Improved Electrical Signal of Non-Poled 3D Printed Zinc Oxide-Polyvinylidene Fluoride Nanocomposites.

Polyvinylidene fluoride (PVDF) presents highly useful piezo and pyro electric properties but they are predicated upon the processing methods and the ensuing volume fraction of the ß-phase. Production of PVDF with higher ß-phase content for additive manufacturing (AM) is particularly desirable because it can enable the creation of custom parts with enhanced properties. Necessary steps from compounding to the testing of a 3D printed piezo sensitive sensor are presented in this paper. AM process variables and the influence of zinc oxide (ZnO) nanofiller on crystallinity, viscosity, and electromechanical properties of PVDF, have been explored. Fourier-transform infrared spectroscopy (FTIR) measurements confirm that a high cooling rate (HCR) of 30 °C min-1 promotes the conversion of the α-into the ß-phase, reaching a maximum of 80% conversion with 7.5-12.5% ZnO content. These processing conditions increase the elastic modulus up to 40%, while maintaining the ultimate strength, ≈46 MPa. Furthermore, HCR 10% ZnO-PVDF produces four times higher volts per Newton when compared to low cooling rate, 5 °C min-1, pristine PVDF. A piezoelectric biomedical sensor application has been presented using HCR and ZnO nanofiller. This technique also reduces the need for post-poling which can reduce manufacturing time and cost.

Characterization of the mechanical properties of a new grade of ultra high molecular weight polyethylene and modeling with the viscoplasticity based on overstress.

Enhancements to the service life and performance of orthopedic implants used in total knee and hip replacement procedures can be achieved through optimization of design and the development of superior biocompatible polymeric materials. The introduction of a new or modified polymer must, naturally, be preceded by a rigorous testing program. This paper presents the assessment of the mechanical properties of a new filled grade of ultra high molecular weight polyethylene (UHMWPE) designated AOX(TM) and developed by DePuy Orthopaedics Inc. The deformation behavior was investigated through a series of tensile and compressive tests including strain rate sensitivity, creep, relaxation, and recovery. The polymer was found to exhibit rate-reversal behavior for certain loading histories: strain rate during creep with a compressive stress can be negative, positive, or change between the two during a test. Analogous behavior occurs during relaxation as well. This behavior lies beyond the realm of most numerical models used to computationally investigate and improve part geometry through finite element analysis of components. To address this shortcoming, the viscoplasticity theory based on overstress (VBO) has been suitably modified to capture these trends. VBO is a state variable based model in a differential formulation. Numerical simulation and prediction of all of the aforementioned tests, including good reproduction of the rate reversal behavior, is presented in this study.

Rapid molecular imaging using attenuated total internal reflection planar array infrared spectroscopy for the analysis of counterfeit pharmaceutical tablets.

A planar array infrared (PA-IR) spectrograph containing an attenuated total internal reflection (ATR) accessory has been constructed in order to permit rapid analysis of poorly transmitting materials. The technique has been optimized to allow molecular spectroscopic information to be collected in roughly 2 seconds with a corresponding peak-to-peak noise value as low as 2.14 x 10(-4) absorbance units. Additionally, up to 150 spectra could be extracted from sample sizes as large as 6 mm where each spatial element measured 40 x 200 microm at the sample position. An application study for this technique entailed developing an embedding method that allows cross-sectioned pharmaceutical tablets to be brought into intimate contact with the internal reflection element (IRE) of the accessory. A supplemental investigation involved calculating the yield strength of multiple IRE materials in order to determine the maximum amount of pressure that can be applied to a sample without damaging the IRE. Finally, feasibility was demonstrated for using the instrument/accessory as a means to rapidly authenticate suspected counterfeit pharmaceutical tablets.