VOC amounts in ambient areas of a high-technology science park in Taiwan: their reciprocal correlations and impact on inhabitants.

INTRODUCTION: This study presents bihourly, seasonal, and yearly concentration changes in volatile organic compounds (VOCs) in the inlet and effluent water of the wastewater treatment plant (WWTP) of a high-technology science park (HTIP) in Taiwan, with the VOC amounts at different sites correlated geologically. MATERIALS AND METHODS: This research adopted a combination of two systems, solid-phase microextraction with a gas chromatography/flame ionization detector and an assembly of purge and trap coupled with gas chromatography/mass spectrometry, to monitor polar and nonpolar VOCs in wastewater. This paper investigated the total VOCs, acetone, isopropyl alcohol (IPA), and dimethylsulfide (DMS) concentrations in real water samples collected in the ambient area of the HTIP. RESULTS AND DISCUSSION: The major contents of VOCs measured in the effluent of the WWTP in the HTIP and the surrounding river region were DMS (14-176 ppb), acetone (5-95 ppb), and IPA (15-316 ppb). In comparison with the total VOCs in the inlet wastewater of the WWTP, no corresponding relationship for total VOC concentration in the wastewater was observed between the inlet water and effluent water of the WWTP. CONCLUSIONS: The peak VOC concentrations appeared in the third season, and the correlation of different VOC amounts reflects the production situation of the factories. In addition, VOC concentrations at different sites indicate that the Ke-Ya River is seemingly an effective channel for transporting wastewater to its final destination. The data are good indications for the management of environmental pollution near the HTIP.

Electrochemical immunoassay of cotinine in serum based on nanoparticle probe and immunochromatographic strip.

A disposable sensor for the determination of cotinine in human serum was developed based on immunochromatographic test strip and quantum dot label. In this assay, cotinine linked with quantum dot competes with cotinine in sample to bind to anti-cotinine antibody in the test strip and the quantum dots serve as signal vehicles for electrochemical readout. Some parameters governing the performance of the sensor were optimized. The sensor shows a wide linear range from 1 ng mL(-1) to 100 ng mL(-1) cotinine with a detection limit of 1.0 ng mL(-1). The sensor was validated with spiked human serum samples and it was found that this method was reliable in measuring cotinine in human serum. The results demonstrate that this sensor is rapid, accurate, and less expensive and has the potential for point of care (POC) detection of cotinine and fast screening of tobacco smoke exposure.

Process sampling module coupled with purge and trap-GC-FID for in situ auto-monitoring of volatile organic compounds in wastewater.

An automatic sampling device, i.e., process sampling module (PSM), connected with a purge and trap-GC-FID system has been developed for real-time monitoring of VOCs in wastewater. The system was designed to simultaneously monitor 17 compounds, including one polar compound, i.e., acetone, and 16 non-polar compounds. The trapping tube is packed with two adsorbents, Carbopack B and Carbosieve III, to trap target compounds. For the purpose of in situ monitoring, the flush valve of the sampling tube is composed of two two-way valves and a time controller to prevent absorption interference of the residue. The optimal conditions for the analytical system include a 12 min purge time at a temperature of 60 degrees C, and 4 min of desorption time with a desorption temperature of 260 degrees C. Good chromatograms have been obtained with the analytical system even if a cryogenic device and de-misting were not used. The relative standards deviation (RSD) of the system is between 2% and 13.4%, and accuracies between 0.3 and 23.5% have been achieved. The detection limits of the method range from 0.32 to 2.39 ppb. In this system, the four parts, i.e., PSM, P&T, GC, and FID, were simple, reliable and rugged. Also, the interface of these four parts was simple and dependable.

Impact of inclement weather on the characteristics of volatile organic compounds in ambient air at the Hsinchu Science Park in Taiwan.

This study describes continuous monitoring of the volatile organic air pollutants, acetone and toluene, in Hsinchu Science Park (HSP) during an occurrence of inclement weather, i.e., a typhoon. Using a lab-designed sampling system coupled with a continuous automated GC-MS analysis system, a total of 53 polar and nonpolar compounds were identified and quantified. The concentration of polar compounds dropped sharply from 41.4 ppbv before the typhoon to the stage of no detection during the storm, but rose again after the typhoon. The amount of nonpolar compounds remained unaffected during the storm. The polar compounds were more affected by both the rainfall and wind than were the nonpolar compounds. The severity of air pollution strongly correlates with the concentration of acetone released into the atmosphere by a wastewater treatment facility. The system used in this study has been proved reliable while working in inclement weather condition; in addition, the results can probably be applied in the monitoring of the environment during the typhoon season in high-tech research areas.

Determination and impact of volatile organics emitted during rush hours in the ambient air around gasoline stations.

This study analyzes the volatile organic compounds (VOCs) in the ambient air around gasoline stations during rush hours and assesses their impact on human health. Results from this study clearly indicate that methyl tertiary butyl ether (MTBE), toluene, and isobutane are the major VOCs emitted from gasoline stations. Moreover, the concentrations of MTBE and toluene in the ambient air near gasoline stations are remarkably higher than those sampled on surrounding roads, revealing that these compounds are mainly released from gasoline stations. The concentration of VOCs near the gasoline stations without vapor recovery systems are approximately 7.3 times higher than those around the gasoline stations having the recovery systems. An impact on individual health and air quality because of gasoline station emissions was done using Integrated Risk Information System and Industrial Source Complex Short Term model.

Measurement of non-methane hydrocarbons in Taipei city and their impact on ozone formation in relation to air quality.

Air pollutants data from semi-continuous measurements at multiple sampling sites in Taipei metropolitan area of Taiwan was obtained by collecting air samples in canisters. The hydrocarbon composition was determined by using GC/MS and GC/FID. The air samples were pre-concentrated onto glass beads prior to separation by PLOT and DB-1 columns of GC. The method showed detection limit of <1 ppb and relative standard deviation in the range of 5-30% for different compounds. Aromatic hydrocarbons (toluene, benzene, etc.) and aliphatic hydrocarbons (ethylene, acetylene, propane, etc.) were correlated primarily to determine the source of emission. The estimated hydrocarbons were ranked according to their abundance and photochemical reactivity. The criteria pollutants, ozone and NO2 were measured by UV-differential optical absorption spectroscopy (UV-DOAS), and were utilized to determine the relative importance of non-methane hydrocarbons (NMHC) and significant contribution of NO2 in limiting ozone formation. The obtained results suggest that ozone formation in Taipei city is probably limited by the supply of non-methane hydrocarbons. The concentration profile of targeted pollutants was compared to other metropolitan areas to determine air quality and the pollutant sources.

Sampling and analysis of volatile organics emitted from wastewater treatment plant and drain system of an industrial science park.

Volatile organic compounds (VOCs) were monitored in the different sections of a wastewater treatment plant (WWTP), the outlet of both the WWTP and rainfall water, and the downstream of the WWTP joining the river in the area or vicinity of an industrial science park located in Hsinchu, Taiwan. Levels of VOCs were determined by collecting air samples over several sampling points and analyzed using gas chromatography. Among VOCs identified in the drainage and effluent system in each season, acetone, isopropanol (IPA) and dimethyl sulfide (DMS) were the major emission species and maximum concentrations were 400.4, 22.8 and 641.2 ppbv, respectively. The ambient air and wastewater sample analysis from neighboring wastewater streams identified pollutants being discharged from unaccounted sources other than the industrial park. According to the 24h semi-continuous monitoring data (27/7/2002-29/7/2002), the total VOC concentration was an average of 93 ppbv (acetone contributed approximately 78%) with a dramatic variation during the day and night. The emission rate of measured VOCs estimated using fixed box model projected an average of 2-4 microg m(-2) h(-1)) during the day and 9-17 microg m(-2) h(-1) during the night. In addition, the isopleth maps show that the acetone and DMS emissions influence adversely the nearby residential area located at less than 100 m downwind from the plant. Eventually, based on this study, an on-line monitoring and alerting system could be built for a long-term performance, and with regular information on the varying pollutants over time construction of a green strategy and creation of a sustainable environment can be achieved.

Distribution of volatile organic compounds over a semiconductor Industrial Park in Taiwan.

This study examined volatile organic compounds (VOC) concentration in ambient air collected during the years 2000--2003 at several different locations of Hsinchu Science-based Industrial Park (HSIP) in Taiwan. A canister automated GC-MS system analyzed the volatile organics in ambient air grasp samples according to T0-15 method. Oxygenated volatiles were the most abundant VOC detected in HSIP followed by aromatics that are commonly used as solvents in the semiconductor industries. The major components measured in the ambient air are 2-propanol (29-135 ppbv), acetone (12-164 ppbv), benzene (0.7-1.7 ppbv), and toluene (13-20 ppbv). At some of the sampling locations, odorous compounds such as carbon disulfide and dimethyl sulfide levels exceed threshold values. The estimated toluene/benzene ratio is very high at most of the sites. However, the total amount of VOC is reduced over the years from 2000 to 2003 due to strict implementation on use and discharge of solvents in industries. There exists no definite seasonal pattern for sporadic occurrence of high levels of some of the volatile organics. Stagnant weather conditions with low wind speeds aid accumulation of toxic species at ground level. The results entail that hi-tech semiconductor industries are still a potential source for harmful organic substances to surrounding microenvironment.

Determination of volatile organic compounds in workplace air by multisorbent adsorption/thermal desorption-GC/MS.

Investigation of volatile organic compounds (VOCs) was first conducted in the air of class-100 cleanrooms at liquid crystal display (LCD) fabrication facilities. Air samples were collected on multisorbent tubes (including Carbopack B, Carbopack C, and Carbosieve S-III) and analyzed using adsorption/thermal desorption coupled with gas chromatography-mass spectrometry (GC-MS). Optimal conditions lead to average recoveries in the range of 96.2-98.2%, and method detection limits between 0.38 and 0.78 ppb, under the condition of 1-l sampling volume and 80% relative humidity. The method appears to be accurate, sensitive, simple and well-suited for determining VOC distributions from various stages of LCD manufacturing process and temporal variations of the analyte concentrations. About 15 VOCs were identified in workplace air. The major pollutants such as propylene glycol methyl ether acetate (PGMEA), butyl acetate, and acetone that are commonly used in the opto-electronics industry were detected and accurately quantified with the established method.

Measurement of toxic volatile organic compounds in indoor air of semiconductor foundries using multisorbent adsorption/thermal desorption coupled with gas chromatography-mass spectrometry.

A method for the qualitative and quantitative analysis of volatile organic compounds (VOCs) in the air of class-100 clean rooms at semiconductor fabrication facilities was developed. Air samples from two semiconductor factories were collected each hour on multisorbent tubes (including Carbopack B, Carbopack C, and Carbosieve SIII) with a 24-h automatic active sampling system and analyzed using adsorption/thermal desorption coupled with gas chromatography-mass spectrometry. Experimental parameters, including thermal desorption temperature, desorption time, and cryofocusing temperature, were optimized. The average recoveries and the method detection limits for the target compounds were in the range 94-101% and 0.31-0.89 ppb, respectively, under the conditions of a 1 L sampling volume and 80% relative humidity. VOCs such as acetone, isopropyl alcohol, 2-heptanone, and toluene, which are commonly used in the semiconductor and electronics industries, were detected and accurately quantified with the established method. Temporal variations of the analyte concentrations observed were attributed to the improper use of organic solvents during operation.

Analysis of alkyl organoiodide mixtures by high-performance liquid chromatography using electrochemical detection with a post-column photochemical reactor.

A method for the analysis of six alkyl organoiodides (iodomethane, iodoethane, 1-iodopropane, 1-iodobutane, 1-iodopentane, 1-iodohexane) commonly found in acetic acid process was developed. In this method the target analytes were determined by high-performance liquid chromatography (HPLC) using a post-column photochemical reactor with electrochemical detection (ED) in less than 30 min. HPLC was performed in ODS C18 reversed-phase column (5 microm, 250 x 4.6 mm I.D.) under isocratic conditions with methanol-0.067 M acetate buffer (70:30, v/v), pH 6.2 as mobile phase at flow-rate 1.1 ml/min. Alkyl organoiodides, which are electrochemically inactive, were made oxidizable at potential of 120 mV after post-column irradiation with low-pressure mercury lamp in a knitted PTFE tube. The photoreactor was placedin an aluminum housing full of nitrogen in order to prevent from the interference of oxygen. The detection limit for most analytes was of the order of 1-2 microg/l. The HPLC-ED method with a post-column photochemical reactor has good precision and linearity and can be readily applied to the routine determination of alkyl organoiodides in real acetic acid samples.