ABSTRACT
The Institute for Reference Materials and Measurements operates a 7.0 MV Van de Graaff accelerator to generate monoenergetic neutron radiation for experimental applications. Owing to increased intensities of generated neutron fields and the more stringent regulation related to the maximum dose for the public, a concrete shielding wall surrounding the experimental building was constructed. This paper presents a study aiming at evaluating the effect of the shielding on the neutron field outside the wall. For this purpose, the following measurements were carried out around the building: (1) cartography of the neutron field for different experimental conditions; (2) measurement of neutron spectra using multiple Bonner spheres; (3) activation measurements using gold discs followed by low-level gamma spectrometry. From the measurements, it can be concluded that the wall fulfils its purpose to reduce the neutron dose rate to the surrounding area to an acceptable level.
Subject(s)
Air Pollution, Indoor/analysis , Neutrons , Occupational Exposure/analysis , Particle Accelerators , Radiation Protection/instrumentation , Risk Assessment/methods , Thermoluminescent Dosimetry/methods , Body Burden , Environmental Monitoring/instrumentation , Environmental Monitoring/methods , Equipment Design , Equipment Failure Analysis/methods , Humans , Maximum Allowable Concentration , Quality Assurance, Health Care/methods , Radiation Dosage , Radiation Protection/methods , Relative Biological Effectiveness , Reproducibility of Results , Risk Factors , Safety Management/methods , Sensitivity and Specificity , Thermoluminescent Dosimetry/instrumentationABSTRACT
As a result of the introduction of the ICRP 60 recommendations and the increasing contribution of the neutron dose to the total dose of the personnel at the Belgonucleaire Mox fuel fabrication plant, the BD-PND bubble detector manufactured by Bubble Technology industries was introduced as a new, reliable personal neutron dosimeter. In the framework of the evaluation program of the bubble detector, measurements and calculations of the neutron spectra in the installations of the fuel fabrication plant were performed. The measurements were carried out with a ROSPEC neutron spectrometer, and the calculations were performed by means of the Monte Carlo code MCNP 4A. Comparison between measurements and calculations revealed good agreement. On the basis of the obtained neutron spectra, a correction factor was determined to take into account the new ICRP 60 recommendations and the difference between the calibration spectrum of the bubble detectors and the observed neutron spectra at the plant. This correction factor was applied to the calibration factor provided by Bubble Technology Industries.
