ABSTRACT
The removal of dyes from industrial wastewater is one of the most environmental challenges that should be addressed through sustainable technologies. In this study, a novel green and cost-effective granular from bentonite and bio-wastes of sawdust and corncob (GBSC) was prepared for sustainable treatment of acid orange 7 (AO7) dye wastewater. The d-optimal mixture method was employed to determine the optimum combination of the GBSC in terms of dye adsorption and structure stability. Characterizations of the GBSC were investigated using SEM, XRD, FTIR and BET analyses and compared with bentonite powder (BP), modified bentonite powder (MBP), and granular modified bentonite (GMB). According to the results, a mixture of bentonite 60 wt%, sawdust 20 wt% and corncob 20 wt% at 550 °C yielded the optimal combination of the GBSC which resulted to the highest adsorption capacity 135.22 mg/g, the lowest mass loss 3.1% and maximum crushing strength 12.275 N. The kinetic and isotherm of the adsorption data were fitted well by the pseudo-second-order model and Langmuir isotherm. Our finding suggested a green circular economy model by utilizing agriculture wastes (sawdust and corncob) to synthesize GBSC for sustainable dye wastewater treatment, which offers a cost-effective adsorbent (0.907 $/g) with high regeneration (4 times reusability with 40.5% removal rate) to keep them in circulation for as long as possible.
ABSTRACT
There is an urgent need for developing eco-friendly adsorbents for dye wastewater treatment with high efficiency and low cost. Meanwhile, organoclay has received an increasing attention as a natural adsorbent for dye removal. However, no comprehensive investigation has been conducted to evaluate the feasibility of this approach in terms of operation cost and removal efficiency. In this research, we intend to answer this question: could organoclay be used as an efficient and cost-effective approach for dye wastewater treatment? In line with that, after characterization of the Na-bentonite and modified clay by using SEM, EDX, FTIR and XRD, the performance of the organoclay was optimized in terms of AO7 dye removal efficiency and adsorption cost using response surface methods (RSM). Then, the organoclay performance was compared with other typical adsorbents activated carbon and chitosan. The characterization results proved that Na-bentonite was successfully modified by CTAB. According to RSM results, the maximum dye removal of 95% and the minimum adsorption cost of 0.009 $/g were achieved under optimum conditions of: pH: 5, AO7 concentration: 56 mg/L, contact time: 53 min and organoclay dosage: 0.8 g/L. While, in the case of other adsorbents of Na-bentonite, chitosan and activated carbon the maximum removal of 11%, 84% and 92% were achieved with 0.0136, 0.0324 and 0.1011 $/g, respectively. The adsorption kinetics and isotherms analyses revealed that the experimental data fitted well with the pseudo-second-order (R2 = 0.993) and Langmuir (R2 = 0.988). This study proved that organoclay can be used as a promising adsorbent for dye removal with low cost and high removal efficiency.