Pulsed corona discharge oxidation of aqueous lignin: decomposition and aldehydes formation.

Lignin is the mass waste product of pulp and paper industry mostly incinerated for energy recovery. Lignin is, however, a substantial source of raw material for derivatives currently produced in costly wet oxidation processes. The pulsed corona discharge (PCD) for the first time was applied to lignin oxidation aiming a cost-effective environmentally friendly lignin removal and transformation to aldehydes. The experimental research into treatment of coniferous kraft lignin aqueous solutions was undertaken to establish the dependence of lignin oxidation and aldehyde formation on the discharge parameters, initial concentration of lignin and gas phase composition. The rate and the energy efficiency of lignin oxidation increased with increasing oxygen concentration reaching up to 82 g kW-1 h-1 in 89% vol. oxygen. Oxidation energy efficiency in PCD treatment exceeds the one for conventional ozonation by the factor of two under the experimental conditions. Oxidation at low oxygen concentrations showed a tendency of the increasing aldehydes and glyoxylic acid formation yield.

Determination of statins by gas chromatography - EI/MRM - Tandem mass spectrometry: fermentation of pine samples with Pleurotus ostreatus.

Statins were separated and quantified with gas chromatography-mass spectrometry (GC-EI-MS/MS) using total ion monitoring (TIC) and multiple reactions monitoring (MRM). The MRM method in statins determination has a novelty value, since there are no previous studies on their simultaneous analysis in environmental or plant samples. The method development and optimization was challenging due to the physicochemical similarities of the silylated lovastatin, simvastatin, pravastatin, fluvastatin, and atorvastatin. The results showed that the use of MRM decreased their detection and quantification limits by factors of 2-10 compared to that obtained in TIC monitoring. The concentration calibration was made between 247.5ng/L and 9900ng/L. Limits of detection and quantification were between 50ng/L (lovastatin)-500ng/L (pravastatin) and 250ng/L (lovastatin)-1000ng/L (pravastatin), respectively. Based on the MRM results, the wood bark and phloem samples contained lovastatin, lovastatin-lactone, simvastatin, simvastatin-lactone, and pravastatin. Their concentrations were 250-3000µg/L, i.e. 4.2-50mg/kg in phloem and bark. However, they were not detected in fluids made with Pleurotus ostreatus fermentation of wood core.