ABSTRACT
Wood pellets are an important source of renewable energy. Their mechanical strength is a crucial property. In this study, the tensile strength of pellets made from oak, pine, and birch sawdust with moisture contents of 8% and 20% compacted at 60 and 120 MPa was determined in a diametral compression test. The highest tensile strength was noted for oak and the lowest for birch pellets. For all materials, the tensile strength was the highest for a moisture content of 8% and 120 MPa. All pellets exhibited a ductile breakage mode characterised by a smooth and round stress-deformation relationship without any sudden drops. Discrete element method (DEM) simulations were performed to check for the possibility of numerical reproduction of pelletisation of the sawdust and then of the pellet deformation in the diametral compression test. The pellet breakage process was successfully simulated using the DEM implemented with the bonded particle model. The simulations reproduced the results of laboratory testing well and provided deeper insight into particle-particle bonding mechanisms. Cracks were initiated close to the centre of the pellet and, as the deformation progressed, they further developed in the direction of loading.
ABSTRACT
Starch agglomerates are widely applied in the pharmaceutical, agricultural, and food industries. The formation of potato starch tablets and their diametral compression were simulated numerically and verified in a laboratory experiment to analyse the microscopic mechanisms of the compaction and the origins of their breakage strength. Discrete element method (DEM) simulations were performed using EDEM software. Samples comprised of 120,000 spherical particles with radii normally distributed in the range of 5-36 µm were compacted in a cylindrical die with a diameter of 2.5 cm. The linear elastic-plastic constitutive contact model with a parallel bonded-particle model (BPM) was used to model the diametral compression. DEM simulations indicated that the BPM, together with the linear elastic-plastic contact model, could describe the brittle, semi-brittle, or ductile breakage mode, depending on the ratio of the strength to Young's modulus of the bond and the bond-to-contact elasticity ratio. Experiments confirmed the findings of the DEM simulations and indicated that potato starch (PS) agglomerates can behave as a brittle, semi-brittle, or ductile material, depending on the applied binder. The PS agglomerates without any additives behaved as a semi-brittle material. The addition of 5% of ground sugar resulted in the brittle breakage mode. The addition of 5% gluten resulted in the ductile breakage mode.
ABSTRACT
The idea of sustainable development assumes that natural resources must be treated as limited goods and that waste must be managed rationally. This idea and the constant striving to reduce production costs make the use of waste materials as substitutes for traditionally used raw materials from non-renewable sources increasingly popular. In cement concrete technology, there are many possibilities to use waste as components of mortars and concretes. The subject of this paper is a fine-grained material, obtained as a by-product during the preparation of aggregate for mineral-asphalt mixtures. The aim of the research was to test the suitability of the selected type of powder, namely limestone powder, as a component of cement composites. The paper presents an evaluation of the potential of using the limestone powder as a substitute for the fine aggregate, focusing on the impact of such a modification on aspects of durability. The sulfate degradation and chloride ion diffusion in concrete were investigated. The overall desirability function has been determined. It was demonstrated that the satisfactory value of the general desirability can be attributed to most of the investigated concretes. Positive test results support the potential of replacing part of natural fine aggregate with the tested waste limestone dust without a negative impact on the durability of concrete.
