ABSTRACT
Miscanthus crops possess very attractive properties such as high photosynthesis yield and carbon fixation rate. Because of these properties, it is currently considered for use in second-generation biorefineries. Here we analyze the differences in chemical composition between M. x giganteus, a commonly studied Miscanthus genotype, and M. nagara, which is relatively understudied but has useful properties such as increased frost resistance and higher stem stability. Samples of M. x giganteus (Gig35) and M. nagara (NagG10) have been separated by plant portion (leaves and stems) in order to isolate the corresponding lignins. The organosolv process was used for biomass pulping (80% ethanol solution, 170 °C, 15 bar). Biomass composition and lignin structure analysis were performed using composition analysis, Fourier-transform infrared (FTIR), ultraviolet-visible (UV-Vis) and nuclear magnetic resonance (NMR) spectroscopy, thermogravimetric analysis (TGA), size exclusion chromatography (SEC) and pyrolysis gas-chromatography/mass spectrometry (Py-GC/MS) to determine the 3D structure of the isolated lignins, monolignol ratio and most abundant linkages depending on genotype and harvesting season. SEC data showed significant differences in the molecular weight and polydispersity indices for stem versus leaf-derived lignins. Py-GC/MS and hetero-nuclear single quantum correlation (HSQC) NMR revealed different monolignol compositions for the two genotypes (Gig35, NagG10). The monolignol ratio is slightly influenced by the time of harvest: stem-derived lignins of M. nagara showed increasing H and decreasing G unit content over the studied harvesting period (December-April).
ABSTRACT
As a renewable, Miscanthus offers numerous advantages such as high photosynthesis activity (as a C4 plant) and an exceptional CO2 fixation rate. These properties make Miscanthus very attractive for industrial exploitation, such as lignin generation. In this paper, we present a systematic study analyzing the correlation of the lignin structure with the Miscanthus genotype and plant portion (stem versus leaf). Specifically, the ratio of the three monolignols and corresponding building blocks as well as the linkages formed between the units have been studied. The lignin amount has been determined for M. x giganteus (Gig17, Gig34, Gig35), M. nagara (NagG10), M. sinensis (Sin2), and M. robustus (Rob4) harvested at different time points (September, December, and April). The influence of the Miscanthus genotype and plant component (leaf vs. stem) has been studied to develop corresponding structure-property relationships (i.e., correlations in molecular weight, polydispersity, and decomposition temperature). Lignin isolation was performed using non-catalyzed organosolv pulping and the structure analysis includes compositional analysis, Fourier transform infradred (FTIR), ultraviolet/visible (UV-Vis), hetero-nuclear single quantum correlation nuclear magnetic resonsnce (HSQC-NMR), thermogravimetric analysis (TGA), and pyrolysis gaschromatography/mass spectrometry (GC/MS). Structural differences were found for stem and leaf-derived lignins. Compared to beech wood lignins, Miscanthus lignins possess lower molecular weight and narrow polydispersities (<1.5 Miscanthus vs. >2.5 beech) corresponding to improved homogeneity. In addition to conventional univariate analysis of FTIR spectra, multivariate chemometrics revealed distinct differences for aromatic in-plane deformations of stem versus leaf-derived lignins. These results emphasize the potential of Miscanthus as a low-input resource and a Miscanthus-derived lignin as promising agricultural feedstock.
Subject(s)
Lignin/analysis , Plant Leaves/chemistry , Plant Stems/chemistry , Poaceae/chemistry , Biomass , Chromatography, Gel/methods , Gas Chromatography-Mass Spectrometry/methods , Lignin/chemistry , Magnetic Resonance Spectroscopy/methods , Principal Component Analysis , Spectrophotometry, Ultraviolet/methods , Spectroscopy, Fourier Transform Infrared/methods , Thermogravimetry/methodsABSTRACT
Polyurethane (PU) coatings were successfully produced using unmodified kraft lignin (KL) as an environmentally benign component in contents of up to 80 wt%. Lignin samples were precipitated from industrial black liquor in aqueous solution working at room temperature and different pH levels (pH 2 to pH 5). Lignins were characterized by UV-Vis, FTIR, pyrolysis-GC/MS, SEC and 31P-NMR. Results show a correlation between pH level, OH number and molecular weight M w of isolated lignins. Lignin-based polyurethane coatings were prepared in an efficient one step synthesis dissolving lignin in THF and PEG425 in an ultrasonic bath followed by addition of 4,4-diphenylmethanediisocyanate (MDI) and triethylamine (TEA). Crosslinking was achieved under very mild conditions (1 hour at room temperature followed by 3 hours at 35 °C). The resulting coatings were characterized regarding their physical properties including ATR-IR, TGA, optical contact angle, light microscopy, REM-EDX and AFM data. Transparent homogeneous films of high flexibility resulted from lignins isolated at pH 4, possessing a temperature resistance up to 160 °C. Swelling tests revealed a resistance against water. Swelling in DMSO depends on index, pH of precipitation and catalyst utilization for PU preparation. According to AFM studies, surface roughness is between 10 and 28 nm.
ABSTRACT
Balanites aegyptiaca (Balanitaceae) is a widely grown desert plant with multiuse potential. In the present paper, a crude extract from B. aegyptiaca seeds equivalent to a ratio of 1 : 2000 seeds to the extract was screened for antiplasmodial activity. The determined IC(50) value for the chloroquine-susceptible Plasmodium falciparum NF54 strain was 68.26 µg/µL ± 3.5. Analysis of the extract by gas chromatography-mass spectrometry detected 6-phenyl-2(H)-1,2,4-triazin-5-one oxime, an inhibitor of the parasitic M18 Aspartyl Aminopeptidase as one of the compounds which is responsible for the in vitro antiplasmodial activity. The crude plant extract had a K(i) of 2.35 µg/µL and showed a dose-dependent response. After depletion of the compound, a significantly lower inhibition was determined with a K(i) of 4.8 µg/µL. Moreover, two phenolic compounds, that is, 2,6-di-tert-butyl-phenol and 2,4-di-tert-butyl-phenol, with determined IC(50) values of 50.29 µM ± 3 and 47.82 µM ± 2.5, respectively, were detected. These compounds may contribute to the in vitro antimalarial activity due to their antioxidative properties. In an in vivo experiment, treatment of BALB/c mice with the aqueous Balanite extract did not lead to eradication of the parasites, although a reduced parasitemia at day 12 p.i. was observed.
ABSTRACT
An important issue facing global health today is the need for new, effective and affordable drugs against malaria, particularly in resource-poor countries. Moreover, the currently available antimalarials are limited by factors ranging from parasite resistance to safety, compliance, cost and the current lack of innovations in medicinal chemistry. Depletion of polyamines in the intraerythrocytic phase of P. falciparum is a promising strategy for the development of new antimalarials since intracellular levels of putrescine, spermidine and spermine are increased during cell proliferation. S-adenosyl-methionine-decarboxylase (AdoMETDC) is a key enzyme in the biosynthesis of spermidine. The AdoMETDC inhibitor CGP 48664A, known as SAM486A, inhibited the separately expressed plasmodial AdoMETDC domain with a Km( i ) of 3 microM resulting in depletion of spermidine. Spermidine is an important precursor in the biosynthesis of hypusine. This prompted us to investigate a downstream effect on hypusine biosynthesis after inhibition of AdoMETDC. Extracts from P. falciparum in vitro cultures that were treated with 10 microM SAM 486A showed suppression of eukaryotic initiation factor 5A (eIF-5A) in comparison to the untreated control in two-dimensional gel electrophoresis. Depletion of eIF-5A was also observed in Western blot analysis with crude protein extracts from the parasite after treatment with 10 microM SAM486A. A determination of the intracellular polyamine levels revealed an approximately 27% reduction of spemidine and a 75% decrease of spermine while putrescine levels increased to 36%. These data suggest that inhibition of AdoMetDc provides a novel strategy for eIF-5A suppression and the design of new antimalarials.
Subject(s)
Adenosylmethionine Decarboxylase/metabolism , Down-Regulation , Plasmodium falciparum/enzymology , Protozoan Proteins/metabolism , Putrescine/biosynthesis , Adenosylmethionine Decarboxylase/antagonists & inhibitors , Adenosylmethionine Decarboxylase/chemistry , Adenosylmethionine Decarboxylase/genetics , Amidines/pharmacology , Animals , Enzyme Inhibitors/pharmacology , Gene Expression Regulation, Enzymologic , Humans , Indans/pharmacology , Kinetics , Malaria, Falciparum/parasitology , Mice , Mice, Inbred C57BL , Peptide Initiation Factors/genetics , Peptide Initiation Factors/metabolism , Plasmodium falciparum/chemistry , Plasmodium falciparum/genetics , Plasmodium falciparum/metabolism , Protozoan Proteins/antagonists & inhibitors , Protozoan Proteins/chemistry , Protozoan Proteins/genetics , RNA-Binding Proteins/genetics , RNA-Binding Proteins/metabolism , Spermidine/metabolism , Spermine/metabolism , Eukaryotic Translation Initiation Factor 5AABSTRACT
In searching for new targets for antimalarials we investigated the biosynthesis of hypusine present in eukaryotic initiation factor-5A (eIF-5A) in Plasmodium. Here, we describe the cloning and expression of deoxyhypusine hydroxylase (DOHH), which completes the modification of eIF-5A through hydroxylation of deoxyhypusine. The dohh cDNA sequence revealed an ORF of 1236 bp encoding a protein of 412 amino acids with a calculated molecular mass of 46.45 kDa and an isoelectric point of 4.96. Interestingly, DOHH from Plasmodium has a FASTA SCORE of only 27 compared with its human ortholog and contains several matches similar to E-Z-type HEAT-like repeat proteins (IPR004155 (InterPro), PF03130 (Pfam), SM00567 (SMART) present in the phycocyanin lyase subunits of cyanobacteria. Purified DOHH protein displayed hydroxylase activity in a novel in vitro DOHH assay, but phycocyanin lyase activity was absent. dohh is present as a single-copy gene and is transcribed in the asexual blood stages of the parasite. A signal peptide at the N-terminus might direct the protein to a different cellular compartment. During evolution, Plasmodium falciparum acquired an apicoplast that lost its photosynthetic function. It is possible that plasmodial DOHH arose from an E/F-type phycobilin lyase that gained a new role in hydroxylation. Structured digital abstract: * MINT-7255047: DHS (uniprotkb:P49366) enzymaticly reacts (MI:0414) with eIF-5A (uniprotkb:Q710D1) by enzymatic studies (MI:0415) * MINT-7255326: DOHH (uniprotkb:Q8I701) enzymaticly reacts (MI:0414) with eIF-5A (uniprotkb:Q710D1) by enzymatic studies (MI:0415).
Subject(s)
Lysine/analogs & derivatives , Mixed Function Oxygenases/metabolism , Plasmodium/metabolism , Amino Acid Sequence , Animals , Blotting, Western , Gas Chromatography-Mass Spectrometry , Lysine/chemistry , Lysine/metabolism , Mixed Function Oxygenases/chemistry , Mixed Function Oxygenases/genetics , Molecular Sequence Data , Molecular Structure , Plasmodium/enzymology , Plasmodium/genetics , Polymerase Chain Reaction , Protozoan Proteins/chemistry , Protozoan Proteins/genetics , Protozoan Proteins/metabolism , Sequence Homology, Amino AcidABSTRACT
Gas chromatography with simultaneous flame-ionization detection (FID) and a nitrogen-phosphorus detection (NPD) as well as gas chromatography-mass spectrometry (GC/MS) has been used to characterize long-chain primary alkyl amines after derivatization with trifluoroacetic anhydride (TFAA). Electron impact ionization- (EI) and negative chemical ionization (NCI) mass spectra of trifluoroacetylated derivatives of the identified tert-octadecylamines are presented for the first time. The corrosion inhibiting alkyl amines were applied in a water-steam circuit of energy systems in the power industry. Solid-phase extraction (SPE) with octadecyl bonded silica (C18) sorbents followed by gas chromatography were used for quantification of the investigated tert-octadecylamines in boiler water, superheated steam and condensate samples from the power plant. The estimated values were: 89 microg l(-1)(n = 5, RSD = 7.8%), 45 microg l(-1) (n = 5, RSD = 5.4%) and 37 microg l(-1)(n = 5, RSD = 2.3%), respectively.