Serum golimumab concentration and anti-drug antibodies are associated with treatment response and drug survival in patients with inflammatory joint diseases: data from the NOR-DMARD study.

Objectives: This study aimed to identify the therapeutic target concentration and frequency of anti-drug antibodies (ADAbs) in golimumab-treated patients with inflammatory joint disease (IJD).Method: Associations between golimumab concentration, ADAbs, and treatment response were examined in 91 patients with IJD [41 axial spondyloarthritis (axSpA), 20 rheumatoid arthritis (RA), and 30 psoriatic arthritis (PsA)] included in the NOR-DMARD study. Treatment response was defined by Ankylosing Spondylitis Disease Activity Score (ASDAS) clinically important improvement in axSpA, European League Against Rheumatism (EULAR) good/moderate response in RA, and improvement of ≥ 50% in modified Disease Activity index for PSoriatic Arthritis (DAPSA) (28 swollen/tender joint counts) in PsA. Serum drug concentrations and ADAbs were analysed using automated in-house assays.Results: At inclusion, 42% were biological disease-modifying anti-rheumatic drug naïve and 42% used concomitant synthetic disease-modifying anti-rheumatic drug. The median golimumab concentration was 2.2 (interquartile range 1.0-3.5) mg/L. The proportions of responders after 3 months among patients with golimumab concentration < 1.0, 1.0-3.9, and ≥ 4.0 mg/L were 19%, 49%, and 74%, respectively. A higher rate of treatment discontinuation was seen in patients with serum golimumab concentration < 1.0 compared to ≥ 1.0 mg/L (hazard ratio 3.3, 95% confidence interval 1.8-6.0, p < 0.05). ADAbs were detected in 6%, and were associated with lower drug concentrations and both reduced treatment response and drug survival.Conclusions: Golimumab concentrations ≥ 1.0 mg/L were associated with improved treatment response and better drug survival, although some patients may benefit from higher concentrations. This study suggests a rationale for dosing guided by therapeutic drug monitoring in golimumab-treated patients with IJD. The results should be confirmed in larger studies including trough samples, and the efficacy of such a strategy must be examined in randomized controlled trials.

Self-consistency of electron-THF cross sections using electron swarm techniques.

The drift velocity and first Townsend ionization coefficient of electrons in gaseous tetrahydrofuran are measured over the range of reduced electric fields 4-1000 Td using a pulsed-Townsend technique. The measured drift velocities and Townsend ionization coefficients are subsequently used, in conjunction with a multi-term Boltzmann equation analysis, as a further discriminative assessment on the accuracy and completeness of a recently proposed set of electron-THF vapor cross sections. In addition, the sensitivity of the transport coefficients to uncertainties in the existing cross sections is presented. As a result of that analysis, a refinement of the momentum transfer cross section for electron-THF scattering is presented, along with modifications to the neutral dissociation and dissociative electron attachment cross sections. With these changes to the cross section database, we find relatively good self-consistency between the measured and simulated drift velocities and Townsend coefficients.

Photon-Assisted Shot Noise in Graphene in the Terahertz Range.

When subjected to electromagnetic radiation, the fluctuation of the electronic current across a quantum conductor increases. This additional noise, called photon-assisted shot noise, arises from the generation and subsequent partition of electron-hole pairs in the conductor. The physics of photon-assisted shot noise has been thoroughly investigated at microwave frequencies up to 20 GHz, and its robustness suggests that it could be extended to the terahertz (THz) range. Here, we present measurements of the quantum shot noise generated in a graphene nanoribbon subjected to a THz radiation. Our results show signatures of photon-assisted shot noise, further demonstrating that hallmark time-dependant quantum transport phenomena can be transposed to the THz range.

Growth and structure of ultrathin alumina films on the (1 1 0) surface of γ-Al4Cu9 complex metallic alloy.

The first stages of oxidation of the (1 1 0) surface of a γ-Al(4)Cu(9) complex metallic alloy were investigated by combining x-ray photoemission spectroscopy, low energy electron diffraction and scanning tunnel microscopy studies. Oxidation at room temperature in the 2 × 10(-8) to 2 × 10(-7) mbar oxygen pressure range occurs in two steps: a fast regime is followed by a much slower one, leading to the formation of a thin aluminium oxide film showing no long range order. Cu-O bonds are never observed, due to fast oxygen induced aluminium segregation. The low value of the estimated activation energy for aluminium diffusion (0.65 ± 0.12 eV at(-1)) was ascribed to the presence of two vacancies in the γ-Al(4)Cu(9) structure. Annealing at 925 K the oxide film formed at room temperature leads to the formation of small crystallized domains with a sixton structure similar to structures reported in the literature following the oxidation of Cu-9% Al(1 1 1), NiAl (1 1 0) and FeAl(1 1 0) surfaces as well as ultrathin Al films deposited onto Cu(1 1 1) or Ni(1 1 1) surfaces. Two contributions were observed in the O1s peaks, which have been ascribed to loosely bound oxygen species and oxygen belonging to the sixton structure respectively.

Oxygen adsorption on the Al9Co2(001) surface: first-principles and STM study.

Atomic oxygen adsorption on a pure aluminum terminated Al9Co2(001) surface is studied by first-principle calculations coupled with STM measurements. Relative adsorption energies of oxygen atoms have been calculated on different surface sites along with the associated STM images. The local electronic structure of the most favourable adsorption site is described. The preferential adsorption site is identified as a 'bridge' type site between the cluster entities exposed at the (001) surface termination. The Al-O bonding between the adsorbate and the substrate presents a covalent character, with s-p hybridization occurring between the states of the adsorbed oxygen atom and the aluminum atoms of the surface. The simulated STM image of the preferential adsorption site is in agreement with experimental observations. This work shows that oxygen adsorption generates important atomic relaxations of the topmost surface layer and that sub-surface cobalt atoms strongly influence the values of the adsorption energies. The calculated Al-O distances are in agreement with those reported in Al2O and Al2O3 oxides and for oxygen adsorption on Al(111).

Structural investigation of the (010) surface of the Al13 Fe4 catalyst.

We have investigated the structure of the Al(13)Fe(4)(010) surface using both experimental and ab initio computational methods. The results indicate that the topmost surface layers correspond to incomplete puckered (P) planes present in the bulk crystal structure. The main building block of the corrugated termination consists of two adjacent pentagons of Al atoms, each centered by a protruding Fe atom. These motifs are interconnected via additional Al atoms referred to as "glue" atoms which partially desorb above 873 K. The surface structure of lower atomic density compared to the bulk P plane is explained by a strong Fe-Al-Fe covalent polar interaction that preserves intact clusters at the surface. The proposed surface model with identified Fe-containing atomic ensembles could explain the Al(13)Fe(4) catalytic properties recently reported in line with the site-isolation concept [M. Armbrüster et al., Nat. Mater. 11, 690 (2012)].

Dynamic structure mediated by graphitelike Al nets on the Al2Cu (001) surface.

A detailed study of the (001) surface of the Al(2)Cu crystal using both experimental and ab initio computational methods is presented in this work. The combination of both approaches gives many arguments to match the surface plane with a bulk truncated surface model terminated by incomplete Al planes. The missing rows of Al atoms lead to a 2√2×√2R 45° surface reconstruction with two domains rotated by 90° from each other. Ab initio calculations demonstrate that the energetic cost associated with the removal of pairs of Al atoms is the lowest for the two nearest surface Al atoms (covalentlike interaction). They reveal that the remaining atomic rows of various widths are oriented according to the graphitelike Al 6(3) nets used to describe the Al(2)Cu bulk structure. The surface dynamics observed at 300 K at the Al(2)Cu surface is also presented. Finally, configurational and vibrational entropies are introduced to discuss the reduced surface plane density.