New insights on the optical properties and upconversion fluorescence of Er-doped CoAl2O4 nanocrystals.

In this study, Er-doped CoAl2O4 nanocrystals (NCs) were synthesized via co-precipitation. All the NCs were crystallized in the form of a single phase with a spinel structure and Er3+ ions replaced Al3+ ions in the formation of the CoAl2-xErxO4 alloy structure. The optical characteristics of the Er3+ ion-doped CoAl2O4 NCs were thoroughly investigated by analyzing both the UV-VIS and photoluminescence spectra, using the Judd-Ofelt theory. The effect of Er doping content on the luminescent properties of the CoAl2O4 pigment (using lasers emitting at wavelengths of 413 and 978 nm) has been studied. The values of Judd-Oflet intensity parameters (Ω2, Ω4, and Ω6) were determined from the absorption spectra using the least square fitting method. The J-O parameters were calculated and compared with those of other host materials; the values of the Ω2, Ω4, and Ω6 parameters decreased with an increase in Er concentration. This suggests that the rigidity and local symmetry of the host materials become weaker as the concentration of Er3+ ions increases. The highest value of the Ω2 parameter, when compared with Ω4 and Ω6, suggests that the vibrational frequencies in the given samples are relatively low. The upconversion fluorescence phenomenon was observed and explained in detail under an excitation wavelength of 978 nm when the excitation power was varied.

Correction: Structural, magnetic and hyperthermia properties and their correlation in cobalt-doped magnetite nanoparticles.

[This corrects the article DOI: 10.1039/D1RA07407E.].

Structural, magnetic and hyperthermia properties and their correlation in cobalt-doped magnetite nanoparticles.

Cobalt doped magnetite nanoparticles (Co x Fe3-x O4 NPs) are investigated extensively because of their potential hyperthermia application. However, the complex interrelation among chemical compositions and particle size means their correlation with the magnetic and heating properties is not trivial to predict. Here, we prepared Co x Fe3-x O4 NPs (0 ≤ x ≤ 1) to investigate the effects of cobalt content and particle size on their magnetic and heating properties. A detailed analysis of the structural features indicated the similarity between the crystallite and particle sizes as well as their non-monotonic change with the increase of Co content. Magnetic measurements for the Co x Fe3-x O4 NPs (0 ≤ x ≤ 1) showed that the blocking temperature, the saturation magnetization, the coercivity, and the anisotropy constant followed a similar trend with a maximum at x = 0.7. Moreover, 57Fe Mössbauer spectroscopy adequately explained the magnetic behaviour, the anisotropy constant, and saturation magnetization of low Co content samples. Finally, our study shows that the relaxation loss is a primary contributor to the SAR in Co x Fe3-x O4 NPs with low Co contents as well as their potential application in magnetic hyperthermia.

Dependence of the distance between cut-wire-pair layers on resonance frequencies.

We studied both experimentally and theoretically the influence of the distance between adjacent cut-wire-pair layers on the magnetic and the electric resonances in the microwave-frequency regime. Besides the dependence on the separation between cut-wire pairs, along the electric-field direction, the electric resonance strongly depends on the distance between cut-wire-pair layers, while the magnetic resonance is almost unchanged. This contrast can be understood by the difference in the distribution of induced-charge density and in the direction of the induced current between the electric and magnetic resonances. A simple model is proposed to simulate our experimental results and the simulation results are in good agreement with the experiment. This result provides important information in obtaining left-handed behavior when the cut-wire pairs are combined with the continuous wire.

Dependence of the magnetic-resonance frequency on the cut-wire width of cut-wire pair medium.

We investigated some magnetic metamaterials based on cut-wire pairs instead of split-ring resonators to quest for the possibility of a negative magnetic permeability. Several periodic structures of cut-wire pairs were designed and fabricated, and their transmission spectra were measured in the microwave-frequency regime. The width dependence of magnetic-resonance frequency was studied both theoretically and experimentally for the periodic structures of cut-wire pairs. It was found that, besides the length dependence, the magnetic-resonance frequency also depends significantly on the width of cut-wire pair. A simple equivalent-circuit model proposed by Zhou et al. [Opt. Lett. 31, 3620-3622 (2006)] was employed to elucidate this interesting phenomenon and to simulate the width dependence. In the simulation the magnetic and the electric energies of the cut-wire pair were directly calculated to obtain the magnetic-resonance frequency. The theoretical results are in good agreement with the experimental ones. It reveals that there is a rather easy way to manipulate the magnetic-resonance frequency of magnetic-magnetic metamaterials.