Measurement and interpretation of electrokinetic phenomena.

In this report, the status quo and recent progress in electrokinetics are reviewed. Practical rules are recommended for performing electrokinetic measurements and interpreting their results in terms of well-defined quantities, the most familiar being the zeta-potential or electrokinetic potential. This potential is a property of charged interfaces and it should be independent of the technique used for its determination. However, often the zeta-potential is not the only property electrokinetically characterizing the electrical state of the interfacial region; the excess conductivity of the stagnant layer is an additional parameter. The requirement to obtain the zeta-potential is that electrokinetic theories be correctly used and applied within their range of validity. Basic theories and their application ranges are discussed. A thorough description of the main electrokinetic methods is given; special attention is paid to their ranges of applicability as well as to the validity of the underlying theoretical models. Electrokinetic consistency tests are proposed in order to assess the validity of the zeta-potentials obtained. The recommendations given in the report apply mainly to smooth and homogeneous solid particles and plugs in aqueous systems; some attention is paid to nonaqueous media and less ideal surfaces.

Thinning of wetting films formed from aqueous solutions of non-ionic surfactant.

We investigated the thinning of wetting films formed from aqueous solution of non-ionic triblock copolymer Pluronic F127 on the surface of silica using a home-made thin film balance and time-resolved ellipsometry. Imaging ellipsometry was used to visualize the film structures at subsequent stages of their development. The results unambiguously show that the time required for the formation of steady films strongly depends on the electrolyte concentration. When increasing the latter from 10(-4) to 0.1 M, this time typically increases with several orders of magnitude, from a few minutes to several hours. Moreover, for sufficiently large amounts of salt, two characteristic relaxation regimes can be clearly identified. After initial quick thinning, further thinning slows down enormously. These typical kinetic regimes are thought to result from the coupled dependencies of the bulk and interfacial properties of F127 on salt concentration. Possible explanations of the phenomenon are discussed.

Confinement-induced symmetry breaking of interfacial surfactant layers.

Interaction forces between mesoscopic objects are fundamental to soft-condensed matter and are among the prime targets of investigation in colloidal systems. Surfactant molecules are often used to tailor these interactions. The forces are experimentally accessible and for a first theoretical analysis one can make use of a parallel-plate geometry. We present molecularly realistic self-consistent field calculations for an aqueous nonionic surfactant solution near the critical micellization concentration, in contact with two hydrophobic surfaces. The surfactants adsorb cooperatively, and form a monolayer onto each surface. At weak overlap the force increases with increasing compression of the monolayers until suddenly a symmetry braking takes place. One of the monolayers is removed jump-like and as the remaining monolayer can relax, some attraction is observed, which gives way to repulsion at further confinement. The restoring of symmetry at strong confinement occurs as a second-order transition and the force jumps once again from repulsion to attraction. It is anticipated that the metastable branch of the interaction curve will be probed in a typical force experiment. Under normal conditions pronounced hysteresis in the surface force is predicted, without the need to change the adsorbed amount jump-like.

Modeling of confinement-induced phase transitions for surfactant layers on amphiphilic surfaces.

A self-consistent field model is used to consider a solution of positively charged surfactants up to its critical micellization concentration adsorbing onto two surfaces in close proximity. Each surface mimics a polystyrene sulfonate interface; that is, hydrophobic properties are combined with a (fixed) negative charge. We observe large and sudden changes in adsorption as a function of separation, which are not normally considered when interpreting surface force measurements. The parameters are chosen such that the adsorbed surfactant layer is of a monolayer type when the surfaces are far apart. A typical interaction curve is presented for a fixed surfactant chemical potential, which is extracted from the set of adsorption isotherms each with a fixed slit width. When the slit width approaches the thickness of the two surfactant layers, a first-order phase transition takes place, which is driven by the unfavorable hydrophobic-water contacts. At the transition, the average orientation of the surfactants switches from a high concentration of tails at the surface to a bilayer configuration where tail profiles from both sides merge in the center. The headgroups are pulled slightly away from the surface. The interaction force jumps from a weak electrostatic repulsion at large distances (two effectively positively charged surface layers repel each other) to a strong electrostatic attraction at short distances (the central surfactant bilayer is attracted to the oppositely charged surfaces). The amount of adsorbed surfactants tend to decrease with decreasing distance between the surfaces but suddenly increases at the transition. Because of this, we anticipate that in surface force experiments, for example, there is a hysteresis associated with this transition: the forces and also the adsorbed amounts depend not only on the distance between the surfaces but also on the history if nonsufficient equilibration times are implemented.

Confinement-induced phase transition and hysteresis in colloidal forces for surfactant layers on hydrophobic surfaces.

In this paper we consider surfactant solutions near a pair of interfaces. It is well-known that strong lateral interactions between surfactant molecules give rise to a step in the adsorption isotherm. In a self-consistent field theory, such a step in the adsorbed amount shows up as a van der Waals loop. The consequence of such a loop for surface force experiments is analyzed. From adsorption isotherms at fixed confinement we extract the relevant adsorbed amounts for a fixed chemical potential as a function of the confinement. A cusped structure is found for the relation between the interaction energy and the slit width: there is a confinement-induced first-order phase transition. The corresponding interaction curve has a kink at the binodal slit distance. Metastable branches as well as an unstable branch (bracketed by the two spinodal points) are presented. The metastability is expected to give rise to force hysteresis in, e.g., atomic force microscope or surface force apparatus experiments, distinctly different from those due to mechanical instabilities of the cantilever system.

Influence of NaCl on the behavior of PEO-PPO-PEO triblock copolymers in solution, at interfaces, and in asymmetric liquid films.

The solution behavior of the polymeric surfactant Pluronic F127 (PEO(99)PPO(65)PEO(99)) and its adsorption behavior on aqueous-silica and aqueous-air interfaces, as well as the disjoining pressure isotherms of asymmetric films (silica/aqueous film/air) containing F127, are studied. The interfacial properties of adsorbed F127 layers (the adsorbed amount Gamma and the thickness h) as well as the aqueous wetting film properties [film thickness (h) and refractive indexes] were studied via ellipsometry. The solution properties of F127 were investigated using surface tensiometry and light scattering. The interactions between the air-water and silica-water interfaces were measured with a thin film pressure balance technique (TFB) and interpreted in terms of disjoining pressure as a function of the film thickness. The relations between the behaviors of the asymmetric films, adsorption at aqueous air, and aqueous silica interfaces and the solution behavior of the polymeric surfactant are discussed. Special attention is paid to the influence of the concentrations of F127 and NaCl. Addition of electrolyte lowers the critical micelle concentration, diminishes adsorption on silica, and increases the thickness of the asymmetric film.

Mixed adsorption of poly(vinylpyrrolidone) and sodium dodecylbenzenesulfonate on kaolinite.

The mixed adsorption of the nonionic polymer poly(vinylpyrrolidone) (PVP) and the anionic surfactant sodium dodecylbenzenesulfonate (SDBS) on kaolinite has been studied. Both components adsorb from their mixture onto the clay mineral. The overall adsorption process is sensitive to the pH, the electrolyte concentration, and the amounts of polymer and surfactant. Interpretation of the experimental data addresses also the patchwise heterogeneous nature of the clay surface. In the absence of PVP, SDBS adsorbs on kaolinite by electrostatic and hydrophobic interactions. However, when PVP is present, surfactant adsorption at 10(-2) M NaCl is mainly driven by charge compensation of the edges. The adsorption of PVP from the mixture shows similar behavior under different conditions. Three regions can be distinguished based on the changing charge of polymer-surfactant complexes in solutions with increasing SDBS concentration. At low surfactant content, PVP adsorbs by hydrogen bonding and hydrophobic interactions, whereas electrostatic interactions dominate at higher surfactant concentrations. Over the entire surfactant concentration range, polymer-surfactant aggregates are present at the edges. The composition of these surface complexes differs from that in solution and is controlled by the surface charge.

Microflotation Suppression and Enhancement Caused by Particle/Bubble Electrostatic Interaction.

The processes of attachment and detachment of small or medium-sized particles to relatively large bubbles during microflotation are considered in terms of the heterocoagulation theory. Calculations are made for the conditions that the surface potentials are of similar sign and constant, that one of the surface potentials is small, that hydrophobic attraction is absent, and that there are no surface deformations. Under these conditions bubble-particle aggregates may form as a result of an electrostatic attraction which exceeds the repulsive van der Waals force at intermediate distances. Next to electrostatic and van der Waals forces, hydrodynamic and gravitational forces are considered. These forces may overcome the electrostatic repulsion at large distances and promote particle bubble attachment. Strong electrostatic attraction at small distances, arising at a large difference of the surface potentials of the bubble and the particle and of low electrolyte concentrations, can prevent subsequent detachment by hydrodynamic and gravitational forces. With increasing electrolyte concentration the electrostatic barrier increases and the attractive electrostatic force diminishes. As a result, a critical electrolyte concentration for microflotation exists. Above this concentration attachment may still occur but it is followed by detachment. At lower electrolyte concentrations the electrostatic attractive force prevents the detachment. The dependence of the critical electrolyte concentration on the values of the bubble and particle potentials and the Hamaker constant is calculated. The critical concentration does not depend on particle or bubble size if the absolute values of the total detachment force and the total pressing force coincide, which is the case for Stokes and potential flow. For every electrolyte concentration lower than the critical value there are two critical particle sizes that limit the flotation possibility. For small particle sizes attachment is impossible because the pressing force is smaller than the electrostatic barrier. For large particle sizes detachment cannot be prevented because the detachment force exceeds the maximum electrostatic attraction. A microflotation domain of intermediate particle sizes exists in which irreversible heterocoagulation occurs. Copyright 2001 Academic Press.

The effect of polyethylene oxide molecular weight on determination of its concentration in aqueous solutions.

The influence of the molecular weight of polyethylene oxide (PEO) on the results from several methods for determining its concentration in aqueous solutions has been investigated. Modified versions of the complexation reactions of PEO with molybdophosphoric acid and with tetraiodobismuthate give results that are independent of molecular-weight effects for the range ca. 400-10(6). The reaction with KBiI(4) is the less accurate. Oxidative digestion is also independent of molecular-weight, but impurities easily obscure the measurements. Other methods studied included interferometry, viscometry, and complexation with tannic acid. Interferometry and the reaction with tannic acid were only independent of molecular-weight for M > 4000. With viscometry very poor results were obtained.