Exchange-bias via nanosegregation in novel Fe2-x Mn1+x Al (x = -0.25, 0, 0.25) Heusler films.

Exchange-bias has been reported in bulk nanocrystalline Fe2MnAl, but individual thin films of this Heusler alloy have never been studied so far. Here we study the structural and magnetic properties of nanocrystalline thin films of Fe2-x Mn1+x Al (x = -0.25, 0 and 0.25) obtained by sputtering and ex situ post-deposition annealing. We find that Fe2MnAl films display exchange-bias, and that varying Mn concentration determines the magnitude of the effect, which can be either enhanced (in Fe1.75Mn1.25Al) or suppressed (in Fe2.25Mn0.75Al). X-ray diffraction shows that our films present a mixed L21-B2 Heusler structure where increasing Mn concentration favors the partial transformation of the L21 phase into the B2 phase. Scanning transmission electron microscopy (STEM) and energy dispersive X-ray spectroscopy (EDX) reveal that this composition-driven L21 → B2 transformation is accompanied by phase segregation at the nanoscale. As a result, the Fe2-x Mn1+x Al films that show exchange-bias (x = 0, 0.25) are heterogeneous, with nanograins of an Fe-rich phase embedded in a Mn-rich matrix (a non-negative matrix factorisation algorithm was used to give an indication of the phase composition from EDX data). Our comparative analysis of XRD, magnetometry and X-ray magnetic circular dichroism (XMCD), shows that the Fe-rich nanograins and Mn-rich matrix are composed of a ferromagnetic L21 phase and an antiferromagnetic B2 phase, respectively, thus revealing that exchange-coupling between these two phases is the cause of the exchange-bias effect. Our work should inspire the development of single-layer, environmentally friendly spin valve devices based on nanocomposite Heusler films.

Pushing the limits of applicability of REBCO coated conductor films through fine chemical tuning and nanoengineering of inclusions.

An outstanding current carrying performance (namely critical current density, Jc) over a broad temperature range of 10-77 K for magnetic fields up to 12 T is reported for films of YBa2Cu3O7-x with Ba2Y(Nb,Ta)O6 inclusion pinning centres (YBCO-BYNTO) and thicknesses in the range of 220-500 nm. Jc values of 10 MA cm-2 were measured at 30 K - 5 T and 10 K - 9 T with a corresponding maximum of the pinning force density at 10 K close to 1 TN m-3. The system is very flexible regarding properties and microstructure tuning, and the growth window for achieving a particular microstructure is wide, which is very important for industrial processing. Hence, the dependence of Jc on the magnetic field angle was readily controlled by fine tuning the pinning microstructure. Transmission electron microscopy (TEM) analysis highlighted that higher growth rates induce more splayed and denser BYNTO nanocolumns with a matching field as high as 5.2 T. Correspondingly, a strong peak at the B||c-axis is noticed when the density of vortices is lower than the nanocolumn density. YBCO-BYNTO is a very robust and reproducible composite system for high-current coated conductors over an extended range of magnetic fields and temperatures.

Intrasaccular Flow Disruption in Acutely Ruptured Aneurysms: A Multicenter Retrospective Review of the Use of the WEB.

BACKGROUND AND PURPOSE: Use of the WEB intra-aneurysmal flow-disruption device in unruptured wide-neck bifurcation aneurysms has proven safety and efficacy. However, ruptured aneurysms are underrepresented in existing studies. This retrospective multicenter study describes the use of the WEB in patients with a ruptured intracranial aneurysm. MATERIALS AND METHODS: Ten centers contributed to this study. Clinical and procedural data of 47 patients with 52 aneurysms were analyzed retrospectively together with follow-up angiographies. RESULTS: There were 37 anterior and 15 posterior circulation aneurysms with a neck size of ≥4 mm in 49 of 52 (94%) aneurysms; 45 (87%) aneurysms were <10 mm, and 2 were partially thrombosed. Successful placement of the WEB was possible in every case. Adjunctive devices were used in 8 of 52 (15%) aneurysms. Thromboembolic events were observed in 4 of 52 (8%) patients. Adverse events occurred in 15 patients with 16 aneurysms, 9 of which were potentially related to the WEB procedure (3 thromboembolic events, 5 protrusions, and 1 perforations; 2 perforations were caused by the wire or catheter), but none had a clinical impact. Four patients were retreated. Short-term follow-up in 25 of 39 patients revealed complete occlusion in 15 of 25 (60%), 5 of 25 (20%) with residual neck, and 5 of 25 (20%) with residual aneurysm filling. Short- to midterm imaging in 9 of 25 patients revealed complete occlusion in 5 (55.6%), residual neck in 2 (22%), and residual aneurysm filling in 2 (22%). Of 47 patients, 23 (49%) had an mRS score of 0, 1, or 2; 13 (28%) had an mRS score of 3 or 4; and none had an mRS score of 5 at discharge. CONCLUSIONS: This retrospective series showed good procedural safety, feasibility, and stability of midterm occlusion in ruptured wide-neck bifurcation aneurysms.

Delayed diagnosed posterior interosseous nerve palsy due to intramuscular myxoma.

We present a case of posterior interosseous nerve palsy after bowel surgery associated with intramuscular myxoma of the supinator muscle. The initial symptoms of swelling of the forearm made it difficult to distinguish the condition from extravasations after intravenous cannulation. The diagnosis was finally established with nerve conduction studies and MRI 3 months after symptom onset. The patient underwent surgery for removal of the tumour and decompression of the posterior interosseous nerve. The histological examination identified the tumour as intramuscular myxoma and the patient made a full recovery with no recurrence of the lesion until present. Every swelling on the forearm causing neurological disorders is tumour suspected and should be examined clinically as well as electrophysically and radiographically. Early surgery and nerve decompression should follow immediately after the diagnosis. In case of intramuscular myxoma, good recovery of function after surgery with low recurrence risk may be expected.

Growth and process conditions of aligned and patternable films of iron(III) oxide nanowires by thermal oxidation of iron.

A simple, catalyst-free growth method for vertically aligned, highly crystalline iron oxide (α-Fe(2)O(3)) wires and needles is reported. Wires are grown by the thermal oxidation of iron foils. Growth properties are studied as a function of temperature, growth time and oxygen partial pressure. The size, morphology and density of the nanostructures can be controlled by varying growth temperature and time. Oxygen partial pressure shows no effect on the morphology of resulting nanostructures, although the oxide thickness increases with oxygen partial pressure. Additionally, by using sputtered iron films, the possibility of growth and patterning on a range of different substrates is demonstrated. Growth conditions can be adapted to less tolerant substrates by using lower temperatures and longer growth time. The results provide some insight into the mechanism of growth.

Defects on the dorsum of the hand--the posterior interosseous flap and its alternatives.

There are conditions that preclude the use of the posterior interosseous flap for reconstruction of the dorsum of the hand. Based on a series of 34 cases, these conditions are outlined and alternative solutions discussed. The posterior interosseous flap was employed for closure in 30 cases. In four cases different methods were used due to severe trauma to the wrist and distal forearm with potential impairment of the pedicle, a complex defect requiring a composite flap and an anatomical variation. Thin free flaps were employed alternatively. All flaps survived but there was marginal flap necrosis in two posterior interosseous flaps. The posterior interosseous flap proved its usefulness and reliability in reconstruction of the hand in this series. In four cases, free lateral arm and temporoparietal fascial flaps were employed. Flaps based on the main vessels of the forearm were not used due to their significant donor site morbidity.