Direct measurements of methane emissions from key facilities in Alberta's oil and gas supply chain.

The Canadian government aims to achieve a 40-45 % reduction of oil and gas (O&G) methane (CH4) emissions by 2025, and 75 % by 2030, although recent studies consistently show that Canada's federal inventory underestimates emissions by a factor of 1.4 to 2.0. We conducted aerial mass balance measurements at sixteen upstream O&G facilities in Alberta between September 29 and November 6, 2021, and our measurements revealed that emissions were, on average, 1.7 (standard deviation (SD): 0.6) times higher than the reported emissions for the same year. On a subsequent campaign from August 12 to September 27, 2022, we focused on understudied O&G sectors covering 24 midstream and end-use facilities. These sites were found to be emitting, on average, 3.4 (SD: 1.1) times more CH4 than reported. By extrapolating our measurements to Alberta, we found that underground gas storage contributed to 1.6 % of provincial O&G emissions, followed by natural gas power stations/refineries less than 1.0 %. The widespread underreporting of CH4 emissions highlights the necessity for more empirical measurements of midstream and end-use facilities.

Constraining natural gas pipeline emissions in San Juan Basin using mobile sampling.

Quantifying methane (CH4) leaks of pipeline systems is critical to ensure accurate emission factors in regional and global atmospheric models. The previous emission factors in the United States Environmental Protection Agency (EPA) Greenhouse Gas Inventory (GHGI) are from 1996 and do not reflect the modern gathering pipeline system. Additional data from different basins across the United States are urgently needed to improve the emission factors. The National Energy Technology Laboratory conducted a ground-based vehicle survey at Carson National Forest in the San Juan Basin, New Mexico, in September 2019. 187 km of natural gas gathering pipeline systems were surveyed. The mobile CH4 survey system was efficient in identifying CH4 plumes and pinpointing the leak sources. Gaussian dispersion modeling suggested our survey system had a minimum detection limit of 1.5 LPM. No leaks were found from the pipelines while a leak of 7.1 +/- 0.2 LPM was on a pig launcher door and another leak of 0.7 +/- 0.1 LPM on a block valve. Limited access to the gathering pipeline system prevented us from quantifying all potential leaks detected by the CH4 sensors. The low leak frequency phenomenon was also observed in the sole existing study of natural gas gathering pipelines in the Fayetteville Shale.

Quantifying source contributions of volatile organic compounds under hydraulic fracking moratorium.

Volatile organic compounds (VOCs) are precursors for ozone (O3) and secondary particulate matter, which contribute to asthma and cardiovascular diseases. With the technology development of hydraulic fracking, the United States experienced a shale gas boom in the last decade while the public raised concerns about the potential health impacts of co-emitted VOCs and other airborne pollutants. National Energy Technology Laboratory conducted stationary trailer-based ambient monitoring to study the sources of VOCs in Maryland, where the state enacted a moratorium on unconventional natural gas extraction. The campaign had two periods, May to August 2014 (summer) and November 2014 to February 2015 (winter). Ethane was the most abundant VOC, averaging 12.3 ppb (SD = 15.7 ppb) in summer and 21.7 ppb (SD = 21.6 ppb) in winter. The seasonal variation of VOCs indicated different source strengths. The sampling region was in the nitrogen oxides (NOx) limited regime for O3 production, and the O3 concentrations were sensitive to VOC/NOx ratios in the early mornings. We derived a six-factor profile using positive matrix factorization: motor vehicles, industrial, biogenics, coal burning, fugitive and evaporative, and ozone secondary. The fugitive and evaporative factor explained 44.5% of total VOCs, and the motor vehicles factor followed second with 15.5%. Oil and gas activities had a considerable impact on the abundance of VOCs in this region.

Moving beyond Fine Particle Mass: High-Spatial Resolution Exposure to Source-Resolved Atmospheric Particle Number and Chemical Mixing State.

BACKGROUND: Most epidemiological studies address health effects of atmospheric particulate matter (PM) using mass-based measurements as exposure surrogates. However, this approach ignores many critical physiochemical properties of individual atmospheric particles. These properties control the deposition of particles in the human lung and likely their toxicity; in addition, they likely have larger spatial variability than PM mass. OBJECTIVES: This study was designed to quantify the spatial variability in number, size, source, and chemical mixing state of individual particles in a populous urban area. We quantified the population exposure to these detailed particle properties and compared them to mass-based exposures. METHODS: We performed mobile sampling using an advanced single-particle mass spectrometer to measure the spatial variability of number concentration of source-resolved 50-1,000 nm particles and particle mixing state in Pittsburgh, Pennsylvania. We built land-use regression (LUR) models to estimate their spatial patterns and coupled them with demographic data to estimate population exposure. RESULTS: Particle number concentration had a much larger spatial variability than mass concentration within the city. Freshly emitted particles from traffic and cooking drive the variability in particle number, but mass concentrations are dominated by aged background particles composed of secondary materials. In addition, people exposed to elevated number concentrations of atmospheric particles are also exposed to more externally mixed particles. CONCLUSIONS: Our advanced measurement technique provides a new exposure picture that resolves the large intra-city spatial heterogeneity in traffic and cooking particle number concentrations in the populous urban area. Our results provide a complementary and more detailed perspective compared with bulk measurements of composition. In addition, given the influence of particle mixing state on properties such as particle deposition in the lung, the large spatial gradients of chemical mixing state may significantly influence the health effects of fine PM. https://doi.org/10.1289/EHP5311.

Land-Use Regression Modeling of Source-Resolved Fine Particulate Matter Components from Mobile Sampling.

This study presents land-use regression (LUR) models for submicron particulate matter (PM1) components from an urban area. Models are presented for mass concentrations of inorganic species (SO4, NO3, NH4), organic aerosol (OA) factors, and total PM1. OA is source-apportioned using positive matrix factorization (PMF) of data collected from aerosol mass spectrometry deployed on a mobile laboratory. PMF yielded a three-factor solution: cooking OA (COA), hydrocarbon-like OA (HOA), and less-oxidized oxygenated OA (LO-OOA). This study represents the first time that LUR has been applied to source-resolved OA factors. We sampled a roughly 20 km2 area of West Oakland, California, USA, over 1 month (mid-July to mid-August, 2017). The road network of the sampling domain was comprehensively sampled each day using a randomized driving route to minimize temporal and spatial bias. Mobile measurements were aggregated both spatially and temporally for use as discrete spatial observations for LUR model building. LUR model performance was highest for those species with more spatial variability (primary OA factors: COA R2 = 0.80, HOA R2 = 0.67) and lowest for secondary inorganic species (SO4 R2 = 0.47, NH4 R2 = 0.43) that were more spatially homogeneous. Notably, the stepwise selective LUR algorithm largely selected predictors for primary OA factors that correspond to the associated land-use categories (e.g., cooking land-use variables were selected in cooking-related PM models). This finding appears to be robust, as we demonstrate the predictive link between land-use variables and the corresponding source-resolved PM1 components through a subsampling analysis.

Urban Ultrafine Particle Exposure Assessment with Land-Use Regression: Influence of Sampling Strategy.

Sampling strategies in the collection of ultrafine particle (UFP) data to develop land-use regression (LUR) models can strongly influence the resulting exposure estimates. Here, we systematically examine how much sampling is needed to develop robust and stable UFP LUR models. To address this question, we collected 3-6 weeks of continuous measurements of UFP concentrations at 32 sites in Pittsburgh, Pennsylvania covering a wide range of urban land-use attributes. Through systematic subsampling of this data set, we evaluate the performance of hundreds of LUR models with varying numbers of sampling days and daily sampling durations. Our base LUR model derived from wintertime average concentrations explained about 80% of the spatial variability in the data (adjusted R2 ∼ 0.8). The performance of the LUR models degrades with decreasing number of sampling days and sampling duration per day. For our data set, 1-3 h of sampling per day for 10-15 days provided UFP concentration estimates comparable to models derived from the entire data set. Small numbers of repeated sampling per site (1-3 days) at short duration (∼15-60 min per day) result in poor performance ( R2 < 0.5), similar to previous UFP LUR models. This study provides guidelines for the design of future measurement campaigns and monitoring networks to generate robust UFP LUR models for exposure assessments. Further study in other locations with more sites is needed to evaluate these guidelines over a broader range of conditions.

Quantifying Urban Spatial Variations of Anthropogenic VOC Concentrations and Source Contributions with a Mobile Sampling Platform.

Volatile organic compounds (VOCs) are important atmospheric constituents because they contribute to formation of ozone and secondary aerosols, and because some VOCs are toxic air pollutants. We measured concentrations of a suite of anthropogenic VOCs during summer and winter at 70 locations representing different microenvironments around Pittsburgh, PA. The sampling sites were classified both by land use (e.g., high versus low traffic) and grouped based on geographic similarity and proximity. There was roughly a factor of two variation in both total VOC and single-ring aromatic VOC concentrations across the site groups. Concentrations were roughly 25% higher in winter than summer. Source apportionment with positive matrix factorization reveals that the major VOC sources are gasoline vehicles, solvent evaporation, diesel vehicles, and two factors attributed to industrial emissions. While we expected to observe significant spatial variability in the source impacts across the sampling domain, we instead found that source impacts were relatively homogeneous.

Intracity Variability of Particulate Matter Exposure Is Driven by Carbonaceous Sources and Correlated with Land-Use Variables.

Localized primary emissions of carbonaceous aerosol are the major drivers of intracity variability of submicron particulate matter (PM1) concentrations. We investigated spatial variations in PM1 composition with mobile sampling in Pittsburgh, Pennsylvania, United States and performed source-apportionment analysis to attribute primary organic aerosol (OA) to traffic (HOA) and cooking OA (COA). In high-source-impact locations, the PM1 concentration is, on average, 2 µg m-3 (40%) higher than urban background locations. Traffic emissions are the largest source contributing to population-weighted exposures to primary PM. Vehicle-miles traveled (VMT) can be used to reliably predict the concentration of HOA and localized black carbon (BC) in air pollutant spatial models. Restaurant count is a useful but imperfect predictor for COA concentration, likely due to highly variable emissions from individual restaurants. Near-road cooking emissions can be falsely attributed to traffic sources in the absence of PM source apportionment. In Pittsburgh, 28% and 9% of the total population are exposed to >1 µg m-3 of traffic- and cooking-related primary emissions, with some populations impacted by both sources. The source mix in many U.S. cities is similar; thus, we expect similar PM spatial patterns and increased exposure in high-source areas in other cities.

Restaurant Impacts on Outdoor Air Quality: Elevated Organic Aerosol Mass from Restaurant Cooking with Neighborhood-Scale Plume Extents.

Organic aerosol (OA) is a major component of fine particulate matter (PM2.5) in urban environments. We performed in-motion ambient sampling from a mobile platform with an aerosol mass spectrometer (AMS) to investigate the spatial variability and sources of OA concentrations in Pittsburgh, Pennsylvania, a midsize, largely postindustrial American city. To characterize the relative importance of cooking and traffic sources, we sampled in some of the most populated areas (∼18 km2) in and around Pittsburgh during afternoon rush hour and evening mealtime, including congested highways, major local roads, areas with high densities of restaurants, and urban background locations. We found greatly elevated OA concentrations (10s of µg m-3) in the vicinity of numerous individual restaurants and commercial districts containing multiple restaurants. The AMS mass spectral information indicates that majority of the high concentration plumes (71%) were from cooking sources. Areas containing both busy roads and restaurants had systematically higher OA concentrations than areas with only busy roads and urban background locations. Elevated OA concentrations were measured hundreds of meters downwind of some restaurants, indicating that these sources can influence air quality on neighborhood scales. Approximately 20% of the population (∼250 000 people) in the Pittsburgh area lives within 200 m of a restaurant; therefore, restaurant emissions are potentially an important source of outdoor PM exposures for this large population.

Spatial Variability of Sources and Mixing State of Atmospheric Particles in a Metropolitan Area.

Characterizing intracity variations of atmospheric particulate matter has mostly relied on fixed-site monitoring and quantifying variability in terms of different bulk aerosol species. In this study, we performed ground-based mobile measurements using a single-particle mass spectrometer to study spatial patterns of source-specific particles and the evolution of particle mixing state in 21 areas in the metropolitan area of Pittsburgh, PA. We selected sampling areas based on traffic density and restaurant density with each area ranging from 0.2 to 2 km2. Organics dominate particle composition in all of the areas we sampled while the sources of organics differ. The contribution of particles from traffic and restaurant cooking varies greatly on the neighborhood scale. We also investigate how primary and aged components in particles mix across the urban scale. Lastly we quantify and map the particle mixing state for all areas we sampled and discuss the overall pattern of mixing state evolution and its implications. We find that in the upwind and downwind of the urban areas, particles are more internally mixed while in the city center, particle mixing state shows large spatial heterogeneity that is mostly driven by emissions. This study is to our knowledge, the first study to perform fine spatial scale mapping of particle mixing state using ground-based mobile measurement and single-particle mass spectrometry.

Urban Organic Aerosol Exposure: Spatial Variations in Composition and Source Impacts.

We conducted a mobile sampling campaign in a historically industrialized terrain (Pittsburgh, PA) targeting spatial heterogeneity of organic aerosol. Thirty-six sampling sites were chosen based on stratification of traffic, industrial source density, and elevation. We collected organic carbon (OC) on quartz filters, quantified different OC components with thermal-optical analysis, and grouped them based on volatility in decreasing order (OC1, OC2, OC3, OC4, and pyrolyzed carbon (PC)). We compared our ambient OC concentrations (both gas and particle phase) to similar measurements from vehicle dynamometer tests, cooking emissions, biomass burning emissions, and a highway traffic tunnel. OC2 and OC3 loading on ambient filters showed a strong correlation with primary emissions while OC4 and PC were more spatially homogeneous. While we tested our hypothesis of OC2 and OC3 as markers of fresh source exposure for Pittsburgh, the relationship seemed to hold at a national level. Land use regression (LUR) models were developed for the OC fractions, and models had an average R2 of 0.64 (SD = 0.09). The paper demonstrates that OC2 and OC3 can be useful markers for fresh emissions, OC4 is a secondary OC indicator, and PC represents both biomass burning and secondary aerosol. People with higher OC exposure are likely inhaling more fresh OC2 and OC3, since secondary OC4 and PC varies much less drastically in space or with local primary sources.