ABSTRACT
Chitosan has become increasingly applied in agriculture worldwide, thus entering the soil environment. We hypothesized that chitosan should affect the water stability of soil. Since this problem has not been studied to date, we examined, for the first time, the influence of chitosan on the water stability and wettability of soil aggregates. The aggregates were prepared from four soils with various properties amended with different amounts of two kinds of powdered chitosan, and subjected to 1 and/or 10 wetting-drying cycles. The water stability was measured by monitoring air bubbling after aggregate immersion in water, and the wettability was measured by a water drop penetration test. The biopolymer with a lower molecular mass, lower viscosity, and higher degree of deacetylation was more effective in increasing the water stability of the soil than the biopolymer with a higher molecular mass, higher viscosity, and lower deacetylation degree. After a single wetting-drying cycle, the water stability of the soil aggregates containing chitosan with a higher molecular mass was generally lower than that of the soil; after ten wetting-drying cycles, the water stability increased 1.5 to 20 times depending on the soil. The addition of low-molecular-mass chitosan after a single wetting-drying cycle caused the water stability to become one to two hundred times higher than that of the soil. A trial to find out which soil properties (pH, C and N content, bulk density, porosity, and particle size distribution) are responsible for the effectiveness of chitosan action was not successful, and this will be the objective of further studies.
ABSTRACT
Due to the harmful effects of nanoparticles in the environment, their effective removal from aqueous media is of great importance. This paper described the research on the silver nanoparticles (Ag-NPs) sorption on biochars obtained from different feedstock types. The sorbents were produced through pyrolysis (double-barrel method) of the vineyard (BV), paulownia tree (BP), and tobacco (BT). BV exhibited the highest specific surface area, porosity, value of variable surface charge, and content of surface acidic functional groups among the used biochars. The pseudo-second order model best described the obtained adsorption kinetics, whereas the Freundlich model accounted for the registered adsorption data. The Ag-NPs removal was highly efficient in the case of BV, especially in the nanoparticle concentration range 50-500 mg/L. Thus, this biochar can be considered as an ecofriendly, effective, low-cost organic adsorbent, potentially used in the aqueous media purification.
