A waterborne outbreak and detection of cryptosporidium oocysts in drinking water of an older high-rise apartment complex in seoul.

From May to June 2012, a waterborne outbreak of 124 cases of cryptosporidiosis occurred in the plumbing systems of an older high-rise apartment complex in Seoul, Republic of Korea. The residents of this apartment complex had symptoms of watery diarrhea and vomiting. Tap water samples in the apartment complex and its adjacent buildings were collected and tested for 57 parameters under the Korean Drinking Water Standards and for additional 11 microbiological parameters. The microbiological parameters included total colony counts, Clostridium perfringens, Enterococcus, fecal streptococcus, Salmonella, Shigella, Pseudomonas aeruginosa, Cryptosporidium oocysts, Giardia cysts, total culturable viruses, and Norovirus. While the tap water samples of the adjacent buildings complied with the Korean Drinking Water Standards for all parameters, fecal bacteria and Cryptosporidium oocysts were detected in the tap water samples of the outbreak apartment complex. It turned out that the agent of the disease was Cryptosporidium parvum. The drinking water was polluted with sewage from a septic tank in the apartment complex. To remove C. parvum oocysts, we conducted physical processes of cleaning the water storage tanks, flushing the indoor pipes, and replacing old pipes with new ones. Finally we restored the clean drinking water to the apartment complex after identification of no oocysts.

Adsorptive behavior of dimethylglyoxime on Au(111).

Dimethylglyoxime (DMG) adsorbed on Au(111) was investigated using electrochemical scanning tunneling microscopy (STM) and X-ray photoelectron spectroscopy (XPS). STM experiments revealed three different structures of adsorbed DMG at open circuit potential (~0.07 V versus Ag/AgCl): (2√3×2√3)R30°-α, (2√3×4√3)R30°-ß, and (2√3×4√3)R30°-γ. The coverage of adsorbed DMG obtained using XPS was 0.33. A combination of structural and quantitative information identified the adsorbed DMG as an anionic tetramer, held together by intermolecular hydrogen bonding and arrayed in three ordered patterns. Domains of adsorbed DMG underwent phase transitions between the observed structures, most likely due to the influence of the STM tip. However, a significant correlation between the observed structures and the imaging conditions was not found. The ordered layers existed only at open circuit potential as evidenced by their disappearance when the potential was shifted to 0.2 or -0.15 V. The ordered layers were also removed by immersion in a solution of Ni(2+), implying that the adsorbed DMG was converted to a soluble dimer complex with the Ni(2+) ion. This particular observation is discussed in terms of the rigidity of the organic network.

Preoxidation of CO on Os-modified Pt(111): a comparison with Ru-modified Pt(111).

The variation in CO adsorption structures during the preoxidation of CO on Os-modified Pt(111) (Pt(111)/Os) was investigated using cyclic voltammetry and electrochemical scanning tunneling microscopy. The spontaneous deposition of Os on Pt(111) resulted in randomly scattered islands with a coverage range of 0.13-0.54. During preoxidation on Pt(111)/Os, a phase transition from (2 × 2)-α to (√19 × âˆš19) via the transient structures of (2 × 2)-ß and (1 × 1) took place as on unmodified Pt(111). As the amount of Os increased, however, the transient structures of (2 × 2)-ß and (1 × 1) appeared at lower potentials with higher populations. When the population of the transient structures was greater than 50%, an oxidative CO stripping process took place to the structure of (√19 × âˆš19), completing the preoxidation. These observations strongly support the idea that the presence of Os increases the mobility of adsorbed CO by electronic modification of the Pt(111) surface (electronic effect). In addition, the results obtained with Pt(111)/Os were compared with those of Pt(111)/Ru.

Modification of Au nanoparticles dispersed on carbon support using spontaneous deposition of Pt toward formic acid oxidation.

This work presents formic acid oxidation on Pt deposits on Au nanoparticles dispersed on Vulcan XC-72R. The Pt deposits were produced using spontaneous deposition method contacting the Au nanoparticles with solutions containing Pt complex ions in various concentrations. The Pt deposits were characterized using CO stripping coulometry, X-ray photoelectron spectroscopy, and inductively coupled plasma atomic emission spectroscopy. When the Pt concentration is 10(-5)-10(-4) M, the Pt deposits are nanoislands of monatomic height. In the concentration range of 10(-4)-10(-3) M, the Pt deposits are most likely two-layer-thick nanofeatures. As Pt concentration increases further, the deposits become wider and thicker. Voltammetric behavior of Pt deposits reveals that on Pt deposits, dehydrogenation path is activated at the expense of poison-forming dehydration path. Furthermore, chronoamperometric measurement of the catalytic activity of Pt deposits supports that the two-layer-thick Pt deposits are most efficient in formic acid oxidation among the studied Pt deposits on Au nanoparticles. The enhancement factor of the particular Pt deposits is 2 in terms of turnover frequency, compared with a commercial Pt catalyst. Details are discussed in conjunction with Pt deposits on Au(111).