ABSTRACT
The currently studied materials considered as potential candidates to be solid electrolytes for Li-ion batteries usually suffer from low total ionic conductivity. One of them, the NASICON-type ceramic of the chemical formula Li1.3Al0.3Ti1.7(PO4)3, seems to be an appropriate material for the modification of its electrical properties due to its high bulk ionic conductivity of the order of 10-3 Sâcm-1. For this purpose, we propose an approach concerning modifying the grain boundary composition towards the higher conducting one. To achieve this goal, Li4SiO4 was selected and added to the LATP base matrix to support Li+ diffusion between the grains. The properties of the Li1.3Al0.3Ti1.7(PO4)3-xLi4SiO4 (0.02 ≤ x ≤ 0.1) system were studied by means of high-temperature X-ray diffractometry (HTXRD); 6Li, 27Al, 29Si, and 31P magic angle spinning nuclear magnetic resonance spectroscopy (MAS NMR); thermogravimetry (TG); scanning electron microscopy (SEM); and impedance spectroscopy (IS) techniques. Referring to the experimental results, the Li4SiO4 additive material leads to the improvement of the electrical properties and the value of the total ionic conductivity exceeds 10-4 Sâcm-1 in most studied cases. The factors affecting the enhancement of the total ionic conductivity are discussed. The highest value of σtot = 1.4 × 10-4 Sâcm-1 has been obtained for LATP-0.1LSO material sintered at 1000 °C for 6 h.
ABSTRACT
In the present study, the high pressure torsion (HPT) was used to refine the grain structure down to the nanometer scale in an austenitic stainless steel. The principles of HPT lay on torsional deformation under simultaneous high pressure of the specimen, which results in substantial reduction in the grain size. Disks of the 316LVM austenitic stainless steel of 10 mm in diameter were subjected to equivalent strains epsilon of 32 at RT and 450 degrees C under the pressure of 4 GPa. Furthermore, two-stage HPT processes, i.e., deformation at room temperature followed by deformation at 450 degrees C, were performed. The resulting microstructures were investigated in TEM observations. The mechanical properties were measured in terms of the microhardness and in tensile tests. HPT performed at two-stage conditions (firstly at RT next at 450 degrees C) gives similar values of microhardness to the ones obtained after deforming only at 450 degrees C but performed to higher values of the overall equivalent strain epsilon. The effect of high pressure torsion on structural refinement and mechanical properties of an austenitic stainless steel was evaluated.
