Achromatic Metalens over 60 nm Bandwidth in the Visible and Metalens with Reverse Chromatic Dispersion.

In this Letter, we experimentally report an achromatic metalens (AML) operating over a continuous bandwidth in the visible. This is accomplished via dispersion engineering of dielectric phase shifters: titanium dioxide nanopillars tiled on a dielectric spacer layer above a metallic mirror. The AML works in reflection mode with a focal length independent of wavelength from λ = 490 to 550 nm. We also design a metalens with reverse chromatic dispersion, where the focal length increases as the wavelength increases, contrary to conventional diffractive lenses. The ability to engineer the chromatic dispersion of metalenses at will enables a wide variety of applications that were not previously possible. In particular, for the AML design, we envision applications such as imaging under LED illumination, fluorescence, and photoluminescence spectroscopy.

Polarization-Insensitive Metalenses at Visible Wavelengths.

In this Letter, we demonstrate highly efficient, polarization-insensitive planar lenses (metalenses) at red, green, and blue wavelengths (λ = 660, 532, and 405 nm). Metalenses with numerical apertures (NA) of 0.85 and 0.6 and corresponding efficiencies as high as 60% and 90% are achieved. These metalenses are less than 600 nm-thick and can focus incident light down to diffraction-limited spots as small as ∼0.64λ and provide high-resolution imaging. In addition, the focal spots are very symmetric with high Strehl ratios. The single step lithography and compatibility with large-scale fabrication processes make metalenses highly promising for widespread applications in imaging and spectroscopy.

Intense THz Pulses with large ponderomotive potential generated from large aperture photoconductive antennas.

We report the generation of free space terahertz (THz) pulses with energy up to 8.3 ± 0.2 µJ from an encapsulated interdigitated ZnSe Large Aperture Photo-Conductive Antenna (LAPCA). An aperture of 12.2 cm2 is illuminated using a 400 nm pump laser with multi-mJ energies at 10 Hz repetition rate. The calculated THz peak electric field is 331 ± 4 kV/cm with a spectrum characterized by a median frequency of 0.28 THz. Given its relatively low frequency, this THz field will accelerate charged particles efficiently having very large ponderomotive energy of 15 ± 1 eV for electrons in vacuum. The scaling of the emission is studied with respect to the dimensions of the antenna, and it is observed that the capacitance of the LAPCA leads to a severe decrease in and distortion of the biasing voltage pulse, fundamentally limiting the maximum applied bias field and consequently the maximum energy of the radiated THz pulses. In order to demonstrate the advantages of this source in the strong field regime, an open-aperture Z-scan experiment was performed on n-doped InGaAs, which showed significant absorption bleaching.

Multispectral Chiral Imaging with a Metalens.

The vast majority of biologically active compounds, ranging from amino acids to essential nutrients such as glucose, possess intrinsic handedness. This in turn gives rise to chiral optical properties that provide a basis for detecting and quantifying enantio-specific concentrations of these molecules. However, traditional chiroptical spectroscopy and imaging techniques require cascading of multiple optical components in sophisticated setups. Here, we present a planar lens with an engineered dispersive response, which simultaneously forms two images with opposite helicity of an object within the same field-of-view. In this way, chiroptical properties can be probed across the visible spectrum using only the lens and a camera without the addition of polarizers or dispersive optical devices. We map the circular dichroism of the exoskeleton of a chiral beetle, Chrysina gloriosa, which is known to exhibit high reflectivity of left-circularly polarized light, with high spatial resolution limited by the numerical aperture of the planar lens. Our results demonstrate the potential of metasurfaces in realizing a compact and multifunctional device with unprecedented imaging capabilities.

Super-Dispersive Off-Axis Meta-Lenses for Compact High Resolution Spectroscopy.

Metasurfaces have opened a new frontier in the miniaturization of optical technology by allowing exceptional control over the wavefront. Here, we demonstrate off-axis meta-lenses that simultaneously focus and disperse light of different wavelengths with unprecedented spectral resolution. They are designed based on the geometric phase via rotated silicon nanofins and can focus light at angles as large as 80°. Due to the large angle focusing, these meta-lenses have superdispersive characteristics (0.27 nm/mrad) that make them capable of resolving wavelength differences as small as 200 pm in the telecom region. In addition, by stitching several meta-lenses together, we maintain a high spectral resolution for a wider wavelength range. The meta-lenses have measured efficiencies as high as 90% in the wavelength range of 1.1 to 1.6 µm. The planar and compact configuration together with high spectral resolution of these meta-lenses has significant potential for emerging portable/wearable optics technology.

Highly enhanced Raman scattering of graphene using plasmonic nano-structure.

Highly enhanced Raman scattering of graphene on a plasmonic nano-structure platform is demonstrated. The plasmonic platform consists of silver nano-structures in a periodic array on top of a gold mirror. The gold mirror is used to move the hot spot to the top surface of the silver nano-structures, where the graphene is located. Two different nano-structures, ring and crescent, are studied. The actual Raman intensity is enhanced by a factor of 890 for the G-peak of graphene on crescents as compared to graphene on a silicon dioxide surface. The highest enhancement is observed for the G-peak as compared to the 2D-peak. The results are quantitatively well-matched with a theoretical model using an overlap integral of incident electric field intensities with the corresponding intensities of Raman signals at the G- and 2D-peaks. The interaction of light with nano-structures is simulated using finite element method (FEM).

Silicon nanowire arrays with enhanced optical properties.

Vertical silicon nanowire arrays were fabricated leading to an enhanced photoluminescence (PL) emission and second-order nonlinear optical response. PL from the nanowires was increased by a factor of 50 as compared to bulk silicon. The second order nonlinearity was demonstrated in second-harmonic generation and rotational anisotropic measurements. Enhancement by at least a factor of 80 was achieved as compared to bulk silicon for the p-polarized input and s-polarized output. These enhancements in the silicon characteristics should enable highly desired applications using a silicon platform, such as nonlinear and active devices.

Color matrix refractive index sensors using coupled vertical silicon nanowire arrays.

Vivid colors are demonstrated in silicon nanowires with diameters ranging from 105 to 346 nm. The nanowires are vertically arranged in a square lattice with a pitch of 400 nm and are electromagnetically coupled to each other, resulting in frequency-dependent reflection spectra. Since the coupling is dependent on the refractive index of the medium surrounding the nanowires, the arrays can be used for sensing. A simple sensor is demonstrated by observing the change in the reflected color with changing refractive index of the surrounding medium. A refractive index resolution of 5 × 10(-5) is achieved by analyzing bright-field images captured with an optical microscope equipped with a charge coupled device camera.

Polarization resolved reflection from ordered vertical silicon nanowire arrays.

We measure polarization resolved reflections from ordered vertical silicon nanowire arrays of two different diameters and compare the results to rigorous coupled wave analysis simulations. Ellipsometric analysis based on anisotropic effective-medium approximation is used to fit the experimental data and estimate the diameter and length of the nanowires. In addition, depolarization of light is observed for wavelengths below 400 nm.

Enhanced first-order Raman scattering from arrays of vertical silicon nanowires.

Vertical ordered silicon nanowire arrays with diameters ranging from 30 to 60 nm are fabricated and display enhanced Raman scattering. The first-order 520 cm(-1) phonon mode shows no significant shift or peak broadening with increasing laser power, suggesting that the excellent defect-free diamond crystalline structure and thermal properties of bulk silicon are maintained. The Raman enhancement per unit volume of the first-order phonon peak increases with increasing nanowire diameter, and has maximum enhancement factors of 7.1 and 70 when compared to the original silicon on insulator (SOI) and bulk silicon wafers, respectively. For the array with 60 nm diameter nanowires, the total Raman intensity is larger than that of the SOI wafer. The results are understood using a model based on the confinement of light and are supported by finite difference time domain (FDTD) simulations.