An integrated microfluidic device for DNA purification and PCR amplification of STR fragments.

This work presents the integration of DNA extraction from complex samples and PCR amplification of STR fragments in a valveless, glass microdevice, using commercially available kits and instrumentation. DNA extraction was performed using a microchannel packed with a silica solid phase and a standard syringe pump as a single pressure source driving the extraction process, followed by integrated, online microchip amplification of STR fragments in a total volume of 1.2 microL. Reported characteristics important to this work include the capacity of the device for purification of DNA from a complex biological sample (whole blood) and the timing of DNA elution from the silica solid phase for successful downstream PCR amplification by placement the microdevice into a conventional thermocycler. Potential application of this microdevice to forensic genetic analysis was demonstrated through the preliminary extraction of DNA from semen, followed by an integrated, multiplexed, on-chip amplification that yielded detectable STR amplicons. By utilizing conventional laboratory equipment, the device presented exploits the benefits of microfluidic systems without complex control systems.

Infrared temperature control system for a completely noncontact polymerase chain reaction in microfluidic chips.

A completely noncontact temperature system is described for amplification of DNA via the polymerase chain reaction (PCR) in glass microfluidic chips. An infrared (IR)-sensitive pyrometer was calibrated against a thermocouple inserted into a 550-nL PCR chamber and used to monitor the temperature of the glass surface above the PCR chamber during heating and cooling induced by a tungsten lamp and convective air source, respectively. A time lag of less than 1 s was observed between maximum heating rates of the solution and surface, indicating that thermal equilibrium was attained rapidly. Moreover, the time lag was corroborated using a one-dimensional heat-transfer model, which provided insight into the characteristics of the device and environment that caused the time lag. This knowledge will, in turn, allow for future tailoring of the devices to specific applications. To alleviate the need for calibrating the pyrometer with a thermocouple, the on-chip calibration of pyrometer was accomplished by sensing the boiling of two solutions, water and an azeotrope, and comparing the pyrometer output voltage against the known boiling points of these solutions. The "boiling point calibration" was successful as indicated by the subsequent chip-based IR-PCR amplification of a 211-bp fragment of the B. anthracis genome in a chamber reduced beyond the dimensions of a thermocouple. To improve the heating rates, a parabolic gold mirror was positioned above the microfluidic chip, which expedited PCR amplification to 18.8 min for a 30-cycle, three-temperature protocol.

A fully integrated microfluidic genetic analysis system with sample-in-answer-out capability.

We describe a microfluidic genetic analysis system that represents a previously undescribed integrated microfluidic device capable of accepting whole blood as a crude biological sample with the endpoint generation of a genetic profile. Upon loading the sample, the glass microfluidic genetic analysis system device carries out on-chip DNA purification and PCR-based amplification, followed by separation and detection in a manner that allows for microliter samples to be screened for infectious pathogens with sample-in-answer-out results in < 30 min. A single syringe pump delivers sample/reagents to the chip for nucleic acid purification from a biological sample. Elastomeric membrane valving isolates each distinct functional region of the device and, together with resistive flow, directs purified DNA and PCR reagents from the extraction domain into a 550-nl chamber for rapid target sequence PCR amplification. Repeated pressure-based injections of nanoliter aliquots of amplicon (along with the DNA sizing standard) allow electrophoretic separation and detection to provide DNA fragment size information. The presence of Bacillus anthracis (anthrax) in 750 nl of whole blood from living asymptomatic infected mice and of Bordetella pertussis in 1 microl of nasal aspirate from a patient suspected of having whooping cough are confirmed by the resultant genetic profile.

Rapid DNA amplification in glass microdevices.

The polymerase chain reaction (PCR) for amplification of DNA has become a very useful tool in scientific research and analytical laboratories, yet conventional techniques are time-consuming, and the reagents are expensive. Miniaturization of this technique has the potential to drastically reduce amplification time and reagent consumption while simultaneously improving the efficiency of the reaction. Increasing the surface area-to-volume ratio using microfluidic reaction chambers allows homogeneous solution temperatures to be achieved much more rapidly than in conventional heating blocks. Employing infrared radiation to selectively heat the reaction solution can additionally reduce the time and energy needed for thermocycling; the reaction container is not heated and can even serve as a heat sink for enhancement of cooling. Microchip systems also provide the potential for fabrication of structures for additional processing steps directly in line with the PCR chamber. Not only can amplification be integrated with product separation and analysis, but sample preparation steps can also be incorporated prior to amplification. The ultimate goal is a miniature total-analysis-system with seamlessly coupled sample-in/answer-out capabilities that consumes very low volumes of reagents and drastically reduces the time for analysis. This chapter will focus on the materials and methods involved in simple straight-channel microchip PCR on glass substrates using non-contact thermocycling.

A simple, valveless microfluidic sample preparation device for extraction and amplification of DNA from nanoliter-volume samples.

A glass microdevice has been constructed for the on-line integration of solid-phase extraction (SPE) of DNA and polymerase chain reaction (PCR) on a single chip. The chromatography required for SPE in the microfluidic sample preparation device (muSPD) was carried out in a silica bead/sol-gel SPE bed, where the purified DNA was eluted directly into a downstream chamber where conventional thermocycling allowed for PCR amplification of specific DNA target sequences. Through rapid, simple passivation of the PCR chamber with a silanizing reagent, reproducible DNA extraction and amplification was demonstrated from complex biological matrixes in a manner amenable to any research laboratory, using only a syringe pump and a conventional thermocycler. The muSPD allowed for SPE concentration of DNA from 600 nL of blood coupled to subsequent on-chip amplification that yielded a detectable amplicon; this simple device can be applied to a variety of routine genetic analyses without the need for sophisticated instrumentation. In addition, the applicability of these developments to nonconventional thermocycling was demonstrated through the use of noncontact, IR-mediated heating. This was exemplified with the isolation of DNA from an anthrax spore-spiked nasal swab and the subsequent on-chip amplification of target DNA sequences in a total processing time of only 25 min.

Extrinsic Fabry-Perot interferometry for noncontact temperature control of nanoliter-volume enzymatic reactions in glass microchips.

Optical fiber extrinsic Fabry-Perot interferometry (EFPI) was investigated as a noncontact temperature sensor and utilized for regulating the temperature of small-volume solutions in microchips. Interference pattern analysis determined the optical path lengths (OPL) associated with reflections from various surfaces on or in the microchip, in particular, from gold sputtered on the bottom of a microchannel. Since OPL is directly proportional to refractive index, which is dependent on solution temperature, the EFPI sensor was capable of noncontact monitoring of solution temperature simply from alterations in the measured path length. Calibration of the sensor against a thermocouple was performed while heating the microchip in a noncontact manner with an IR lamp. The combination of EFPI temperature sensor, IR-mediated heating, and air cooling allowed a fully noncontact system for small-volume temperature control in microchip structures, and its utility was illustrated by optimal digestion of DNA by a temperature-dependent restriction endonuclease in 320 nL. The functionality and simplicity of the microchip EFPI temperature sensor was enhanced by replacing the prebonding sputtered gold with a tunable, chemically plated semireflective silver coating created in situ after chip fabrication. This provided an 8-fold improvement in the lowest detectable temperature change (deltaT = 0.1 degrees C), facilitated primarily by enhanced reflection from both the bottom and top surfaces of the microchannel. This approach for controlling micro- and nanoscale reactions--with heating, cooling, and temperature control being carried out in a completely noncontact fashion--provides an accurate and sensitive method for executing chemical and biochemical reactions in microchips.