ABSTRACT
Diacylglycerol (DAG) is commonly known as one of the precursors for the 3-monochloro-1,2-propanediol esters (3-MCPDE) and glycidyl esters (GE) formation. However, due to its health-promoting effects, its potential as alternative frying medium was examined. This study aimed to assess the frying performance of soybean oil-based diacylglycerol oil (DO) and its oil blends with palm olein (PO), in comparison with PO. Four different oil types (DO, PO, OB I (DO:PO, 1:1, w/w) and OB II (DO:PO, 1:2, w/w)) were used to fry potato chips for five consecutive days at 180â. The formation of oxidation compounds, acylglycerol composition, 3-MCPDE and GE changes throughout the frying study were investigated. Both OB I and OB II exhibited lower oxidation compounds' formation rates than PO. Besides, significant (p < 0.05) reductions of 3-MCPDE and increments of GE levels were observed in all frying systems throughout the frying study. After 25 frying cycles, the 3-MCPDE levels in all frying oils were below 0.13 mg/kg, while the GE levels ranged from 1.51 mg/kg to 1.89 mg/kg. Despite the poorer oxidative stability of DO, its 3-MCPDE and GE levels were much lower compared to PO. In comparison to DO, the 3-MCPDE degradation and GE formation rates were enhanced and reduced, respectively with the blending of PO and DO. This study showed the potential of DO:PO oil blend in deep-fat frying application. With appropriate blending ratio of DO and PO, an alternative frying medium with enhanced nutritional value and oxidative stability could be developed.
Subject(s)
Diglycerides , Soybean Oil , Esters , Palm Oil , Oxidative StressABSTRACT
Diacylglycerol (DAG) is commonly known as one of the precursors for 3-monochloropropane-1,2-diol esters (3-MCPDE) and glycidyl esters (GE) formation. Besides, 3-MCPDE and GE are heat-induced contaminants which can be formed in fat-containing baked products during the baking process. This study attempted to replace the conventional palm-based shortening (SH) with a healthier fat, namely soybean oil-based diacylglycerol stearin (SDAG) in producing biscuits. The effects of different baking temperatures (200, 210 and 220 °C) and SDAG:SH fat blend ratios (0:100, 60:40 (D64S), 80:20 (D82S), 100:0, w/w) towards the biscuits' physical properties were evaluated. Moreover, the oxidative stability, 3-MCPDPE and GE formation in the fats extracted from the biscuits were also investigated. SDAG-produced biscuit showed slight reductions in the spread ratio compared to the SH-produced biscuit. The elevated baking temperatures resulted in biscuits with increased hardness and low moisture content. Pure SDAG and the other fat blends exhibited significant (p < 0.05) poorer oxidative stability than SH. However, D64S was found to be more oxidative stable compared to SDAG and D82S. The D64S fat blend exhibited the lowest 3-MCPDE and GE formation rates among all fat samples with the increasing baking temperatures. Furthermore, the amount of 3-MCPDE and GE detected in the fats extracted from the biscuits baked at highest temperature (220 °C) were still within the safety limit. In overall, better quality biscuits were produced when lower baking temperature (200 °C) was used as all biscuits baked with different fats showed similar textural properties (hardness and cohesiveness), higher oxidative stability and lower formation of 3-MCPDE and GE compared to biscuits baked at higher temperatures. The findings justified the potential of D64S fat blend in replacing the conventional SH in producing healthier biscuits.
