ABSTRACT
This manuscript presents a new method of interpreting the ion temperature (Ti) measurement with a retarding field analyzer (RFA) that accounts for the intermittent/turbulent nature of the scrape off layer (SOL) plasmas in tokamaks. Fast measurements and statistical methods are desirable for an adequate description of random fluctuations caused by such intermittent events as edge localized modes (ELMs) and blobs. We use a RFA that can sweep its current-voltage (I-V) characteristics with up to 10 kHz. The RFA uses an electronics compensation stage to subtract the capacitive pickup due to the finite connecting cable capacitance, which greatly improves the signal-to-noise ratio. In the 10 kHz case, a single I-V characteristic is obtained in time, which is an order of magnitude faster than the ELM cycle. The fast sweeping frequency allows us to reconstruct the Ti probability density function (PDF), which we use as the Ti representation. The boundary conditions that we place on the I-V characteristics when calculating the Ti values impact the resulting Ti PDF. If the boundaries are insensitive to the plasma fluctuations, then the most probable Ti value of the PDF (20 eV-25 eV) is similar to the Ti value obtained via the classical conditional averaging method (20 eV-27 eV). However, if the boundary conditions follow the fluctuations, then the PDF-based method gives a substantially higher most probable Ti value (35 eV-60 eV). Overall, we show that a fast sweeping RFA diagnostic should be used in intermittent SOL plasmas to reconstruct the PDF for accurate Ti measurements.
ABSTRACT
A new reciprocating scintillator based fast-ion loss detector has been installed a few centimeters above the outer divertor of the ASDEX Upgrade tokamak and between two of its lower Edge Localized Modes (ELM) mitigation coils. The detector head containing the scintillator screen, Faraday cup, calibration lamp, and collimator systems are installed on a motorized reciprocating system that can adjust its position via remote control in between plasma discharges. Orbit simulations are used to optimize the detector geometry and velocity-space coverage. The scintillator image is transferred to the light acquisition systems outside of the vacuum via a lens relay (embedded in a 3D-printed titanium holder) and an in-vacuum image guide. A charge coupled device camera, for high velocity-space resolution, and an 8 × 8 channel avalanche photo diode camera, for high temporal resolution (up to 2 MHz), are used as light acquisition systems. Initial results showing velocity-space of neutral beam injection prompt losses and fast-ion losses induced by a (2, 1) neoclassical tearing mode are presented.
ABSTRACT
A magnetically driven fast-ion loss detector system for the ASDEX Upgrade tokamak has been designed and will be presented here. The device is feedback controlled to adapt the detector head position to the heat load and physics requirements. Dynamic simulations have been performed taking into account effects such as friction, coil self-induction, and eddy currents. A real time positioning control algorithm to maximize the detector operational window has been developed. This algorithm considers dynamical behavior and mechanical resistance as well as measured and predicted thermal loads. The mechanical design and real time predictive algorithm presented here may be used for other reciprocating systems.
