ABSTRACT
BACKGROUND: Custom insoles are commonly prescribed to patients with diabetes to redistribute plantar pressure and decrease the risk of ulceration. Advances in 3D printing have enabled the creation of 3D-printed personalized metamaterials whose properties are derived not only from the base material but also the lattice microstructures within the metamaterial. Insoles manufactured using personalized metamaterials have both patient-specific geometry and stiffnesses. However, the safety and biomechanical effect of the novel insoles have not yet been tested clinically. METHODS: Individuals without ulcer, neuropathy, or deformity were recruited for this study. In-shoe walking plantar pressure at baseline visit was taken and sensels with pressure over 200 kPa was used to define offloading region(s). Three pairs of custom insoles (two 3D printed insoles with personalized metamaterials (Hybrid and Full) designed based on foot shape and plantar pressure mapping and one standard-of-care diabetic insole as a comparator). In-shoe plantar pressure measurements during walking were recorded in a standardized research shoe and the three insoles and compared across all four conditions. FINDINGS: Twelve individuals were included in the final analysis. No adverse events occurred during testing. Maximum peak plantar pressure and the pressure time integral were reduced in the offloading regions in the Hybrid and Full but not in the standard-of-care compared to the research shoe. INTERPRETATION: This feasibility study confirms our ability to manufacture the 3D printed personalized metamaterials insoles and demonstrates their ability to reduce plantar pressure. We have demonstrated the ability to modify the 3D printed design to offload certain parts of the foot using plantar pressure data and a patient-specific metamaterials in the 3D printed insole design. The advance in 3D printed technology has shown its potential to improve current care.
Subject(s)
Diabetes Mellitus , Diabetic Foot , Foot Orthoses , Diabetic Foot/therapy , Equipment Design , Feasibility Studies , Foot , Humans , Pressure , Printing, Three-Dimensional , Shoes , WalkingABSTRACT
Patients with diabetes mellitus are at elevated risk for secondary complications that result in lower extremity amputations. Standard of care to prevent these complications involves prescribing custom accommodative insoles that use inefficient and outdated fabrication processes including milling and hand carving. A new thrust of custom 3D printed insoles has shown promise in producing corrective insoles but has not explored accommodative diabetic insoles. Our novel contribution is a metamaterial design application that allows the insole stiffness to vary regionally following patient-specific plantar pressure measurements. We presented a novel workflow to fabricate custom 3D printed elastomeric insoles, a testing method to evaluate the durability, shear stiffness, and compressive stiffness of insole material samples, and a case study to demonstrate how the novel 3D printed insoles performed clinically. Our 3D printed insoles results showed a matched or improved durability, a reduced shear stiffness, and a reduction in plantar pressure in clinical case study compared to standard of care insoles.
Subject(s)
Foot Orthoses , Humans , Pressure , Printing, Three-Dimensional , Shoes , WorkflowABSTRACT
Amputation results in a wide range of functional limitations; advances in surgical, rehabilitative, and prosthetic care are aimed at optimizing functional quality of life for the spectrum of individuals with limb loss. This article initially focuses on advances in surgical and rehabilitative care, followed by noteworthy advances in prosthetics, including potential advantages and disadvantages. Although prosthetics tend to dominate attention in the field, it is important to remember that optimizing surgical and rehabilitative care are vital components of enhancing functional recovery and quality of life in people with limb loss.