Volatile fatty acid and methane production from vinasse and microalgae using two-stage anaerobic co-digestion.

The effects of adding vinasse (VIN) as a co-substrate on the stability and production of volatile fatty acids (VFA) and methane (CH4) during the anaerobic digestion (AD) of microalgal biomass (MB) were evaluated. The AD system consisted of an acidogenic reactor (AR) followed by a methanogenic reactor (MR). The experiment was divided into phase I-start-up and AD of VIN; phase II-MB+VIN co-digestion (50:50 based on chemical oxygen demand (COD)); and phase III-co-digestion of pretreated MB and VIN (PTMB+VIN, 50:50). In phase I, the total amount of VFA in the AR increased from 240 to 2126 mg/L. In the MR, the conversion of VFA into CH4 yielded an average of 71 ± 37 NmL CH4/g CODin. In phase II, the initial CH4 production was 246 ± 31 mL CH4/g CODin but it decreased to 63 mL CH4/g CODin due to the accumulation of longer chain acids. More stable conditions were achieved after two hydraulic retention cycles and the average CH4 yield in this phase was 183 mL CH4/g CODin. In phase III, when using PTMB, 197 ± 72 NmL CH4/g CODin were obtained, i.e., a 2.7- and 1.1-fold increases compared to phases I and II, respectively. The predominance of acetate producers and syntrophic organisms suggests acetoclastic methanogenesis, confirmed by the occurrence of Methanosaeta (10.5%).

Anaerobic co-digestion of microalgal biomass, sugarcane vinasse, and residual glycerol from biodiesel using simplex-centroid mixture design: methane potential, synergic effect, and microbial diversity.

Microalgal biomass (MB) is a promising feedstock for bioenergy production. Nonetheless, the cell recalcitrance and the low C/N ratio limit the methane yield during anaerobic digestion. As an alternative to overcome these challenges, MB co-digestion with different feedstocks has been proposed. Thus, this study evaluated the anaerobic co-digestion (AcoD) of MB cultivated in wastewater with sugarcane vinasse (VIN) and residual glycerol from biodiesel production (GLY). Batch tests were conducted using augmented simplex-centroid mixture design to investigate the impact of AcoD on methane production (SMP), synergistic effects, and the influence on microbial community. When compared to MB digestion, 150 NmL CH4.g-1VS, binary and ternary AcoD achieved SMP increases from 120 to 337%. The combination of 16.7:16.7:66.7 (MB:VIN:GLY) showed the highest SMP for a ternary mixture (631 NmL CH4.g-1VS). Optimal synergies ranged from 1.3 to 1.4 and were primarily found for the MB:GLY AcoD. Acetoclastic Methanosaeta genus was predominant, regardless the combination between substrates. Despite the largest SMP obtained from the MB:GLY AcoD, other ternary mixtures were also highly synergetic and therefore had strong potential as a strategic renewable energy source.

Effect of filtration rates on the performance and head loss development in granular filters during the post-treatment of anaerobic reactor effluent.

This study investigated the performance of a granular filtration system (GFS) composed of a rock filter (RF), a rapid sand filter (RSF), and an activated carbon filter (ACF), applied to the post-treatment of an anaerobic reactor effluent. Four filtration rates (FR) were applied to the GFS (in m3·m-2·d-1): 100-60-60, 100-90-90, 200-120-120, and 200-160-160, for RF-RSF-ACF, respectively. A clarified final effluent with low turbidity (~ 10 NTU), solids (~ 6.5 mg TSS.L-1), and organic matter content (~ 40 mg COD.L-1) was obtained when the GFS worked with FR up to 100-90-90 m3·m-2·d-1. For higher FR, the effluent quality was a little poorer. Principal component analysis showed when the RSF operated at 120 or 160 m3·m-2·d-1, it presented an effluent with higher turbidity which did not affect negatively the ACF performance. The hydraulic load limits in the RSF were reached in periods of 45, 30, and 24.5 h for the FR of 60, 120, and 160 m3·m-2·d-1, respectively, and head loss analysis depicted a more distributed solid retention through the sand depth with the lower FR. Thus, the results revealed that the RF-RSF-ACS system is a promising alternative for effluent polishing of anaerobic reactor, especially when the FR is set at 90 m3·m-2·d-1 or even higher.

Mesophilic anaerobic digestion of waste activated sludge in an intermittent mixing reactor: Effect of hydraulic retention time and organic loading rate.

An anaerobic digester was operated at mesophilic temperature and with intermittent mixing conditions to treat waste activated sludge. The organic loading rate (OLR) was increased by decreasing the hydraulic retention time (HRT), and the effect on process performance, digestate characteristics and inactivation of pathogens was investigated. The removal efficiency of total volatile solids (TVS) was also measured by biogas formation. The HRT varied from 50 to 7 days, corresponding to OLR from 0.38 to 2.31 kgTVS.m-3.d-1. The acidity/alkalinity ratio remained within stable limits (lower than 0.6) at 50-, 25- and 17-day HRT; due to an imbalance between the production and consumption of volatile fatty acids, the ratio increased to 0.7 ± 0.2 at HRT of 9 days and 7 days. The highest TVS removal efficiencies were 16, 12 and 9%, which were obtained at 50-, 25- and 17 day-HRT, respectively. Intermittent mixing provided solids sedimentation greater than 30% for almost all HRT tested. The highest methane yields (0.10-0.05 m3.kgTVSfed-1.d-1) were obtained when the reactor was operated at a higher HRT (50-17 days). At lower HRT, methanogenic reactions were likely limited. Zinc and copper were the main heavy metals found in the digestate, while the most probable number (MPN) of coliform bacteria remained below 106 MPN.g TVS-1. Neither Salmonella nor viable Ascaris eggs were found in the digestate. In general, increasing the OLR by decreasing the HRT to 17 days under intermittent mixing conditions provided an attractive alternative to treat sewage sludge despite some limitations due to biogas and methane yields.

Biopolymers recovery: dynamics and characterization of alginate-like exopolymers in an aerobic granular sludge system treating municipal wastewater without sludge inoculum.

Alginate-like exopolymers (ALE) are present in the extracellular polymeric substances (EPS) of biological sludge such as aerobic granular sludge (AGS). The recovery of ALE from excess sludge produced by wastewater treatment plants (WWTP) is a relevant approach for the recovery of valuable products of industrial interest. However, little is known about dynamics of ALE content in sludge and associated factors. Thus, this study aimed at assessing the dynamics of EPS and ALE in terms of content, some chemical properties and influencing environmental factors along granulation in a sequencing batch reactor treating municipal wastewater. Results indicated that the EPS content was not correlated with the development of AGS, while the ALE content was higher, more stable and steadily increased after granulation achievement. Overall, 236 ± 27 mg VSALE/g VSsludge was recovered from AGS and 187 ± 94 mg VSALE/g VSsludge from flocs. However, the lower ALE content in flocs may be compensated by the higher sludge production rate in activated sludge systems. Principal component analysis (PCA) revealed that ALE content positively correlates with the nutrient and organic substrate conversion, and with the fraction of large AGS. Microbial analyses indicated that a stable microbial community composition was associated with a higher and more stable ALE content. ALE recovered from both flocs and AGS was endowed with hydrogel property, and no clear difference in their elemental composition and functional groups was observed. Therefore, our study provides insights about quantitative and qualitative aspects of ALE which are helpful for the improvement of waste biological sludge valorization.

Granulação natural em reator operado em bateladas sequenciais: características dos grânulos e desempenho no tratamento de esgoto sanitário / Natural granulation in sequencing batch reactor: granules characteristics and performance for domestic wastewater treatment

RESUMO Os reatores operados em bateladas sequenciais (RBS) com biomassa granular aeróbia são uma tecnologia compacta e promissora no tratamento de águas residuárias. Porém, sua utilização com esgoto sanitário ainda é um desafio, devido à instabilidade e desintegração dos agregados. O presente trabalho avaliou a granulação da biomassa em um RBS em escala piloto, sem a adição de inóculo, para o tratamento de esgoto sanitário. O estudo foi dividido em três estratégias operacionais com ciclos compostos pelas fases: enchimento, anóxica, aeróbia, sedimentação, descarte e repouso. Trabalhou-se com variações no tempo dos ciclos, 4 horas (estratégias I e II) e 6 horas (estratégia III), e na fase anóxica, 13, 30 e 90 minutos nas estratégias I, II e III, respectivamente. O desenvolvimento dos grânulos ocorreu de forma natural, sem inoculação, e o reator tratou o esgoto sanitário atendendo às exigências nacionais de padrões de lançamento de efluentes. As características do lodo granular aeróbio e o desempenho do reator no tratamento de esgoto melhoraram com o aumento da fase anóxica. Grânulos (200 a 400 µm) compreenderam mais de 80% da biomassa com boas características de sedimentabilidade (a razão entre os índices volumétricos de lodo após 30 e 10 minutos de sedimentação - IVL30/IVL10 - esteve entre 0,7 e 1,0) na estratégia III. As variáveis de maior relevância no processo foram a razão IVL30/IVL10 e a razão entre a demanda química de oxigênio solúvel do efluente e do anóxico (DQOS efluente/DQOS anóxico), polissacarídeos e temperatura, indicando a importância desses parâmetros para a manutenção da estabilidade operacional de um RBS com grânulos.

ABSTRACT Sequencing batch reactor (SBR) with aerobic granular biomass is a compact and promising technology in wastewater treatment. However, its use for sanitary sewage is still a challenge due to the instability and disintegration of the aggregates. The present work evaluated the biomass granulation in a pilot SBR, without addition of inoculum, for sanitary sewage treatment. The study was divided into three operational strategies with cycles composed by the phases of: filling, anoxic, aerobic, settling, effluent withdrawal and idle. The variations in the operational cycle time were: 4 hours (strategies I and II) and 6 hours (strategy III); and anoxic phase of 13, 30 and 90 minutes in strategies I, II and III, respectively. The granules development occurred in a natural way, without inoculation, and the reactor treated the sanitary wastewater meeting the national requirements of effluent discharge standards. The characteristics of the aerobic granular sludge and the reactor's performance improved with the anoxic phase increase. Granules (200-400 µm) were more than 80% of the biomass with good sedimentation characteristics (SVI30/SVI10 ratio between 0.7-1.0), in strategy III. The greatest relevance variables for the process were SVI30/SVI10 and COD Effluent/CODS Anoxic ratios, polysaccharides and temperature, indicating the importance of these parameters for the maintenance of the operational stability of granular SBR.