Adsorption of ß-casein-surfactant mixed layers at the air-water interface evaluated by interfacial rheology.

This work presents a detailed study of the dilational viscoelastic moduli of the adsorption layers of the milk protein ß-casein (BCS) and a surfactant at the liquid/air interface, over a broad frequency range. Two complementary techniques have been used: a drop profile tensiometry technique and an excited capillary wave method, ECW. Two different surfactants were studied: the nonionic dodecyldimethylphosphine oxide (C12DMPO) and the cationic dodecyltrimethylammonium bromide (DoTAB). The interfacial dilational elasticity and viscosity are very sensitive to the composition of protein-surfactant mixed adsorption layers at the air/water interface. Two different dynamic processes have been observed for the two systems studied, whose characteristic frequencies are close to 0.01 and 100 Hz. In both systems, the surface elasticity was found to show a maximum when plotted versus the surfactant concentration. However, at frequencies above 50 Hz the surface elasticity of BCS + C12DMPO is higher than the one of the aqueous BCS solution over most of the surfactant concentration range, whereas for the BCS + DoTAB it is smaller for high surfactant concentrations and higher at low concentrations. The BCS-surfactant interaction modifies the BCS random coil structure via electrostatic and/or hydrophobic interactions, leading to a competitive adsorption of the BCS-surfactant complexes with the free, unbound surfactant molecules. Increasing the surfactant concentration decreases the adsorbed proteins. However, the BCS molecules are rather strongly bound to the interface due to their large adsorption energy. The results have been fitted to the model proposed by C. Kotsmar et al. ( J. Phys. Chem. B 2009 , 113 , 103 ). Even though the model describes well the concentration dependence of the limiting elasticity, it does not properly describe its frequency dependence.

Stabilization of superparamagnetic iron oxide nanoclusters in concentrated brine with cross-linked polymer shells.

Iron oxide nanoparticles, in the form of sub-100-nm clusters, were synthesized in the presence of poly(acrylic acid) (PAA) or poly(styrene sulfonate-alt-maleic acid) (PSS-alt-MA) to provide electrosteric stabilization. The superparamagnetic nanoclusters were characterized using a superconducting quantum interference device (SQUID), transmission electron microscopy (TEM), dynamic light scattering (DLS), thermogravimetric analysis (TGA), and zeta potential measurements. To anchor the polymer shell on the nanoparticle surface, the polymer was cross-linked for a range of cross-linking densities. For nanoclusters with only 12% (w/w) PSS-alt-MA, electrosteric stabilization was sufficient even in 8 wt % NaCl. For PAA, the cross-linked polymer shell was essentially permanent and did not desorb even upon dilution of the nanoparticles for iron oxide concentrations down to 0.014 wt %. Without cross-linking, over half of the polymer desorbed from the particle surfaces. This general approach of the adsorption of polymer stabilizers onto nanoparticles followed by cross-linking may be utilized for a wide variety of cross-linkable polymers without the need to form covalent bonds between the nanoparticles and polymer stabilizer. Thus, this cross-linking approach is an efficient and inexpensive method of stabilizing nanoparticles for large-scale applications, including the electromagnetic imaging of subsurface reservoirs, even at high salinity.

From surfactant adsorption kinetics to asymmetric nanomembrane mechanics: pendant drop experiments with subphase exchange.

Adsorption equilibrium is the state in which the chemical potential of each species in the interface and bulk is the same. Dynamic phenomena at fluid-fluid interfaces in the presence of surface active species are often probed by perturbing an interface or adjoining bulk phase from the equilibrium state. Many methods designed for studying kinetics at fluid-fluid interfaces focus on removing the system from equilibrium through dilation or compression of the interface. This modifies the surface excess concentration Γ(i) and allows the species distribution in the bulk C(i) to respond. There are only a few methods available for studying fluid-fluid interfaces which seek to control C(i) and allow the interface to respond with changes to Γ(i). Subphase exchange in pendant drops can be achieved by the injection and withdrawal of liquid into a drop at constant volumetric flow rate R(E) during which the interfacial area and drop volume V(D) are controlled to be approximately constant. This can be accomplished by forming a pendant drop at the tip of two coaxial capillary tubes. Although evolution of the subphase concentration C(i)(t) is dictated by extrinsic factors such as R(E) and V(D), complete subphase exchange can always be attained when a sufficient amount of liquid is used. This provides a means to tailor driving forces for adsorption and desorption in fluid-fluid systems and in some cases, fabricate interfacial materials of well-defined composition templated at these interfaces. The coaxial capillary pendant drop (CCPD) method opens a wide variety of experimental possibilities. Experiments and theoretical frameworks are reviewed for the study of surfactant exchange kinetics, macromolecular adsorption equilibrium and dynamics, as well as the fabrication of a wide range of soft surface materials and the characterization of their mechanics. Future directions for new experiments are also discussed.

Superparamagnetic nanoclusters coated with oleic acid bilayers for stabilization of emulsions of water and oil at low concentration.

Emulsions of water and dodecane with drop sizes down to 1 microm were stabilized with 30-100 nm interfacially active nanoclusters of sub-15 nm iron oxide primary particles at an extremely low loading of 0.14 wt.%. The nanoclusters, coated with a bilayer of oleic acid, formed stable dispersions in water at pH 7-10. The phase behavior and droplet morphologies of the emulsions of water and dodecane were tuned with pH. The oil/water emulsions at pH 9-10 were converted to middle phase emulsions at pH 6-7 and water/oil emulsions as the pH was further lowered. The magnetization per gram of Fe is similar for the nanoclusters and the primary particles, indicating the spacing between the particles is sufficient to avoid magnetic coupling. The larger volume of nanoclusters relative to the individual primary particles is beneficial for magnetomotive sensing applications including imaging of oil reservoirs, as it increases the force on the particles for a given magnetic field.