Characterization of the aerosol produced from an aerated jet.

Faucet aerators that form aerated water jets generate aerosols, which can constitute a risk of infection if the water is contaminated, particularly for vulnerable individuals near the sink. In this study, we characterize the size and trajectory of water droplets produced from an aerated jet. The detected particle diameter ranged from 3 to 150µm. The concentration of droplets in the air varied from near-zero to a maximum of 2×1011particles/m3, depending on the location relative to the jet. We found four relevant categories of droplets based on their trajectories following their emission at the jet's free surface: particles with inertia high enough to escape the immediate vicinity of the jet (category 1), particles moving towards the jet (category 2), particles drawn into the aerator, which only included particles with a diameter smaller than 50µm (category 3), and particles with a near-vertical trajectory (category 4). Tracing category 1 particles to their generation location on the water interface shows a higher emission rate near the aerator. Finally, we employ a numerical model to compute the subsequent trajectories of droplets detected at the limits of the sampled domain. We find that particles whose diameter is smaller than 55µm completely dry and become airborne. Larger droplets deposit within a radius of 7cm around the jet, assuming a surface is located 20cm below the aerator tip. These results increase the fundamental understanding of the emission mechanisms of droplets in aerated jets and their fate in the sink environment.

Assessment of percolation through a solid leach bed in dry batch anaerobic digestion processes.

This work aimed at assessing water percolation through a solid cow manure leach bed in dry batch AD processes. A laboratory-scale percolation column and an experimental methodology were set up. Water behaviour was modelled by a double porosity medium approach. An experimental procedure was proposed to determine the main hydrodynamic parameters of the multiphase flow model: the porosity, the permeability and the term for water exchange from macro- to micro-porosity. Micro- and macro-porosity values ranged from 0.42 to 0.70 m(3) m(-3) and 0.18 to 0.50 m(3) m(-3). Intrinsic permeability values for solid cow manure ranged from 5.55·10(-11) to 4.75·10(-9) m(2). The term for water exchange was computed using a 2nd order model. The CFD tool developed was used to simulate successive percolation and drainage operations. These results will be used to design leachate recirculation strategies and predict biogas production in full-scale dry AD batch processes.

Monitoring of bacterial communities during low temperature thermal treatment of activated sludge combining DNA phylochip and respirometry techniques.

Sludge reduction is one of the major challenges in biological wastewater treatment. One approach is to increase the sludge degradation yield together with the biodegradation kinetics. Among the various sludge pretreatment strategies proposed, thermal pretreatment at around 65 °C was described as promising. The enhancement in the biodegradation activity due to the selection of thermophilic hydrolytic bacteria was proposed, but further experiments are needed to demonstrate the specific role of these bacteria. In this study, concentrated activated sludge grown at 20 °C was subjected to thermal treatment at 65 °C for different periods. The originality of the work relied on a polyphasic approach based on the correlation between kinetics (chemical oxygen demand, COD; mixed liquor suspended solids, MLSS), bacterial activity (respirometry) and bacterial community structure (phylochip monitoring) in order to characterize the mechanisms involved in the thermal reduction of sludge. The bacterial activity in the aeration basin decreased to a very low level when recycling sludge was treated at 65 °C from 13 to 60 h, but then, started to increase after 60 h. In parallel to these fluctuations in activity, a drastic shift occurred in the bacterial community structure with the selection of thermophilic bacteria (mainly related to genera Paenibacillus and Bacillus), which are known for their specific hydrolases.

Analysis of the outcome of shredding pretreatment on the anaerobic biodegradability of paper and cardboard materials.

Paper and cardboard stand for the major biodegradable organic fraction of most of municipal solid waste (MSW). This article aims at discussing the possible positive impact of a thin shredding of this fraction on its biodegradability under mesophilic anaerobic conditions, either for landfilling or for digestion in industrial reactors. For that purpose, BMP tests were performed on two types of paper and cardboard mixtures: one sorted from a complex landfill French MSW income, one built from source separated papers and cardboards. For both of these substrates, comparison was made between assays on large pieces of waste and assays on tiny shredded waste (powder particles of less than 1mm diameter). For the second substrate, assays at two different inoculation levels were performed. All results are discussed both in terms of maximal methane conversion yields and in terms of kinetic rates. The main conclusion is that shredding does not improve methane potential of paper and cardboard, neither the biogas production rates. This leads the authors to put forward the hypothesis that shredding does not significantly either increase enzyme accessibility to cellulose nor favor the surface bacterial colonization, although it strongly affects the macrostructure of the waste.

Nanofiltration theory: good co-ion exclusion approximation for single salts.

We applied an approximate analytic method, the good co-ion exclusion (GCE) approximation, to the hindered electrotransport theory describing salt and solution transport across charged nanofiltration membranes. This approximation, which should be valid at sufficiently low feed electrolyte concentration, leads to a considerable simplification of the exact parametrized equations obtained previously for single salt nanofiltration parameters (salt rejection, electric filtration potential, and volume flux density) and therefore provides further insight into ion transfer in nanoporous membranes. We also established the domain of validity of the GCE approximation as a function of the salt type for 1:1, 2:1, 1:2, and 2:2 salts. Our results for the volume flux density, obtained within an extended GCE approximation, confirm that the global osmotic reflection coefficient in the solution flux equation is not equal to the limiting salt rejection.