ABSTRACT
This paper presents a novel analog front-end for EMG sensor signal processing powered by 1 V. Such a low supply voltage requires specific design steps enabled using the 28 nm fully depleted silicon on insulator (FDSOI) technology from STMicroelectronics. An active ground circuit is implemented to keep the input common-mode voltage close to the analog ground and to minimize external interference. The amplifier circuit comprises an input instrumentation amplifier (INA) and a programmable-gain amplifier (PGA). Both are implemented in a fully differential topology. The actual performance of the circuit is analyzed using the corner and Monte Carlo analyses that comprise fifth-hundred samples for the global and local process variations. The proposed circuit achieves a high common-mode rejection ratio (CMRR) of 105.5 dB and a high input impedance of 11 GΩ with a chip area of 0.09 mm2.
ABSTRACT
This paper introduces a new current-controlled current-amplifier suitable for precise measurement applications. This amplifier was developed with strong emphasis on linearity leading to low total harmonic distortion (THD) of the output signal, and on linearity of the gain control. The presented circuit is characterized by low input and high output impedances. Current consumption is significantly smaller than with conventional quadratic current multipliers and is comparable in order to the maximum processed input current, which is ±200 µA. This circuit is supposed to be used in many sensor applications, as well as a precise current multiplier for general analog current signal processing. The presented amplifier (current multiplier) was designed by an uncommon topology based on linear sub-blocks using MOS transistors working in their linear region. The described circuit was designed and fabricated in a C035 I3T25 0.35-µm ON Semiconductor process because of the demand of the intended application for higher supply voltage. Nevertheless, the topology is suitable also for modern smaller CMOS technologies and lower supply voltages. The performance of the circuit was verified by laboratory measurement with parameters comparable to the Cadence simulation results and presented here.
ABSTRACT
In this paper, a second-order asynchronous delta-sigma modulator (ADSM) is proposed based on the active-RCintegrators. The ADSM is implemented in the 0.18 µ m CMOS Logic or Mixed-Signal/RF, General Purpose process from the Taiwan Semiconductor Manufacturing Company with a center frequency of 848 kHz at a supply voltage of 1 V with a 92 dB peak signal-to-noise and distortion ratio ( S N D R ), which corresponds to 15 bit resolution. These parameters were achieved in all the endogenous bioelectric signals bandwidth of 10 kHz. The ADSM dissipated 295 µ W and had an area of 0.54 mm 2 . The proposed ADSM with a high resolution, wide bandwidth, and rail-to-rail input voltage range provides the universal solution for endogenous bioelectric signal processing.
Subject(s)
Semiconductors , Signal Processing, Computer-Assisted , Signal-To-Noise Ratio , TaiwanABSTRACT
This paper presents a compact and simple design of adjustable triangular and square wave functional generators employing fundamental cells fabricated on a single integrated circuit (IC) package. Two solutions have electronically tunable repeating frequency. The linear adjustability of repeating frequency was verified in the range between 17 and 264 kHz. The main benefits of the proposed generator are the follows: A simple adjustment of the repeating frequency by DC bias current, Schmitt trigger (threshold voltages) setting by DC driving voltage, and output levels in hundreds of mV when the complementary metal-oxide semiconductor (CMOS) process with limited supply voltage levels is used. These generators are suitable to provide a simple conversion of illuminance to frequency of oscillation that can be employed for illuminance measurement and sensing in the agriculture applications. Experimental measurements proved that the proposed concept is usable for sensing of illuminance in the range from 1 up to 500 lx. The change of illuminance within this range causes driving of bias current between 21 and 52 µA that adjusts repeating frequency between 70 and 154 kHz with an error up to 10% between the expected and real cases.
