Soluble monolayers of n-decyl glucopyranoside and n-decyl maltopyranoside. Phase changes in the gaseous to the liquid-expanded range.

To examine the transition from the gaseous to the liquid-expanded monolayer state, surface tension data were recorded for n-decyl beta-d-glucopyranoside (Glu) and n-decyl beta-d-maltopyranoside (Mal) solutions at low concentrations and at different temperatures. Comparisons were also made with n-decyl beta-d-thiomaltopyranoside (S-Mal) solutions at room temperature. The transitions observed occur at very low concentrations and surface pressures, about 0.5% of the critical micelle concentration (cmc) and between 0.8 and 1 mN/m for Glu and Mal at 22 degrees C. For S-Mal the transition is recorded for a concentration of 0.5% of the cmc as well, but the surface pressure is lower, about 0.4 mN/m. The gradual change in molecular area about the transition is from about 500 to 200 A(2) and 400 to 150 A(2) for Mal and Glu, respectively, and from about 800 to 250 A(2) for S-Mal. The comparatively large molecular areas after the transitions are incompatible with the notion that a coherent hydrocarbon film would cover the entire surface already at this stage. Standard surface thermodynamics was applied to elucidate the nature of these transitions in combination with two model concepts: The formation of an infinite network of surfactant molecules and, second, the formation of surface micelles. Hard-disk simulation results were employed to quantify the additional surface pressure after the transition attributed to the formation of surface micelles. In conclusion the formation of surface micelles is plausible as the hard-disk model is capable of accounting for the additional surface pressure increase with acceptable accuracy. Further, vibrational sum frequency spectroscopy was used to investigate the transition for Mal. Using the distinct feature of the non-hydrogen-bonded OH ("free OH") at 3700 cm(-)(1) for probing the surface water state, it could be determined that the surface holds a sizable fraction of unperturbed surface water even after the transition from the Henry range. The decrease in the free OH signal was found to correlate with the increase in surface density of surface micelles.

Headgroup and hydrocarbon tail effects on the surface tension of sugar-based surfactant solutions.

Measurements of surface tension isotherms were conducted for water solutions of pure and mixed n-decyl-beta-d-glucopyranoside (C(10)-Glu) and n-decyl-beta-d-maltopyranoside (C(10)-Mal) surfactants. By applying the Gibbs surface tension equation, the surface densities of Glu and Mal were derived for different compositions and concentrations. The surface fractions were compared with theoretically calculated values where the headgroups were modeled as hard disks. Satisfactory agreement was found for hard-disk sizes of 22.9 and 11.3 A(2) in the case of a 1:1 mixture. The results of the hard-disk calculations were employed to estimate the configurational free energy of the n-decyl-hydrocarbon chain. The results obtained agree well with previous calculations for the n-dodecyl chain. Comparison with n-dodecyl beta-d-maltopyranoside (C(12)-Mal) indicated a further contribution, with the longer hydrocarbon chain giving rise to a higher surface tension in good agreement with data for hydrocarbon liquids. Furthermore, the interpenetration of the headgroup into the hydrocarbon film was studied by means of comparing surface-tension data for n-decyl- and n-dodecyl-ethylene-oxide-based surfactants and n-decyl- and n-dodecyl-beta-d-thiomaltopyranosides (C(10)-S-Mal and C(12)-S-Mal, respectively) and -maltopyranosides. It was found that lengthening the tetra(etylene oxide) chain by one segment affects the surface tension only marginally, indicating little interpenetration of the additional ethylene-oxide group into the hydrocarbon film. For the thiomaltosides, however, the corresponding effect was found to be remarkably high.

n-Decyl-glucopyranoside and n-decyl-maltopyranoside gibbs monolayers. Phase changes in the dilute liquid-expanded range.

Surface tension isotherms were recorded for n-decyl-beta-d-glucopyranoside (Glu) and n-decyl-beta-D-maltopyranoside (Mal) solutions at temperatures of 8, 22, and 29 degrees C. Comparison was made with isotherms of n-decyl-beta-D-thiomaltopyranoside (S-Mal) at 22 degrees C. In addition to the transition from the gaseous to the liquid-expanded (LE) state, a second transition was observed in the early stages of the LE regime for Glu, Mal, and S-Mal at room temperature. The adsorption isotherm of Mal and Glu obtained at 22 degrees C shows the presence of an adsorption step at an average area/molecule of about 79 A2 between, approximately, 0.02 and 0.1 mM (the critical micelle concentration (cmc) is 2 mM) and 0.015 and 0.03 mM (the cmc is 2 mM), respectively. Similarly, for S-Mal an adsorption plateau is observed at 70 A2 between 0.01 and 0.03 mM (the cmc is 0.7 mM). From the temperature dependence of the surface tension, we have seen that there are considerable differences in the adsorption of Glu and Mal. For Mal, the adsorption plateau is also observed at 29 degrees C at around 79 A2, whereas Glu exhibits no adsorption plateau at this temperature. At 8 degrees C, both Mal and Glu exhibit saturation behavior in the dilute part of the liquid-expanded range, but at this temperature the average molecular areas are lower than at 22 degrees C: around 66 A2 for Glu and 75 A2 for Mal. Thus, the temperature sensitivity of Glu is considerably greater than for Mal in this range. The saturation regime coincides with a pronounced surface entropy minimum for Mal. The transition in the dilute liquid-expanded range supposedly occurs from a state with deformed surface micelles arranged in a hexagonal pattern, referred to as the granular range, to a true LE monolayer with a fluid hydrocarbon tail layer covering the entire surface.