Note: Dynamic analysis of a robotic fish motion with a caudal fin with vertical phase differences.

In this paper, a robotic fish with a caudal fin with vertical phase differences is studied, especially focusing on the energy consumption. Energies for thrusting a conventional robotic fish and one with caudal fin with vertical phase differences are obtained and compared each other. It is shown that a robotic fish with a caudal fin with vertical phase differences can save more energy, which implies the efficient thrusting via a vertically waving caudal fin.

Development of roll-to-roll hot embossing system with induction heater for micro fabrication.

In this paper, a hot embossing heating roll with induction heater inside the roll is proposed. The induction heating coil is installed inside a roll that is used as a heating roll of a roll-to-roll (R2R) hot embossing apparatus. Using an inside installed heating coil gives the roll-to-roll hot embossing system a more even temperature distribution on the surface of the heating roll compared to that of previous systems, which used an electric wire for heating. This internal induction heating roll can keep the working environment much cleaner because there is no oil leakage compared to the oiled heating roll. This paper describes the principles and provides an analysis of this proposed system; some evaluation has also been performed for the system. A real R2R hot embossing heating roll system was fabricated and some experiments on micro-pattering have been performed. After that, evaluation has been performed on the results.

Actuation of a robotic fish caudal fin for low reaction torque.

In this paper, a novel caudal fin for actuating a robotic fish is presented. The proposed caudal fin waves in a vertical direction with a specific spatial shape, which is determined by a so-called shape factor. For a specific shape factor, a traveling wave with a vertical phase difference is formed on a caudal fin during fin motion. It will be shown by the analysis that the maximum reaction torque at the joint of a caudal fin varies depending on the shape factors. Compared with a conventional plate type caudal fin, the proposed fin with a shape factor of 2π can eliminate the reaction torque perfectly, while keeping the propulsion force unchanged. The benefits of the proposed fin will be demonstrated by experiments.