution reaction (HER) parts as well as the required high haematite load impede applicability and upscaling of this process. Here it is shown that the same performance is achieved with three times less metal oxide powder if NiO/H2 SO4 suspensions are used along with stainless steel anodes. The reason for the enormous improvement in OER performance by adding NiO to the electrolyte is the weakening of the intramolecular O─H bond in the water molecules, which is under the direct influence of the nickel oxide suspended in the electrolyte. The manipulation of bonds in water molecules to increase the tendency of the water to split is a ground-breaking development, as shown in this first example.

Real-Time Monitoring of Strain Accumulation and Relief during Epitaxy of Ultrathin Co Ferrite Films with Varied Co Content.

Ultrathin CoxFe3-xO4 films of high structural quality and with different Co content (x = 0.6-1.2) were prepared by reactive molecular beam epitaxy on MgO(001) substrates. Epitaxy of these ferrite films is extensively monitored by means of time-resolved (operando) X-ray diffraction recorded in out-of-plane geometry to characterize the temporal evolution of the film structure. The Co ferrite films show high crystalline ordering and smooth film interfaces independent of their Co content. All CoxFe3-xO4 films exhibit enhanced compressive out-of-plane strain during the early stages of growth, which partly releases with increasing film thickness. When the Co content of the ferrite films increases, the vertical-layer distances increase, accompanied by slightly increasing film roughnesses. The latter result is supported by surface-sensitive low-energy electron diffraction as well as X-ray reflectivity measurements on the final films. In contrast, the substrate-film interface roughness decreases with increasing Co content, which is confirmed with X-ray reflectivity measurements. In addition, the composition and electronic structure of the ferrite films is characterized by means of hard X-ray photoelectron spectroscopy performed after film growth. The experiments reveal the expected increasing Fe3+/Fe2+ cation ratios for a higher Co content.

Influence of Oxygen Plasma on the Growth and Stability of Epitaxial NiCo2O4 Ultrathin Films on Various Substrates.

In this work, we investigated the influence of oxygen plasma on the growth of nickel cobaltite (NiCo2O4) thin films compared to growth in a molecular oxygen atmosphere. The films were grown on MgO(001), MgAl2O4(001) and SrTiO3(001) substrates by oxygen plasma (atmosphere of activated oxygen)-assisted and reactive molecular beam epitaxy (molecular oxygen atmosphere). Soft X-ray photoelectron spectroscopy showed that only the use of oxygen plasma led to a spectrum characteristic of (NiCo2O4). Low energy electron diffraction measurements were conducted to obtain information on the structure of the film surfaces. The results proved the formation of a spinel surface structure for films grown with oxygen plasma, while the formation of a rock salt structure was observed for growth with molecular oxygen. To determine the film thickness, X-ray reflectivity measurements were performed. If oxygen plasma were used to grow (NiCo2O4) films, this would result in lower film thicknesses compared to growth using molecular oxygen although the cation flux was kept constant during deposition. Additional X-ray diffraction experiments delivered structural information about the bulk structure of the film. All films had a rock salt bulk structure after exposure to ambient conditions. Angle-resolved hard X-ray photoelectron spectroscopy revealed a homogeneous depth distribution of cations of the grown film, but no typical (NiCo2O4) spectrum anymore. Thus, on the one hand, (NiCo2O4) films with a spinel structure prepared using activated oxygen were not stable under ambient conditions. The structure of these films was transformed into NiCo oxide with a rock salt structure. On the other hand, it was not possible to form (NiCo2O4) films using molecular oxygen. These films had a rock salt structure that was stable under ambient conditions.

Real-Time Monitoring the Growth of Epitaxial CoxFe3-xO4 Ultrathin Films on Nb-Doped SrTiO3(001) via Reactive Molecular Beam Epitaxy by Means of Operando HAXPES.

In this work, we present a comprehensive study on real-time monitoring the growth of epitaxial CoxFe3-xO4 thin films grown on SrTiO3(001) substrates via reactive molecular beam epitaxy. The growth process was monitored during evaporation by means of time resolved operando hard X-ray photoelectron spectroscopy (HAXPES). We prepared ultrathin ferrite films using different oxygen partial pressures, showing pure metallic, light oxidic, and cobalt ferrite-like growth. Additional X-ray diffraction measurements confirm HAXPES results.

Cationic Ordering and Its Influence on the Magnetic Properties of Co-Rich Cobalt Ferrite Thin Films Prepared by Reactive Solid Phase Epitaxy on Nb-Doped SrTiO3(001).

Here, we present the (element-specific) magnetic properties and cation ordering for ultrathin Co-rich cobalt ferrite films. Two Co-rich CoxFe3-xO4 films with different stoichiometry (x=1.1 and x=1.4) have been formed by reactive solid phase epitaxy due to post-deposition annealing from epitaxial CoO/Fe3O4 bilayers deposited before on Nb-doped SrTiO3(001). The electronic structure, stoichiometry and homogeneity of the cation distribution of the resulting cobalt ferrite films were verified by angle-resolved hard X-ray photoelectron spectroscopy. From X-ray magnetic circular dichroism measurements, the occupancies of the different sublattices were determined using charge-transfer multiplet calculations. For both ferrite films, a partially inverse spinel structure is found with increased amount of Co3+ cations in the low-spin state on octahedral sites for the Co1.4Fe1.6O4 film. These findings concur with the results obtained by superconducting quantum interference device measurements. Further, the latter measurements revealed the presence of an additional soft magnetic phase probably due to cobalt ferrite islands emerging from the surface, as suggested by atomic force microscope measurements.

From Bad Electrochemical Practices to an Environmental and Waste Reducing Approach for the Generation of Active Hydrogen Evolving Electrodes.

The electrodeposition of noble metals using corresponding dissolved metal salts represents an interesting process for the improvement of the electrocatalytic hydrogen evolution reaction (HER) properties of less active substrate materials. The fact that only a small fraction of the dissolved noble metals reaches the substrate represents a serious obstacle to this common procedure. We therefore chose a different path. It was found that the HER activity of Ni42 alloy drastically increased (η=140 mV at j=10 mA cm-2 ; pH 1) when a platinum counter electrode was used during polarization experiments in acid. This improvement was caused by a platinum transfer from the platinum anode to the steel cathode, a process which occurred simultaneously to the hydrogen evolution. The negligible accumulation of Pt (26 µg) in the electrolyte turns this straight-forward transfer procedure into a highly cost-effective, environmentally friendly, and waste reducing approach for the generation of cheap, stable and effective HER electrodes.

Electro-oxidation of a cobalt based steel in LiOH: a non-noble metal based electro-catalyst suitable for durable water-splitting in an acidic milieu.

The use of proton exchange membrane (PEM) electrolyzers is the method of choice for the conversion of solar energy when frequently occurring changes of the current load are an issue. However, this technique requires electrolytes with low pH. All oxygen evolving electrodes working durably and actively in acids contain IrOx. Due to their scarcity and high acquisition costs, noble elements like Pt, Ru and Ir need to be replaced by earth abundant elements. We have evaluated a cobalt containing steel for use as an oxygen-forming electrode in H2SO4. We found that the dissolving of ingredients out of the steel electrode at oxidative potential in sulfuric acid, which is a well-known, serious issue, can be substantially reduced when the steel is electro-oxidized in LiOH prior to electrocatalysis. Under optimized synthesis conditions a cobalt-containing tool steel was rendered into a durable oxygen evolution reaction (OER) electrocatalyst (weight loss: 39 µg mm-2 after 50 000 s of chronopotentiometry at pH 1) that exhibits overpotentials down to 574 mV at 10 mA cm-2 current density at pH 1. Focused ion beam SEM (FIB-SEM) was successfully used to create a structure-stability relationship.

Mixed-Valent Mn16-Containing Heteropolyanions: Tuning of Oxidation State and Associated Physicochemical Properties.

The two 16-manganese-containing, Keggin-based 36-tungsto-4-silicates [Mn(III)10Mn(II)6O6(OH)6(PO4)4(A-α-SiW9O34)4](28-) (1) and [Mn(III)4Mn(II)12(OH)12(PO4)4(A-α-SiW9O34)4](28-) (2) have been prepared by reaction of the trilacunary Keggin precursor [A-α-SiW9O34](10-) with either Mn(OOCCH3)3·2H2O (for 1) or MnCl2·4H2O (for 2), in aqueous phosphate solution at pH 9. Polyanions 1 and 2 comprise mixed-valent, cationic {Mn(III)10Mn(II)6O6(OH)6}(24+) and {Mn(III)4Mn(II)12(OH)12}(24+) cores, respectively, encapsulated by four phosphate groups and four {SiW9} units in a tetrahedral fashion. Both polyanions were structurally and compositionally characterized by single-crystal XRD, IR, thermogravimetric analysis, and X-ray absorption spectroscopy. Furthermore, studies were performed probing the magnetic, electrochemical, oxidation catalytic, and Li-ion battery performance of 1 and 2.

Oxidized Mild Steel S235: An Efficient Anode for Electrocatalytically Initiated Water Splitting.

The surface of steel S235 was oxidized by Cl2 gas and checked for its electrocatalytic efficiency regarding oxygen formation in aqueous solution. If exposed to humid Cl2 gas for 110 min, steel S235 became an electrocatalyst that exhibits an overpotential for the oxygen evolution reaction (OER) of 462 mV at 1 mA cm(-2) at pH 7. The OER activity of the same sample at pH 13 was moderate (347 mV overpotential at 2.0 mA cm(-2) current density) in comparison with OER electrocatalysts developed recently. Potential versus time plots measured at a constant current demonstrate the sufficient stability of all samples under catalysis conditions at pH 7 and 13 for tens of hours. High-resolution X-ray photoelectron spectra could be reasonably resolved with the proviso that Fe2 O3 , FeO(OH), MnO(OH), and Mn2 O3 are the predominant Fe and Mn species on the surface of the oxidized steel S235.

Tunnel junction based memristors as artificial synapses.

We prepared magnesia, tantalum oxide, and barium titanate based tunnel junction structures and investigated their memristive properties. The low amplitudes of the resistance change in these types of junctions are the major obstacle for their use. Here, we increased the amplitude of the resistance change from 10% up to 100%. Utilizing the memristive properties, we looked into the use of the junction structures as artificial synapses. We observed analogs of long-term potentiation, long-term depression and spike-time dependent plasticity in these simple two terminal devices. Finally, we suggest a possible pathway of these devices toward their integration in neuromorphic systems for storing analog synaptic weights and supporting the implementation of biologically plausible learning mechanisms.