ABSTRACT
Natural products are increasingly in demand in dermatology and cosmetology. In the present study, highly valuable supercritical CO2 (sCO2) extracts rich in bioactive compounds with antiradical and antibacterial activity were obtained from the inflorescences of industrial hemp. Volatile compounds were analyzed by gas chromatography in tandem with mass spectrometry (GC-MS), while cannabinoids were determined by high performance liquid chromatography (HPLC-DAD). Extraction yields varied from 0.75 to 8.83%, depending on the pressure and temperature applied. The extract obtained at 320 bar and 40 °C with the highest content (305.8 µg mg-1) of cannabidiolic acid (CBDA) showed the best antiradical properties. All tested extract concentrations from 10.42 µg mL-1 to 66.03 µg mL-1 possessed inhibitory activities against E. coli, P. aeruginosa, B. subtilis, and S. aureus. The sCO2 extract with the highest content of cannabidiol (CBD) and rich in α-pinene, ß-pinene, ß-myrcene, and limonene was the most effective. The optimal conditions for sCO2 extraction of cannabinoids and volatile terpenes from industrial hemp were determined. The temperature of 60 °C proved to be optimal for all responses studied, while the pressure showed a different effect depending on the compounds targeted. A low pressure of 131.2 bar was optimal for the extraction of monoterpenes, while extracts rich in sesquiterpenes were obtained at 319.7 bar. A high pressure of 284.78 bar was optimal for the extraction of CBD.
ABSTRACT
Alchemilla vulgaris L. is a good source of antioxidant components with an emphasis on phenolic acids and tannins. In this study, gallic acid, ellagic acid, and hydrolyzable tannins (HT) were extracted from this plant with different deep eutectic solvents (DESs), varying the amount of added H2O, temperature and extraction time. Seventeen DESs (n = 3) were used for the extraction, of which choline chloride:urea (1:2) proved to be the most suitable. The selection of the best solvent was followed by the examination of the influence of the extraction type and parameters using response surface methodology (RSM). Gallic acid content was in the range of 0.00-1.89 µg mg-1, ellagic acid content was 0.00-12.76 µg mg-1 and hydrolyzable tannin (HT) content was 3.06-181.26 µgTAE mg-1, depending on the used technique and the extraction conditions. According to the results, extraction by stirring and heating was the most suitable since the highest amounts of gallic acid, ellagic acid, and HT were extracted, and the obtained optimal values using response surface methodology (RSM) are confirmed by experimentally obtained values.
