ABSTRACT
PbSe is a surprisingly good thermoelectric material due, in part, to its low thermal conductivity that had been overestimated in earlier measurements. The thermoelectric figure of merit, zT, can exceed 1 at high temperatures in both p-type and n-type PbSe, similar to that found in PbTe. While the p-type lead chalcogenides (PbSe and PbTe) benefit from the high valley degeneracy (12 or more at high temperature) of the valence band, the n-type versions are limited to a valley degeneracy of 4 in the conduction band. Yet the n-type lead chalcogenides achieve a zT nearly as high as the p-type lead chalcogenides. This effect can be attributed to the weaker electron-phonon coupling (lower deformation potential coefficient) in the conduction band as compared with that in the valence band, which leads to higher mobility of electrons compared to that of holes. This study of PbSe illustrates the importance of the deformation potential coefficient of the charge-carrying band as one of several key parameters to consider for band structure engineering and the search for high performance thermoelectric materials.
ABSTRACT
The band structure of PbTe can be manipulated by alloying with MgTe to control the band degeneracy. This is used to stabilize the optimal carrier concentration, making it less temperature dependent, demonstrating a new strategy to improve overall thermoelectric efficiency over a broad temperature range.
Subject(s)
Alloys/chemistry , Conservation of Natural Resources/methods , Lead/chemistry , Tellurium/chemistry , Electric Conductivity , Magnesium/chemistry , Microscopy, Electron, Scanning , Nanostructures/chemistry , Nanostructures/ultrastructure , Surface Properties , Temperature , Thermal Conductivity , X-Ray DiffractionABSTRACT
A rapid hot press system in which the heat is supplied by RF induction to rapidly consolidate thermoelectric materials is described. Use of RF induction heating enables rapid heating and consolidation of powdered materials over a wide temperature range. Such rapid consolidation in nanomaterials is typically performed by spark plasma sintering (SPS) which can be much more expensive. Details of the system design, instrumentation, and performance using a thermoelectric material as an example are reported. The Seebeck coefficient, electrical resistivity, and thermal diffusivity of thermoelectric PbTe material pressed at an optimized temperature and time in this system are shown to agree with material consolidated under typical consolidation parameters.
