eDNA Adsorption onto Microplastics: Impacts of Water Chemistry and Polymer Physiochemical Properties.

Adsorption of biomacromolecules onto polymer surfaces, including microplastics (MPs), occurs in multiple environmental compartments, forming an ecocorona. Environmental DNA (eDNA), genetic material shed from organisms, can adsorb onto MPs which can potentially either (1) promote long-range transport of antibiotic resistant genes or (2) serve to gain insights into the transport pathways and origins of MPs by analyzing DNA sequences on MPs. However, little is known about the capacity of MPs to adsorb eDNA or the factors that influence sorption, such as polymer and water chemistries. Here we investigated the adsorption of extracellular linear DNA onto a variety of model MP fragments composed of three of the most environmentally prevalent polymers (polyethylene, polyethylene terephthalate, and polystyrene) in their pristine and photochemically weathered states. Batch adsorption experiments in a variety of water chemistries were complemented with nonlinear modeling to quantify the rate and extent of eDNA sorption. Ionic strength was shown to strongly impact DNA adsorption by reducing or inhibiting electrostatic repulsion. Polyethylene terephthalate exhibited the highest adsorption capacity when normalizing for MP specific surface area, likely due to the presence of ester groups. Kinetics experiments showed fast adsorption (majority adsorbed under 30 min) before eventually reaching equilibrium after 1-2 h. Overall, we demonstrated that DNA quickly binds to MPs, with pseudo-first- and -second-order models describing adsorption kinetics and the Freundlich model describing adsorption isotherms most accurately. These insights into DNA sorption onto MPs show that there is potential for MPs to act as vectors for genetic material of interest, especially considering that particle-bound DNA typically persists longer in the environment than dissolved DNA.

Design and Validation of Passive Environmental DNA Samplers Using Granular Activated Carbon and Montmorillonite Clay.

Environmental DNA (eDNA) analysis is gaining prominence as a tool for species and biodiversity monitoring in aquatic environments. eDNA shed by organisms is captured in grab samples, concentrated by filtration, extracted, and analyzed using molecular methods. Conventional capture and filtration methods are limited because (1) filtration does not capture all extracellular DNA, (2) eDNA can degrade during sample transport and storage, (3) filters often clog in turbid waters, reducing the eDNA captured, and (4) grab samples are time sensitive due to pulse eDNA inputs. To address these limitations, this work designs and validates Passive Environmental DNA Samplers (PEDS). PEDS consist of an adsorbent-filled sachet that is suspended in water to collect eDNA over time. Both extracellular and cellular DNA are captured, and the extracellular DNA is protected from degradation. The eDNA captured over time may be more representative than a grab sample. Two adsorbents, Montmorillonite Clay (MC) and Granular Activated Carbon (GAC), are tested. In laboratory experiments, MC-PEDS adsorbed five times more extracellular DNA and desorbed up to four times more than GAC-PEDS (despite high levels of eDNA loss during desorption). In microcosm and field experiments, GAC-PEDS captured over an order of magnitude more eDNA than MC-PEDS. Field results further validated PEDS as an effective eDNA capture method compared to conventional methods.

Development and validation of rapid environmental DNA (eDNA) detection methods for bog turtle (Glyptemys muhlenbergii).

Bog turtles (Glyptemys muhlenbergii) are listed as Species of Greatest Conservation Need (SGCN) for wildlife action plans in every state it occurs and multi-state efforts are underway to better characterize extant populations and prioritize restoration efforts. However, traditional sampling methods can be ineffective due to the turtle's wetland habitat, small size, and burrowing nature. Molecular methods, such as qPCR, provide the ability to overcome this challenge by effectively quantifying minute amounts of turtle DNA left behind in its environment (eDNA). Developing such methods for bog turtles has proved difficult partly because of the high sequence similarity between bog turtles and closely-related, cohabitating species, most often wood turtles (Glyptemys insculpta). Additionally, substrates containing bog turtle eDNA are often rich in organics or other substances that frequently inhibit both DNA extraction and qPCR amplification. Here, we describe the development and validation of a qPCR assay, BT3, targeting the mitochondrial cytochrome oxidase I gene that correctly identifies bog turtles with 100% specificity and sensitivity when tested on 201 blood samples collected from six species over a wide geographic range. We also developed a full-process internal control employing a genetically modified strain of Caenorhabditis elegans to improve DNA extraction methods, limit false negative results due to qPCR inhibition, and measure total DNA recovery from each sample. Using the internal control, we found that DNA recovery varied by over an order of magnitude between samples and likely explains the lack of bog turtle detection in some cases. Methods presented herein are highly-specific and may offer a more cost effective, non-invasive tool to supplement bog turtle population assessments in the Eastern United States. Poor or differential DNA recovery, which remains unmeasured in the vast majority of eDNA studies, significantly reduced the ability to detect bog turtle in their natural environment.