Starch Sodium Octenylsuccinate as a New Type of Stabilizer in the Synthesis of Catalytically Active Gold Nanostructures.

Here, starch derivatives, i.e., sodium starch octenylsuccinate (OSA starch, hereinafter referred to as OSA), were employed as both reducing and stabilizing agents for the unique, inexpensive, and simple synthesis of gold nanoparticles (OSA-AuNPs) in an aqueous solution with gold salt. The obtained OSA-AuNPs were characterized by UV-vis spectrophotometry, transmission electron microscopy, scanning electron microscopy, and energy-dispersive X-ray spectroscopy. The catalytic activity of the obtained gold colloids was studied in the reduction of organic dyes, including methylene blue (C.I. Basic Blue 9) and rhodamine B (C.I. Basic Violet 10), and food coloring, including tartrazine (E102) and azorubine (E122), by sodium borohydride. Moreover, OSA-AuNPs were utilized as signal amplifiers in surface-enhanced Raman spectroscopy. The obtained results confirmed that gold nanoparticles can be used as effective catalysts in reduction reactions of selected organic dyes, as well as signal enhancers in the SERS technique.

Influence of Modified Starch Admixtures on Selected Physicochemical Properties of Cement Composites.

The conducted research aimed to evaluate the influence of admixtures of various modified starches on the rheological properties of cement composites and their influence on the compressive strength of hardened cement mortars. The study involved 17 different modified starch admixtures. Using a rheometer, the values of viscosity and tangential stresses were determined depending on the shear rate, and were subsequently used to determine the yield point and plastic viscosity of cement slurries. The next parameters tested were the flow of fresh cement slurry and the compressive strength of hardened cement composite. The highest fluidisation was recorded for retentate LU-1420-0.5%Ac-R, an increase of 82%. The conducted tests led to the conclusion that admixing cement composites with modified starches changes the rheological parameters and the compressive strength of cement composites. The highest strength gains occurred for the admixtures of retentate LU-1412-R (increase of 25%). Declines in compressive strength were noticed in the retentate LU-1422-R (decrease by 13%) and the retentate OSA-2.5%-R (decrease of 17%). The admixture of starch hydrolysate significantly decreases the yield point of slurries, which in turn may contribute to the fluidisation of concrete mixes and the reduction of mixing water. The lowest values were obtained for retentates LU-1420-0.5%Ac-R (decrease of 94%), and LU-1412-R (decrease of 93%). It was found that the consistency and compressive strength of cement mortars are affected by both the type of modification and the length of the chemical chain of starch.

Unexpected cytosine-AuCl4- interaction under electrospray ionization mass spectrometry conditions-Formation of cytosine-Au(I) complexes.

The interaction of cytosine with AuCl4-, under electrospray ionization mass spectrometric conditions, is discussed. On the basis of respective full scan mass spectra and product ion spectra, obtained in positive and negative ion mode, it has been deduced that cytosine is very prone to form Au(I)-containing complexes. The complexes may be formed in the gas phase by decomposition of Au(III)-containing complexes and also in the electrospray ionization source as a result of the occurrence of redox process. It has also been found that the interaction of cytosine with Au+ is stronger than that with Cu+ or Ag+, although taking into account the electrostatic attraction, it is not expected.

Synthesis of dextrin-stabilized colloidal silver nanoparticles and their application as modifiers of cement mortar.

Various commercial dextrins were used as reducing and stabilizing agents for a novel one-step synthesis of silver nanoparticles from ammonia complexes of silver ions. As a result, stable colloids of silver were formed during the reaction with the particle size being the function of the dextrin type. The obtained colloids were characterized by UV-vis spectrophotometry, size distribution (using Non-Invasive Backscatter optics) and transmission electron microscopy (TEM). The achieved results clearly indicate the possibility of low-cost production of large quantities of colloidal silver nanoparticles using materials derived from renewable sources. The resulting silver colloids can be used for different purposes, e.g. as bactericidal agents. Combination of the aforementioned properties of nanosilver particles with plasticizing properties of dextrin enables to obtain cement mortars with increased workability and enhanced compressive strength. Moreover, the obtained material is also characterized by increased immunity to adverse impact of microorganisms.

Lignosulfonate-stabilized selenium nanoparticles and their deposition on spherical silica.

We report a novel room-temperature synthesis of selenium nanoparticles, which for the first time uses lignosulfonate as a stabilizer. Various lignosulfonates obtained both from hardwood and softwood were tested. Selenium oxide was used as the precursor of zero-valent selenium. Three different reducers were tested - sodium borohydride, hydrazine and ascorbic acid - and the latter proved most effective in terms of the particle size and stability of the final colloid. The lignosulfonate-stabilized selenium nanoparticles had a negative zeta potential, dependent on pH, which for some lignosulfonates reached -50mV, indicating the excellent stability of the colloid. When spherical silica particles were introduced to the synthesis mixture, selenium nanoparticles were deposited on their surface. Additionally, star-like structures consisting of sharp selenium needles with silica cores were observed. After drying, the selenium-functionalized silica had a grey metallic hue. The method reported here is simple and cost-effective, and can be used for the preparation of large quantities of selenium colloids or the surface modification of other materials with selenium.

Functionalization of organically modified silica with gold nanoparticles in the presence of lignosulfonate.

It is shown that lignosulfonate (LS) can be used as an effective reducing agent for gold ions and simultaneously as a stabilizing agent for gold nanoparticles (AuNPs). When organically modified silica is introduced to the reaction mixture, most of the AuNPs grow on the surface of the silica due to hydrophobic interactions between LS and organic layers covering the solid particles. It was also found that the structure of the organic layer is crucial for the effective deposition of gold nanoparticles onto silica spheres in terms of particle size and gold content in the final SiO2-LS-AuNPs composites. Due to the hydrophobicity of the modified silica it was necessary to carry out the modification in mixed organic/aqueous solvent. The polarity of the organic co-solvent was found to have an effect on the size of the deposited Au-NPs and their quantity. The physical appearance of the obtained hybrids was analyzed by colorimetry, and their structure and composition were evaluated using transmission electron microscopy (TEM). Additionally dispersive and thermal properties were examined by dynamic light scattering (DLS) and thermogravimetry (TG), respectively. The obtained multifunctional hybrid materials exhibits remarkable catalytic activity for the reduction of C.I. Basic Blue 9 (Methylene Blue) by borohydride.

Physicochemical properties of cross-linked and acetylated starches and products of their hydrolysis in continuous recycle membrane reactor.

The aim of the present work was to study the physicochemical properties of doubly modified, by cross-linking and acetylating, starches as well as the products of their enzymatic hydrolysis. A two step procedure of hydrolysis, including the batch and membrane reactors, were investigated. The second step of enzymatic processes were carried out in a continuous recycle membrane reactor (CRMR). Three kinds of commercial starches--two preparations of acetylated distarch adipate E1422 of different degrees of cross-linking, as well as one preparation of acetylated distarch phosphate E1414 were examined. It was found that the degree of substitution of acetyl groups in the macromolecules of starch did not influence the effectiveness of hydrolysis. However, the degree of cross-linking with adipate groups slightly decreased the efficiency of processing in the CRMR. Additionally, the relationship between the type of hydrocolloid and its adsorption activity in the air/water and oil/water systems was considered. All obtained derivatives revealed adsorption properties and reduced the surface/interface tension in the air/water and oil/water systems. The efficiency and effectiveness of adsorption of the investigated hydrocolloids were affected by the type of modification as well as the degree of substitution of acetyl groups in the macromolecules of starch. Particle size distributions formed in aqueous solutions for all investigated hydrolyses were determined and compared with results obtained for commercial products.