ABSTRACT
Purpose: The study aimed to compare four irrigation methods for triple antibiotic paste (TAP) removal using micro-computed tomography (micro-CT) analysis. Materials and methods: Forty bovine central incisor teeth were selected, and the root canals were prepared up to #6 Peeso reamer drills. Equal portions of metronidazole, ciprofloxacin, and minocycline were used for the TAP preparation. The TAP was prepared by mixing the powder with distilled water (with a powder to liquid ratio of 1 mg/1 mL). The TAP was introduced to the canals with a lentulo spiral; then, the access cavities were temporarily sealed. After 21 days of storage, the teeth were randomly divided into four equal groups according to irrigation techniques: open-ended, side-vented, double side-vented needle irrigations and EndoActivator irrigation device. The TAP was removed using 17% EDTA (20 mL) and distilled water (5 mL) for all of the groups. The volume of the intracanal medicament before and after the irrigation procedure was recorded by scanning the samples with micro-CT, and the TAP percentage was calculated. The percentages obtained from each group were compared using ANOVA. The significance level was set at p<0.05. Results: The results showed that there was no statistically significant difference among the TAP percentage volumes removed by the different irrigation techniques. Conclusion: The irrigation techniques used in this study showed similar TAP removal efficiency, however, they could not completely remove the TAP from the root canal systems.
ABSTRACT
BACKGROUND: The heating of chelating agents such as EDTA increases dentin wettability by decreasing surface tension. However, the calcium ion release effect of preheated chelating agents in instrumented root canals has not yet been mentioned. In this study, it was aimed to evaluate the number of calcium ions removed by the pre-heated chelating agents from the root canals. MATERIAL AND METHODS: After 51 bovine teeth were instrumented, three of them were separated as negative controls and the remaining teeth were divided into six groups according to the temperature of the solution (at 22 or 37ºC): EDTA-22, CITRIC-22, QMix-22, EDTA-37, CITRIC-37 and QMix-37. Following irrigation, calcium ion levels were determined by atomic absorption spectrophotometer in chelating agents collected from the root canals. RESULTS: QMix solution eliminated significantly more calcium ions than other chelating agents at different temperatures (p< 0.05). Regardless of the heating, QMix and 17% EDTA were significantly superior to 40% Citric acid (p< 0.05) while no significant difference was detected between QMix and 17% EDTA groups (p< 0.05). Heating all chelating agents did not significantly increase their ability to remove calcium ions from pre-instrumented root canals (P< 0.05). In the SEM examination, it was observed that the smear layer was removed from the middle third of the roots, except for the negative control group. CONCLUSIONS: Temperature changes have shown that these agents do not increase the ability of the smear layer to dissolve the inorganic structure. QMix at different temperatures may be recommended to use as the final chelating agent. Key words:EDTA, citric acid, QMix, calcium ions, temperature.
ABSTRACT
This study was conducted to evaluate the effects of ethylenediaminetetraacetic acid (EDTA), Irritrol, and QMix solutions used with manual irrigation and diode and erbium, chromium-doped yttrium, scandium, gallium, and garnet (Er,Cr:YSGG) laser activation on the bonding ability of sealer to the intraradicular dentin. The root canals of 90 mandibular incisors were instrumented, and the teeth were allocated randomly to nine groups (n = 10/group) receiving final irrigation with different irrigation solutions (EDTA, Irritrol, and QMix) and irrigant activation techniques (manual, diode laser, and Er,Cr:YSGG laser). Following endodontic filling, three sections of 1-mm thickness were obtained from the middle third of each root. The root filling was subjected to a push-out test to examine the bond strength of the sealer to dentin. The test data were examined using analysis of variance with a significance level of É < .05. Failure modes were determined by stereomicroscopy, and the surface characteristics of dentin were observed by scanning electron microscopy. Irritrol showed less push-out bond strength than did the other solutions in the Er,Cr:YSGG laser groups (p < .05). In the diode laser groups, QMix provided greater adhesion than did Irritrol (p < .05). The activation of QMix with the Er,Cr:YSGG laser increased the bond strength more than did manual irrigation (p < .05). No other significant difference was observed between other comparison pairs (p > .05). QMix provided adhesion superior to that of Irritrol when activated with diode and Er,Cr:YSGG lasers. Er,Cr:YSGG laser activation increased the adhesion of filling material with QMix irrigation.
Subject(s)
Dental Bonding , Lasers, Solid-State , Dental Materials , Dentin , Edetic Acid , Humans , Incisor , Lasers, SemiconductorABSTRACT
The aim of this in vitro study was to compare the percentage of penetration of three final irrigant into the dentinal tubules after application of several irrigation techniques. Mandibular premolars were divided into nine groups (n:10): chlorhexidine (CHX) + conventional syringe irrigation (CI), CHX + EndoActivator (SI), CHX + Er,Cr:YSGG laser (LAI), QMix + CI, QMix + SI, QMix + LAI, Irritrol + CI, Irritrol + SI and Irritrol + LAI. Following irrigation, all roots were horizontally sectioned at 2 mm and 5 mm from the apex and examined using a confocal laser scanning microscopy. QMix exhibited a significantly higher penetration percentage than CHX at the apical section (P < 0.05). In the Irritrol group, SI displayed a significantly higher penetration area than CI in the middle section. Statistically significant differences were also determined between middle and apical section (P < 0.05). Use of QMix with different agitation technique seems advantageous in dentinal tubule penetration.
