Montmorillonite Membranes with Tunable Ion Transport by Controlling Interlayer Spacing.

Membranes incorporating two-dimensional (2D) materials have shown great potential for water purification and energy storage and conversion applications. Their ordered interlayer galleries can be modified for their tunable chemical and structural properties. Montmorillonite (MMT) is an earth-abundant phyllosilicate mineral that can be exfoliated into 2D flakes and reassembled into membranes. However, the poor water stability and random interlayer spacing of MMT caused by weak interlamellar interactions pose challenges for practical membrane applications. Herein, we demonstrate a facile approach to fabricating 2D MMT membranes with alkanediamines as cross-linkers. The incorporation of diamine molecules of different lengths enables controllable interlayer spacing and strengthens interlamellar connections, leading to tunable ion transport properties and boosted membrane stability in aqueous environments.

Lead lanthanum zirconate titanate ceramic thin films for energy storage.

An acetic-acid-based sol-gel method was used to deposit lead lanthanum zirconate titanate (PLZT, 8/52/48) thin films on either platinized silicon (Pt/Si) or nickel buffered by a lanthanum nickel oxide buffer layer (LNO/Ni). X-ray diffraction and scanning electron microscopy of the samples revealed that dense polycrystalline PLZT thin films formed without apparent defects or secondary phases. The dielectric breakdown strength was greater in PLZT thin films deposited on LNO/Ni compared with those on Pt/Si, leading to better energy storage. Finally, optimized dielectric properties were determined for a 3-µm-thick PLZT/LNO/Ni capacitor for energy storage purposes: DC dielectric breakdown strength of ∼1.6 MV/cm (480 V), energy density of ∼22 J/cc, energy storage efficiency of ∼77%, and permittivity of ∼1100. These values are very stable from room temperature to 150 °C, indicating that cost-effective, volumetrically efficient capacitors can be fabricated for high-power energy storage.

Sectioning of multilayers to make a multilayer Laue lens.

We report a process to fabricate multilayer Laue lenses (MLL's) by sectioning and thinning multilayer films. This method can produce a linear zone plate structure with a very large ratio of zone depth to width (e.g., >1000), orders of magnitude larger than can be attained with photolithography. Consequently, MLL's are advantageous for efficient nanofocusing of hard x rays. MLL structures prepared by the technique reported here have been tested at an x-ray energy of 19.5 keV, and a diffraction-limited performance was observed. The present article reports the fabrication techniques that were used to make the MLL's.