ABSTRACT
INTRODUCTION: The HeartMate 3™ has shown lower rates of adverse events compared to previous devices due to the design and absence of mechanical bearings. For previous devices, sound analysis emerged as a way to assess pump function. The aims of this study were to determine if sound analysis can be applied to the HeartMate 3 in vivo and in vitro and to evaluate an electronic stethoscope. METHOD: Sound recordings were performed with microphones and clinical accessible electronic stethoscope. The recordings were studied in both the time and the frequency domains. Recordings from four patients were performed to determine if in vivo and in vitro recordings are comparable. RESULTS: The results show that it is possible to detect sound from HeartMate 3 and the sound spectrum is clear. Pump frequency and frequency of the pulsatile mode are easily determined. Frequency spectra from in vitro and in vivo recordings have the same pattern, and the major proportion (96.7%) of signal power is located at the pump speed frequency ±40 Hz. The recordings from the patients show low inter-individual differences except from location of peaks originating from pump speed and harmonics. Electronic stethoscopes could be used for sound recordings, but the dedicated equipment showed a clearer sound spectrum. DISCUSSION: The results show that acoustic analysis can also be performed with the HeartMate 3 and that in vivo and in vitro sound spectrum is similar. The frequency spectra are different from previous devices, and methods for assessing pump function or thrombosis need further evaluation.
Subject(s)
Equipment Failure Analysis , Heart-Assist Devices , Sound , Equipment Design , Equipment Failure Analysis/instrumentation , Equipment Failure Analysis/methods , Female , Heart Failure/physiopathology , Heart Failure/surgery , Heart Ventricles/physiopathology , Heart-Assist Devices/adverse effects , Heart-Assist Devices/standards , Humans , Magnetometry/methods , Male , Middle Aged , Quality Improvement , Spectrum Analysis/methodsABSTRACT
INTRODUCTION: The use of left ventricular assist device (LVAD) has grown rapidly. Adverse events do continue to occur. In recent years, analysis of LVAD sound recordings emerged as a means to monitor pump function and detect pump thrombosis. The aim of this study was to characterize the sounds from HeartMate II and to evaluate the use of handheld iOS devices for sound recordings. METHOD: Signal analysis of LVAD sound recordings, with dedicated recording equipment and iOS devices, was performed. Two LVADs running in mock loop circuits were compared to an implanted LVAD. Spectral analysis and parametric signal models were explored to quantify the sound and potentially detect changes in it. RESULTS: The sound recordings of two LVADs in individual mock loop circuits and a third one implanted in a patient appeared to be similar. Qualitatively, sound characteristics were preserved following changes in pump speed. Recordings using dedicated equipment showed that HeartMate II sound comprises low-frequency components corresponding to pump impeller rotation, as well as high-frequency components due to a pulse width modulation of the electric power to the pump. These different signal components interact and result in a complicated frequency spectrum. The iPhone and iPod recordings could not reproduce the sounds as well as the dedicated equipment. In particular, lower frequencies were affected by outside disturbances. DISCUSSION: This article outlines a systematic approach to LVAD sound analysis using signal processing methods to quantify and potentially detect changes, and describes some of the challenges, for example, with the use of inexpensive recording devices.
