ABSTRACT
Erythritol tetranitrate (ETN) was prepared independently by two research groups from the USA and the Netherlands. The partially nitrated impurities present in ETN were studied using liquid chromatography-mass spectrometry to address the ultimate challenge in forensic explosives investigations, i.e., providing chemical and tactical information on the production and origin of the explosive material found at a crime scene. Accurate quantification of the tri-nitrated byproduct erythritol trinitrate (ETriN) was achieved by in-lab production of an ETriN standard and using custom-made standards of the two isomers of ETriN (1,2,3-ETriN and 1,2,4-ETriN). Large differences in levels of ETriN were observed between the two sample sets showing that, even when similar synthesis routes are employed, batches from different production locations can contain different impurity profiles. In one of the sample sets the ratios of the lesser partially nitrated impurities, EDiN and EMN, in the ETN samples could be determined. The impurity profiles enable prediction of post-synthesis work-up steps by reduction of the level of partially nitrated products upon recrystallization. However, impurity analysis does not enable predictions with respect to raw material or synthesis route used. Nonetheless, characteristic impurity profiles obtained can be used in forensic casework to differentiate or link ETN samples. However, forensic interpretation can be complicated by acid catalyzed degradation which can cause changes in impurity levels over time. The high food-grade quality of the erythritol precursor materials did not provide other impurity markers using the LC-MS methods in this study. To expand our framework of chemical attribution a follow-up study will be reported that focuses on stable isotope analysis of ETN and its precursor materials that potentially allow predictions for forensic explosives intelligence.
ABSTRACT
An LTQ-Orbitrap FTMS is a new (hybrid) mass spectrometric (MS) analyzer. It allows for the acquisition of full scan MS(n) (n-stage fragmentations, n=1-n) spectra with the linear ion trap detector (LTQ) at high speed and/or with the Fourier Transform-detector (Orbitrap) with ultra high mass resolution (>60,000 at m/z<400amu) and high mass accuracy (≤1ppm with internal calibration). In addition it may be coupled with liquid chromatography (LC) with photo diode array (PDA) detection. Two methods for the forensic screening and confirmation of all common trace explosives in post-blast residues have been developed on this instrument using atmospheric pressure chemical ionization (APCI). In one run, the nitrogen-containing explosives are analyzed with the combination of "LC-(PDA)-APCI(-)-LTQ MS(2)/Orbitrap FTMS" (Method 1). In another run, peroxide explosives are analyzed with "LC-APCI(+)-LTQ MS(2)/Orbitrap FTMS" (Method 2). The performance of both methods has been validated according to procedures defined in the EU COMMISSION DECISION implementing Council Directive 96/23/EC concerning the performance of analytical methods and the interpretation of results (DC 2002/657/EC) and other standards (NEN 17025 and NEN 7777). The methods are highly selective due to the simultaneous utilization of the Orbitrap FTMS and LTQ MS(2), both of which are highly selective detectors Tested explosive compounds can be detected in the molecular ion form by the Orbitrap analyzer with minimal mass interference in different matrices when using an extremely narrow mass tolerance detection window (≤2ppm). The identification of a detected compound follows an identification point system. Experimental results show that almost all explosive compounds meet the confirmation criteria (minimum 4 points) required for the positive identification by the DC 2002/657/EC.
ABSTRACT
Pentaerythritol tetranitrate (PETN) and its degradation products are analyzed to discriminate between residues originating from PETN explosions and residues obtained under other circumstances, such as natural degradation on textile, or after handling intact PETN. The degradation products observed in post-explosion samples were identified using liquid chromatography-mass spectrometry as the less-nitrated analogues of PETN: pentaerythritol trinitrate (PETriN), pentaerythritol dinitrate (PEDiN) and pentaerythritol mononitrate (PEMN). Significant levels of these degradation products were observed in post-explosion samples, whereas only very low levels were detected in a variety of intact PETN samples and naturally degraded PETN. No significant degradation was observed after 12 weeks of storage at room temperature and the influence of high relative humidity (90%) was found to be small. Natural degradation was accelerated by storage of small amounts of PETN on different types of textile, resembling the clothing of a suspect, at elevated temperature (333K). This resulted in significant levels of PETN degradation products, but the relative amounts remained much lower than in post-explosion PETN. For PETriN the peak area relative to PETN was 0.014 (SD=0.0051) and 0.39 (SD=0.19) respectively. Based on the peak areas of PETriN, PEDiN and PEMN relative to PETN, it was possible to fully distinguish the post-explosion profiles from the profiles obtained from intact PETN or after (accelerated) natural degradation. Although more data are required to accurately assess the strength of the evidence, this work illustrates that PETN profiling may yield valuable evidence when investigating a possible link between a suspect and post-explosion PETN found on a crime scene. Due to the substantial variation in the degradation pattern between explosion experiments and even between sampling positions in one experiment, the method is not able to distinguish different PETN explosion events.
