ABSTRACT
The suitability of a new type of polyurethane-based composite carbon foam for several possible usages is evaluated and reported. A comparison of the properties of the as-prepared carbon foams was performed with widely available commercial biomass-derived activated carbon. Carbon foams were synthesized from polyurethane foams with different graphite contents through one-step activation using CO2. In this work, a carbon catalyst was synthesized with a moderately active surface (SBET = 554 m2/g), a thermal conductivity of 0.09 W/mK, and a minimum metal ion content of 0.2 wt%, which can be recommended for phosgene production. The composite carbon foams exhibited better thermal stability, as there is a very little weight loss at temperatures below 500 °C, and weight loss is slower at temperatures above 500 °C (phosgene synthesis: 550-700 °C). Owing to the good surface and thermal properties and the negligible metallic impurities, composite carbon foam produced from polyurethane foams are the best alternative to the conventional coconut-based activated carbon catalyst used in phosgene gas production.
ABSTRACT
Self-supported and flexible bacterial cellulose (BC) based hybrid membranes were synthesized and decorated with zinc oxide/multi-walled carbon nanotube (ZnO-MWCNT) composite additives in order to modify and tune their surface and bulk properties. Two types of ZnO-MWCNT additives with different morphologies were used in a wide concentration range from 0 to 90% for BC-based hybrids produced by filtration. The interaction between BC and ZnO-MWCNT and the effect of concentration and morphology of additives on the properties like zeta potential, hydrophilicity, electrical conductivity, etc. would be an important factor in various applications. Furthermore, the as-prepared hybrid membranes were characterized with the use of scanning electron microscopy (SEM), focused ion beam scanning electron microscopy (FIB-SEM), energy dispersive X-ray spectroscopy (EDS), X-ray powder diffraction (XRD) and surface area measurement (BET). Applying the presented synthesis routes, the surface properties of BC-based membranes can be tailored easily. Results reveal that the as-prepared BC-ZnO-MWCNT hybrid membranes can be ideal candidates for different kinds of applications, such as water filtration or catalysts.
ABSTRACT
The role of organic solvents in governing the crystallization and morphology of semi-crystalline poly-l-lactide (PLLA) sheets was systematically investigated. Three different organic solvents; ethyl acetate (EA), o-dichlorobenzene (ODCB), and nitrobenzene (NB), with a solubility parameter analogous to PLLA and with a high capability of swelling, were chosen. It has been witnessed that the degree of crystallization and crystal morphology depends highly on the degree of swelling and evaporation rate of the solvent. Besides, the temperature and time of treatment played a significant role in the crystallization of polymers. The effect of different solvents and curing times are reflected by the measured X-ray diffraction (XRD) peaks and the differences are best shown by the unit cell size. The largest variation is observed along the c-axis, indicating shorter bonds, thus, showing better conformation after NB and ODCB treatment. The percentage of crystallinity calculated using the classical relative crystallinity index of XRD shows closer values to those calculated with differential scanning calorimetry (DSC) data, but a huge variation is observed while using the LeBail deconvolution method. The strong birefringence of polarised optical micrograph (POM) and the crystal morphology of scanning electron micrograph (SEM) also evidenced the orientation of polymer crystallites and increased crystallinity after solvent-supported heat treatment.
