Optimized Repopulation of Tendon Hydrogel: Synergistic Effects of Growth Factor Combinations and Adipose-Derived Stem Cells.

Background: Tendon-derived extracellular matrix (ECM) hydrogel has been shown to augment tendon healing in vivo. We hypothesized that reseeding of the gel with adipose-derived stem cells (ASCs) could further assist repopulation of the gel and that combinations of growth factors (GFs) would improve the survival of these cells after reseeding. Methods: A tendon-specific ECM solution was supplemented with varying concentrations of basic fibroblast growth factor (bFGF), insulin-like growth factor-1 (IGF-1), and platelet-derived growth factor-BB (PDGF-BB). Gels were then seeded with ASCs transfected with a green fluorescent protein/luciferin construct. Cell proliferation was determined using the MTT assay and histology, and GF and ASC augmented gels were injected into the back of Sprague Dawley rats. Bioluminescence of seeded gels was continuously followed after reseeding, and cell counts were performed after the gels were explanted at 14 days. Results: Synergistic effects of the GFs were seen, and an optimal combination was determined to be 10 ng/mL bFGF, 100 ng/mL IGF-1, and 100 ng/mL PDGF-BB (2.8-fold increase; P < .05). In vivo bioluminescence showed an improved initial survival of cells in gels supplemented with the optimal concentration of GF compared with the control group (10.6-fold increase at 8 days; P < .05). Cell counts of explants showed a dramatic endogenous repopulation of gels supplemented by GF + ASCs compared with both gels with GF but no ASCs (7.6-fold increase) and gels with ASCs but no GF (1.6-fold increase). Conclusion: Synergistic effects of GFs can be used to improve cellular proliferation of ASCs seeded to a tendon ECM gel. Reseeding with ASCs stimulates endogenous repopulation of the gel in vivo and may be used to further augment tendon healing.

Augmentation of tendon healing with an injectable tendon hydrogel in a rat Achilles tendon model.

BACKGROUND: Many unsolved problems in plastic and hand surgery are related to poor healing of acute and chronic tendon injuries. The authors hypothesized that tendon healing could be augmented by the addition of a tendon-derived, extracellular matrix hydrogel that would guide tissue regeneration. METHODS: Both Achilles tendons of 36 Wistar rats were given full-thickness injuries approximately 5 mm long and 0.5 mm wide from the tendon insertion at the calcaneus to the midsubstance. The hydrogel was injected into the injury site of one leg and compared with control saline in the other. The ultimate failure load, ultimate tensile stress, and stiffness were evaluated at 2, 4, and 8 weeks. Tendon cross-sections underwent histologic analysis (hematoxylin and eosin and picrosirius red) after the animals were killed. Statistical analysis of biomechanical data was performed using a paired t test. RESULTS: There was no significant difference in strength between gel and saline injections in ultimate failure load (p = 0.15), ultimate tensile stress (p = 0.42), or stiffness (p = 0.76) at 2 weeks. However, there was a significant difference in ultimate failure load (74.8 ± 11.6 N versus 58.4 ± 14.2 N; p = 0.02) at 4 weeks. The difference in ultimate tensile stress (p = 0.63) and stiffness (p = 0.08) remained insignificant. By 8 weeks, there was no significant difference in strength in ultimate failure load (p = 0.15), ultimate tensile stress (p = 0.39), or stiffness (p = 0.75). CONCLUSIONS: Treatment with the tendon hydrogel significantly increases the ultimate failure load of tendons at the critical 4-week time point, and is a promising method for augmentation of tendon healing.

Design and characterization of an injectable tendon hydrogel: a novel scaffold for guided tissue regeneration in the musculoskeletal system.

A biocompatible hydrogel consisting of extracellular matrix (ECM) from human tendons is described as a potential scaffold for guided tissue regeneration and tissue engineering purposes. Lyophilized decellularized tendons were milled and enzymatically digested to form an ECM solution. The ECM solution properties are assessed by proteome analysis with mass spectrometry, and the material's rheological properties are determined as a function of frequency, temperature, and time. In vivo application of the gel in a rat model is assessed for remodeling and host cell repopulation. Histology for macrophage invasion, fibroblast repopulation, and nanoscale properties of the gel is assessed. Gel interaction with multipotent adipoderived stem cells (ASCs) is also addressed in vitro to assess possible cytotoxicity and its ability to act as a delivery vehicle for cells. Proteome analysis of the ECM-solution and gel mass spectroscopy identified the most abundant 150 proteins, of which two isoforms of collagen I represented more than 55% of the sample. Rheology showed that storage (G') and loss (G″) of the ECM solution were stable at room temperature but displayed sigmoidal increases after ∼15 min at 37°C, matching macroscopic observations of its thermo responsiveness. G' and G″ of the gel at 1 rad/s were 213.1±19.9 and 27.1±2.4 Pa, respectively. Electron microscopy revealed fiber alignment and good structural porosity in the gel, as well as invasion of cells in vivo. Histology also showed early CD68(+) macrophage invasion throughout the gel, followed by increasing numbers of fibroblast cells. ASCs mixed with the gel in vitro proliferated, indicating good biocompatibility. This ECM solution can be delivered percutaneously into a zone of tendon injury. After injection, the thermoresponsive behavior of the ECM solution allows it to polymerize and form a porous gel at body temperature. A supportive nanostructure of collagen fibers is established that conforms to the three-dimensional space of the defect. This hydrogel holds the distinctive composition specific for tendon ECM, where tissue-specific cues facilitate host cell infiltration and remodeling. The results presented indicate that injectable ECM materials from tendon may offer a promising alternative in the treatment of tendinopathies and acute tendon injuries.

Reconstruction of the tendon-bone insertion with decellularized tendon-bone composite grafts: comparison with conventional repair.

PURPOSE: Injuries involving the tendon-bone interface (TBI) are difficult to address. Standard techniques typically lead to diminished strength of the healed insertion site. We hypothesized that these injuries would benefit from being reconstructed with decellularized composite grafts replacing both tendon and bone. To test this hypothesis, decellularized grafts were compared with conventional pullout repairs in an in vivo animal model. METHODS: We harvested 48 Achilles TBI grafts from rats and decellularized them. Tendon-bone interface graft reconstruction and pullout repairs were compared using a pair-matched design. Biomechanical properties were evaluated at 2, 4, 8, and 12 weeks. We evaluated histological analysis of insertion morphology and collagen type I/III content. RESULTS: There was a significant increase in ultimate failure load (35 ± 11 vs 24 ± 7 N) and ultimate tensile stress (1.5 ± 0.3 vs 1.0 ± 0.4 N/mm(2)) of the TBI grafts compared with pullout repairs at 2 weeks. These differences remained at 4 weeks. At 12 weeks, both TBI grafts and pullout repairs were as strong as native tissue and not significantly different from each other. Histology showed a more organized extracellular matrix in the TBI graft group at the early time points. Repopulation of the decellularized grafts increased over time. At 12 weeks, the insertion points of both groups were richly populated with cells that possessed morphologies similar to those found in native TBI. CONCLUSIONS: This study showed that decellularized TBI grafts were stronger compared with conventional pullout repairs at 2 and 4 weeks but were comparable at 12 weeks. A more organized extracellular matrix and different collagen composition in the early time points may explain the observed differences in strength. CLINICAL RELEVANCE: In the future, decellularized TBI grafts may be used to reconstruct tendon-bone insertion tears in multiple areas including the flexor tendon system.

Flexor tendon tissue engineering: acellularization of human flexor tendons with preservation of biomechanical properties and biocompatibility.

OBJECTIVE: Acellular human tendons are a candidate scaffold for tissue engineering flexor tendons of the hand. This study compared acellularization methods and their compatibility with allogeneic human cells. METHOD: Human flexor tendons were pretreated with 0.1% ethylenediaminetetracetic acid (EDTA) for 4 h followed by 24 h treatments of 1% Triton X-100, 1% tri(n-butyl)phosphate, or 0.1% or 1% sodium dodecyl sulfate (SDS) in 0.1% EDTA. Outcomes were assessed histologically by hematoxylin and eosin and SYTO green fluorescent nucleic acid stains and biochemically by a QIAGEN DNeasy kit, Sircol collagen assay, and 1,9 dimethylmethylene blue glycosaminoglycan assay. Mechanical data were collected using a Materials Testing System to pull to failure tendons acellularized with 0.1% SDS. Acellularized tendons were re-seeded in a suspension of human dermal fibroblasts. Attachment of viable cells to acellularized tendon was assessed biochemically by a cell viability assay and histologically by a live/dead stain. Data are reported as mean±standard deviation. RESULT: Compared with the DNA content of fresh tendons (551±212 ng DNA/mg tendon), only SDS treatments significantly decreased DNA content (1% SDS [202.8±37.4 ng DNA/mg dry weight tendon]; 0.1% SDS [189±104 ng DNA/mg tendon]). These findings were confirmed by histology. There was no decrease in glycosaminoglycans or collagen following acellularization with SDS. There was no difference in the ultimate tensile stress (55.3±19.2 [fresh] vs. 51.5±6.9 [0.1% SDS] MPa). Re-seeded tendons demonstrated attachment of viable cells to the tendon surface using a viability assay and histology. CONCLUSION: Human flexor tendons were acellularized with 0.1% SDS in 0.1% EDTA for 24 h with preservation of mechanical properties. Preservation of collagen and glycoaminoglycans and re-seeding with human cells suggest that this scaffold is biocompatible. This will provide a promising scaffold for future human flexor tendon tissue engineering studies to further assess biocompatibility through cell proliferation and in vivo studies.